Home
last modified time | relevance | path

Searched refs:jack (Results 1 – 25 of 75) sorted by relevance

123

/freebsd/sys/contrib/device-tree/Bindings/sound/
H A Drt5640.txt38 - realtek,jack-detect-source
40 0: jack-detect is not used
41 1: Use GPIO1 for jack-detect
42 2: Use JD1_IN4P for jack-detect
43 3: Use JD2_IN4N for jack-detect
44 4: Use GPIO2 for jack-detect
45 5: Use GPIO3 for jack-detect
46 6: Use GPIO4 for jack-detect
48 - realtek,jack-detect-not-inverted
49 bool. Normal jack-detect switches give an inverted signal, set this bool
[all …]
H A Drt5651.txt19 - realtek,jack-detect-source
21 1: Use JD1_1 pin for jack-detect
22 2: Use JD1_2 pin for jack-detect
23 3: Use JD2 pin for jack-detect
25 - realtek,jack-detect-not-inverted
26 bool. Normal jack-detect switches give an inverted (active-low) signal,
27 set this bool in the rare case you've a jack-detect switch which is not
H A Dda7218.txt56 - dlg,jack-rate-us : Time between jack detect measurements (us)
58 - dlg,jack-debounce : Number of debounce measurements taken for jack detect
60 - dlg,jack-threshold-pct : Threshold level for jack detection (% of VDD)
64 - dlg,discharge : Boolean flag, auto discharge of Mic Bias on jack removal
97 dlg,jack-rate-us = <40>;
98 dlg,jack-debounce = <2>;
99 dlg,jack-threshold-pct = <84>;
H A Dda7219.txt49 - dlg,btn-cfg : Periodic button press measurements for 4-pole jack (ms)
53 - dlg,jack-ins-deb : Debounce time for jack insertion (ms)
55 - dlg,jack-det-rate: Jack type detection latency (3/4 pole)
57 - dlg,jack-rem-deb : Debounce time for jack removal (ms)
100 dlg,jack-ins-deb = <20>;
101 dlg,jack-det-rate = "32ms_64ms";
102 dlg,jack-rem-deb = <1>;
H A Dqcom,msm8916-wcd-analog.txt16 "mbhc_ins_rem_det1" - jack insert removal detect interrupt 1.
19 "mbhc_ins_rem_det" - jack insert removal detect interrupt.
42 - qcom,hphl-jack-type-normally-open: boolean, present if hphl pin on jack is a
44 its assumed that hphl pin on jack is NC
46 - qcom,gnd-jack-type-normally-open: boolean, present if gnd pin on jack is
48 its assumed that gnd pin on jack is NC
H A Dnau8821.txt11 - nuvoton,jkdet-enable: Enable jack detection via JKDET pin.
33 - nuvoton,jack-insert-debounce: number from 0 to 7 that sets debounce time to 2^(n+2) ms
34 - nuvoton,jack-eject-debounce: number from 0 to 7 that sets debounce time to 2^(n+2) ms
52 nuvoton,jack-insert-debounce = <7>;
53 nuvoton,jack-eject-debounce = <7>;
H A Dnokia,rx51.txt10 - jack-detection-gpios: GPIO for jack detection
24 jack-detection-gpios = <&gpio6 17 GPIO_ACTIVE_HIGH>; /* 177 */
H A Dnau8825.txt11 - nuvoton,jkdet-enable: Enable jack detection via JKDET pin.
69 - nuvoton,jack-insert-debounce: number from 0 to 7 that sets debounce time to 2^(n+2) ms
70 - nuvoton,jack-eject-debounce: number from 0 to 7 that sets debounce time to 2^(n+2) ms
105 nuvoton,jack-insert-debounce = <7>;
106 nuvoton,jack-eject-debounce = <7>;
H A Drt5645.txt24 a GPIO spec to control the external combo jack circuit to tie the sleeve/ring2
46 1 : Mode-0 (VDD=3.3V), two port jack detection
47 2 : Mode-1 (VDD=3.3V), one port jack detection
48 3 : Mode-2 (VDD=1.8V), one port jack detection
H A Dimx-audio-es8328.txt7 - jack-gpio : Optional GPIO for headphone jack
47 jack-gpio = <&gpio5 15 0>;
H A Dalc5623.txt14 - jack-det-ctrl: Default register value for Reg-5Ah, Jack Detect
24 jack-det-ctrl = <0x4810>;
H A Domap-abe-twl6040.txt15 - ti,jack-detection: Need to be present if the board capable to detect jack
62 ti,jack-detection;
H A Dimx-audio-spdif.txt17 or jack on the board or it's connecting to some
23 is a physical S/PDIF in connector/jack on the board.
H A Dwm8960.txt21 enabled and disabled together with HP_L and HP_R pins in response to jack
24 - wlf,hp-cfg: A list of headphone jack detect configuration register values.
H A Dnau8824.txt64 - nuvoton,jack-eject-debounce: Jack ejection debounce time.
87 nuvoton,jack-eject-debounce = <1>;
H A Dsirf-audio.txt13 - hp-switch-gpios: Need to be present if the board capable to detect jack
/freebsd/sys/contrib/device-tree/src/arm64/mediatek/
H A Dmt8183-kukui-audio-da7219.dtsi29 dlg,jack-ins-deb = <20>;
30 dlg,jack-det-rate = "32_64";
31 dlg,jack-rem-deb = <1>;
H A Dmt8188-geralt-ciri-sku1.dts27 everest,jack-pol = [0e];
H A Dmt8188-geralt-ciri-sku2.dts27 everest,jack-pol = [0e];
H A Dmt8188-geralt-ciri-sku5.dts29 everest,jack-pol = [0e];
H A Dmt8188-geralt-ciri-sku6.dts29 everest,jack-pol = [0e];
/freebsd/contrib/netbsd-tests/ipf/regress/
H A Dip33 pool ipf/dstlist (name jack; policy weighted connection;)
/freebsd/contrib/netbsd-tests/ipf/expected/
H A Dip33 pool ipf/dstlist (name jack; policy weighting connection;)
/freebsd/sys/contrib/device-tree/src/arm64/qcom/
H A Dqrb2210-rb1.dts126 /* Main barrel jack input */
136 /* 1.2V supply stepped down from the barrel jack input */
147 /* 3.3V supply stepped down from the barrel jack input */
158 /* 5V supply stepped down from the barrel jack input */
169 /* "Battery" voltage for the SoM, stepped down from the barrel jack input */
H A Dqrb4210-rb2.dts175 /* Main barrel jack input */
185 /* 1.2V supply stepped down from the barrel jack input */
196 /* 3.3V supply stepped down from the barrel jack input */
207 /* 5V supply stepped down from the barrel jack input */
218 /* "Battery" voltage for the SoM, stepped down from the barrel jack input */

123