/linux/drivers/net/phy/ |
H A D | sfp-bus.c | 196 __set_bit(PHY_INTERFACE_MODE_1000BASEX, interfaces); in sfp_parse_support() 201 __set_bit(PHY_INTERFACE_MODE_1000BASEX, interfaces); in sfp_parse_support() 209 __set_bit(PHY_INTERFACE_MODE_1000BASEX, interfaces); in sfp_parse_support() 237 __set_bit(PHY_INTERFACE_MODE_1000BASEX, interfaces); in sfp_parse_support() 314 __set_bit(PHY_INTERFACE_MODE_1000BASEX, interfaces); in sfp_parse_support() 330 __set_bit(PHY_INTERFACE_MODE_1000BASEX, interfaces); in sfp_parse_support() 385 return PHY_INTERFACE_MODE_1000BASEX; in sfp_select_interface()
|
H A D | marvell-88x2222.c | 201 case PHY_INTERFACE_MODE_1000BASEX: in mv2222_config_line() 222 priv->line_interface = PHY_INTERFACE_MODE_1000BASEX; in mv2222_swap_line_type() 232 case PHY_INTERFACE_MODE_1000BASEX: in mv2222_swap_line_type() 497 sfp_interface != PHY_INTERFACE_MODE_1000BASEX && in mv2222_sfp_insert()
|
H A D | phylink.c | 131 PHY_INTERFACE_MODE_1000BASEX, 182 case PHY_INTERFACE_MODE_1000BASEX: /* 1.25Mbd */ in phylink_interface_signal_rate() 219 case PHY_INTERFACE_MODE_1000BASEX: in phylink_interface_max_speed() 538 case PHY_INTERFACE_MODE_1000BASEX: in phylink_get_capabilities() 929 case PHY_INTERFACE_MODE_1000BASEX: in phylink_parse_mode() 1145 case PHY_INTERFACE_MODE_1000BASEX: in phylink_pcs_neg_mode() 3684 case PHY_INTERFACE_MODE_1000BASEX: in phylink_mii_c22_pcs_decode_state() 3757 case PHY_INTERFACE_MODE_1000BASEX: in phylink_mii_c22_pcs_encode_advertisement()
|
/linux/drivers/net/pcs/ |
H A D | pcs-lynx.c | 88 case PHY_INTERFACE_MODE_1000BASEX: in lynx_pcs_get_state() 132 if (interface == PHY_INTERFACE_MODE_1000BASEX) { in lynx_pcs_config_giga() 177 case PHY_INTERFACE_MODE_1000BASEX: in lynx_pcs_config()
|
H A D | pcs-xpcs-wx.c | 180 case PHY_INTERFACE_MODE_1000BASEX: in txgbe_xpcs_switch_mode()
|
H A D | pcs-xpcs.c | 131 PHY_INTERFACE_MODE_1000BASEX, 745 phy_interface_t interface = PHY_INTERFACE_MODE_1000BASEX; in xpcs_config_aneg_c37_1000basex() 1195 if (interface == PHY_INTERFACE_MODE_1000BASEX) in xpcs_link_up()
|
/linux/drivers/phy/freescale/ |
H A D | phy-fsl-lynx-28g.c | 203 case PHY_INTERFACE_MODE_1000BASEX: in lynx_28g_lane_set_nrate() 252 case PHY_INTERFACE_MODE_1000BASEX: in lynx_28g_cleanup_lane() 408 case PHY_INTERFACE_MODE_1000BASEX: in lynx_28g_set_mode() 493 __set_bit(PHY_INTERFACE_MODE_1000BASEX, pll->supported); in lynx_28g_pll_read_configuration()
|
/linux/drivers/net/dsa/b53/ |
H A D | b53_serdes.c | 79 if (interface == PHY_INTERFACE_MODE_1000BASEX) in b53_serdes_config() 182 __set_bit(PHY_INTERFACE_MODE_1000BASEX, in b53_serdes_phylink_get_caps()
|
/linux/drivers/net/ethernet/freescale/dpaa2/ |
H A D | dpaa2-mac.c | 83 case PHY_INTERFACE_MODE_1000BASEX: in dpmac_eth_if_mode() 310 case PHY_INTERFACE_MODE_1000BASEX: in dpaa2_mac_set_supported_interfaces() 312 __set_bit(PHY_INTERFACE_MODE_1000BASEX, in dpaa2_mac_set_supported_interfaces()
|
/linux/drivers/net/ethernet/freescale/fman/ |
H A D | fman_memac.c | 651 case PHY_INTERFACE_MODE_1000BASEX: in memac_if_mode() 669 case PHY_INTERFACE_MODE_1000BASEX: in memac_select_pcs() 687 case PHY_INTERFACE_MODE_1000BASEX: in memac_prepare() 1174 memac_supports(mac_dev, PHY_INTERFACE_MODE_1000BASEX))) { in memac_initialization() 1176 __set_bit(PHY_INTERFACE_MODE_1000BASEX, supported); in memac_initialization()
|
H A D | fman_dtsec.c | 890 case PHY_INTERFACE_MODE_1000BASEX: in dtsec_select_pcs() 916 case PHY_INTERFACE_MODE_1000BASEX: in dtsec_mac_config() 1460 mac_dev->phy_if == PHY_INTERFACE_MODE_1000BASEX) { in dtsec_initialization() 1462 __set_bit(PHY_INTERFACE_MODE_1000BASEX, supported); in dtsec_initialization()
