Searched refs:CAM (Results 1 – 25 of 61) sorted by relevance
123
31 comment = "CAM Target Layer / iSCSI target daemon"34 The CAM Target Layer allows the cam(4) storage subsystem to export storage38 the CAM Target Layer configuration, accepting incoming iSCSI connections,
2 CTL - CAM Target Layer Description76 This is visible through the CTL CAM SIM. This allows using CTL without170 - Fixed the phantom device problem in the CTL CAM SIM and improved the171 CAM SIM to automatically trigger a rescan when the port is enabled and237 - Switch CTL over to using CAM CCBs instead of its own union ctl_io. This240 will also require changes to the CAM CCB structure to support CTL.325 CTL-specific wrappers around the CAM sense building functions.337 This is a CTL frontend port that is also a CAM SIM. The idea is that this351 conceptually very similar to CAM's union ccb. 369 CTL wrappers around CAM sense printing functions.[all …]
7 dd.sh CAM stuck in vmwait 2020011622 gjournal4.sh CAM stuck in vmwait 2018051725 gnop3.sh CAM stuck in vmwait 2026021932 gunion.sh CAM stuk in vmwait 2025122650 overcommit2.sh CAM stuck in vmwait seen 20200112
5 camio is a d-traced tcpdump-like program for examining CAM traffic (and13 point of the driver and most of the I/O already had the proper CAM status code,
12 * This driver for FreeBSD-CAM is derived from the Linux sym53c8xx driver.24 * FreeBSD-CAM services is based on the aic7xxx driver for FreeBSD-CAM
15 # Allow for CAM debugging
68 #device ctl # CAM Target Layer
5 This has not been ported CAM yet.
6 PROJECT_NAME = "FreeBSD kernel CAM code"
28 # CAM debugging
12 are pretty much used to stress and test the FreeBSD CAM framework
17 involving CAM and UMASS but is applicable to other areas.19 CAM provides a generic transport for SCSI-like devices. Many different60 causes FreeBSD to only send 10-byte commands. Since the CAM subsystem108 reset the UA either, and so CAM runs in circles trying to retrieve
81 |--- CAM94 |--- CAM112 |--- CAM169 |--- CAM
52 /* Apalis I2C3 (CAM) */
104 /* Apalis I2C3 (CAM) */
47 * I2C3_SDA/SCL (CAM) on MXM3 pin 201/203 (e.g. camera sensor on carrier
85 * I2C3_SDA/SCL (CAM) on MXM3 pin 201/203 (e.g. camera sensor on carrier
58 /* CAM port */
48 - You need CAM(SCSI) support in your kernel.50 2002/4/8, you need to apply CAM-patch in this archive
164 label = "CAM";
5 * DEVKIT ADDON CAM-TS-A01