| /linux/Documentation/userspace-api/media/dvb/ |
| H A D | fe-set-voltage.rst | 13 FE_SET_VOLTAGE - Allow setting the DC level sent to the antenna subsystem.
34 This ioctl allows to set the DC voltage level sent through the antenna
37 Usually, a satellite antenna subsystems require that the digital TV
45 .. attention:: if more than one device is connected to the same antenna,
|
| H A D | fe-set-tone.rst | 37 Usually, satellite antenna subsystems require that the digital TV device
42 .. attention:: If more than one device is connected to the same antenna,
|
| H A D | fe-diseqc-send-master-cmd.rst | 36 to the antenna subsystem.
|
| H A D | fe-enable-high-lnb-voltage.rst | 34 to compensate for long antenna cables.
|
| H A D | fe-diseqc-reset-overload.rst | 13 FE_DISEQC_RESET_OVERLOAD - Restores the power to the antenna subsystem, if it was powered off due -…
|
| H A D | frontend.rst | 43 control the antenna subsystem, selecting the polarization and choosing
|
| /linux/Documentation/userspace-api/media/v4l/ |
| H A D | ext-ctrls-rf-tuner.rst | 12 In this context, RF tuner is radio receiver circuit between antenna and
13 demodulator. It receives radio frequency (RF) from the antenna and
60 path, just right after the antenna input. The difference between the
68 signal path. It is located very close to tuner antenna input. Used
|
| H A D | video.rst | 10 be for example: RF connectors (antenna/cable), CVBS a.k.a. Composite
|
| /linux/arch/arm/boot/dts/broadcom/ |
| H A D | bcm2711-rpi-cm4.dtsi | 70 /* internal antenna enabled */
78 /* external antenna disabled */
|
| /linux/Documentation/networking/ |
| H A D | radiotap-headers.rst | 91 0x01 //<-- antenna
107 int pkt_rate_100kHz = 0, antenna = 0, pwr = 0;
136 antenna = *iterator.this_arg);
|
| /linux/Documentation/admin-guide/media/ |
| H A D | si470x.rst | 34 - Si4704: FM radio receiver, no external antenna required
35 - Si4705: FM radio receiver, no external antenna required, RDS support, Dig I/O
36 - Si4706: Enhanced FM RDS/TMC radio receiver, no external antenna required, RDS
|
| /linux/drivers/media/tuners/ |
| H A D | mt20xx.c | 428 static void mt2050_set_antenna(struct dvb_frontend *fe, unsigned char antenna) in mt2050_set_antenna() argument
434 buf[1] = antenna ? 0x11 : 0x10; in mt2050_set_antenna()
436 tuner_dbg("mt2050: enabled antenna connector %d\n", antenna); in mt2050_set_antenna()
|
| /linux/drivers/net/wireless/ralink/rt2x00/ |
| H A D | rt2x00link.c | 252 void rt2x00link_reset_tuner(struct rt2x00_dev *rt2x00dev, bool antenna) in rt2x00link_reset_tuner() argument
284 if (antenna) in rt2x00link_reset_tuner()
|
| H A D | rt2x00reg.h | 29 enum antenna { enum
|
| /linux/arch/arm64/boot/dts/apple/ |
| H A D | t8112-j493.dts | 50 apple,antenna-sku = "XX";
|
| H A D | t8112-j413.dts | 50 apple,antenna-sku = "XX";
|
| H A D | t8103-jxxx.dtsi | 79 apple,antenna-sku = "XX";
|
| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-sx9324 | 11 + connected to an antenna where it can act as a base
|
| /linux/drivers/net/wireless/silabs/wfx/ |
| H A D | data_rx.c | 73 hdr->antenna = 0; in wfx_rx_cb()
|
| /linux/drivers/net/wireless/ath/ath9k/ |
| H A D | Makefile | 9 antenna.o \
|
| H A D | recv.c | 80 static void ath_setdefantenna(struct ath_softc *sc, u32 antenna) in ath_setdefantenna() argument
83 ath9k_hw_setantenna(sc->sc_ah, antenna); in ath_setdefantenna()
84 sc->rx.defant = antenna; in ath_setdefantenna()
937 rx_status->antenna = rx_stats->rs_antenna; in ath9k_rx_skb_preprocess()
|
| /linux/Documentation/devicetree/bindings/media/i2c/ |
| H A D | max2175.txt | 32 in this hardware for AM antenna input.
|
| /linux/drivers/net/wireless/intersil/p54/ |
| H A D | eeprom.h | 114 } __packed, antenna);
|
| H A D | lmac.h | 171 u8 antenna; member
213 u8 antenna; member
|
| /linux/drivers/net/wireless/broadcom/b43legacy/ |
| H A D | phy.h | 174 void b43legacy_set_rx_antenna(struct b43legacy_wldev *dev, int antenna);
|