|
/linux/drivers/net/ethernet/microchip/sparx5/ |
H A D | sparx5_port.c | 97 if (port->conf.portmode == PHY_INTERFACE_MODE_1000BASEX) in sparx5_get_dev2g5_status() 173 case PHY_INTERFACE_MODE_1000BASEX: in sparx5_get_port_status() 227 case PHY_INTERFACE_MODE_1000BASEX: in sparx5_port_verify_speed() 675 if (conf->portmode == PHY_INTERFACE_MODE_1000BASEX) /* cl-37 aneg */ in sparx5_get_aneg_word() 738 else if (conf->portmode == PHY_INTERFACE_MODE_1000BASEX && in sparx5_port_pcs_low_set()
|
/linux/drivers/net/ethernet/microchip/lan966x/ |
H A D | lan966x_port.c | 322 if (state->interface == PHY_INTERFACE_MODE_1000BASEX) in lan966x_port_status_get() 346 else if (config->portmode == PHY_INTERFACE_MODE_1000BASEX && in lan966x_port_pcs_set()
|
/linux/drivers/phy/marvell/ |
H A D | phy-armada38x-comphy.c | 129 case PHY_INTERFACE_MODE_1000BASEX: in a38x_comphy_set_mode()
|
H A D | phy-mvebu-a3700-comphy.c | 249 MVEBU_A3700_COMPHY_CONF_ETH(0, PHY_INTERFACE_MODE_1000BASEX), 254 MVEBU_A3700_COMPHY_CONF_ETH(1, PHY_INTERFACE_MODE_1000BASEX), 661 case PHY_INTERFACE_MODE_1000BASEX: in mvebu_a3700_comphy_ethernet_power_on()
|
/linux/drivers/net/dsa/qca/ |
H A D | qca8k-8xxx.c | 1296 case PHY_INTERFACE_MODE_1000BASEX: in qca8k_phylink_mac_select_pcs() 1353 state->interface != PHY_INTERFACE_MODE_1000BASEX) in qca8k_phylink_mac_config() 1389 case PHY_INTERFACE_MODE_1000BASEX: in qca8k_phylink_mac_config() 1426 __set_bit(PHY_INTERFACE_MODE_1000BASEX, in qca8k_phylink_get_caps() 1586 } else if (interface == PHY_INTERFACE_MODE_1000BASEX) { in qca8k_pcs_config()
|
/linux/include/linux/ |
H A D | phylink.h | 662 case PHY_INTERFACE_MODE_1000BASEX: in phylink_get_link_timer_ns()
|
/linux/drivers/net/dsa/mv88e6xxx/ |
H A D | serdes.c | 106 else if (state->interface == PHY_INTERFACE_MODE_1000BASEX) in mv88e6xxx_pcs_decode_state()
|
H A D | port.c | 534 mode = PHY_INTERFACE_MODE_1000BASEX; in mv88e6xxx_port_set_cmode() 546 case PHY_INTERFACE_MODE_1000BASEX: in mv88e6xxx_port_set_cmode()
|
/linux/drivers/net/ethernet/xilinx/ |
H A D | xilinx_axienet_main.c | 2390 if (interface == PHY_INTERFACE_MODE_1000BASEX || in axienet_mac_select_pcs() 2702 lp->phy_mode = PHY_INTERFACE_MODE_1000BASEX; in axienet_probe() 2714 lp->phy_mode != PHY_INTERFACE_MODE_1000BASEX) { in axienet_probe() 2857 lp->phy_mode == PHY_INTERFACE_MODE_1000BASEX) { in axienet_probe() 2890 __set_bit(PHY_INTERFACE_MODE_1000BASEX, in axienet_probe()
|
/linux/drivers/net/ethernet/stmicro/stmmac/ |
H A D | dwmac-intel.c | 589 phy_mode == PHY_INTERFACE_MODE_1000BASEX) in intel_mgbe_common_data() 598 plat->phy_interface == PHY_INTERFACE_MODE_1000BASEX) { in intel_mgbe_common_data()
|
/linux/drivers/phy/microchip/ |
H A D | sparx5_serdes.c | 2201 case PHY_INTERFACE_MODE_1000BASEX: in sparx5_serdes_get_serdesmode() 2270 case PHY_INTERFACE_MODE_1000BASEX: in sparx5_serdes_set_mode() 2346 case PHY_INTERFACE_MODE_1000BASEX: in sparx5_serdes_validate()
|
/linux/drivers/net/ethernet/altera/ |
H A D | altera_tse_main.c | 1088 interface == PHY_INTERFACE_MODE_1000BASEX) in alt_tse_select_pcs() 1433 __set_bit(PHY_INTERFACE_MODE_1000BASEX, in altera_tse_probe()
|
/linux/drivers/net/ethernet/marvell/prestera/ |
H A D | prestera_main.c | 333 case PHY_INTERFACE_MODE_1000BASEX: in prestera_pcs_config() 411 __set_bit(PHY_INTERFACE_MODE_1000BASEX, in prestera_port_sfp_bind()
|
/linux/drivers/net/ethernet/freescale/enetc/ |
H A D | enetc_pf.c | 914 pf->if_mode == PHY_INTERFACE_MODE_1000BASEX || in enetc_port_has_pcs() 1111 __set_bit(PHY_INTERFACE_MODE_1000BASEX, in enetc_phylink_create()
|