Searched hist:"23 cd11b6035bd75d09de25120c66892139aaeb59" (Results 1 – 3 of 3) sorted by relevance
| /freebsd/sys/arm/ti/cpsw/ |
| H A D | if_cpswreg.h | diff 23cd11b6035bd75d09de25120c66892139aaeb59 Thu Mar 17 20:35:08 CET 2016 Luiz Otavio O Souza <loos@FreeBSD.org> Add support for dual emac mode.
In dual emac mode, the CPSW subsystem provides two independent ethernets.
This is implemented (as recommended by TI's TRM) with a mixture of switch
settings (vlans) and specific features of CPSW subsystem.
The driver was splitted to accommodate the shared parts (RX and TX rings
for example) while it still provides two independent ethernets.
Each of the ethernet ports driver has it's own set of MDIO registers among
the other private settings.
Previously this driver always operate in promisc mode, now the Switch ALE
(address table entry) is properly initialized and enabled.
The driver is also tested (and known to work) with both ports operating in
single port mode (active_slave 0 or 1).
Tested on uBMC (dual emac mode, both ports in single mode, giga and fast
ethernet) and BBB (single port, fast ethernet).
Sponsored by: Rubicon Communications (Netgate)
|
| H A D | if_cpswvar.h | diff 23cd11b6035bd75d09de25120c66892139aaeb59 Thu Mar 17 20:35:08 CET 2016 Luiz Otavio O Souza <loos@FreeBSD.org> Add support for dual emac mode.
In dual emac mode, the CPSW subsystem provides two independent ethernets.
This is implemented (as recommended by TI's TRM) with a mixture of switch
settings (vlans) and specific features of CPSW subsystem.
The driver was splitted to accommodate the shared parts (RX and TX rings
for example) while it still provides two independent ethernets.
Each of the ethernet ports driver has it's own set of MDIO registers among
the other private settings.
Previously this driver always operate in promisc mode, now the Switch ALE
(address table entry) is properly initialized and enabled.
The driver is also tested (and known to work) with both ports operating in
single port mode (active_slave 0 or 1).
Tested on uBMC (dual emac mode, both ports in single mode, giga and fast
ethernet) and BBB (single port, fast ethernet).
Sponsored by: Rubicon Communications (Netgate)
|
| H A D | if_cpsw.c | diff 23cd11b6035bd75d09de25120c66892139aaeb59 Thu Mar 17 20:35:08 CET 2016 Luiz Otavio O Souza <loos@FreeBSD.org> Add support for dual emac mode.
In dual emac mode, the CPSW subsystem provides two independent ethernets.
This is implemented (as recommended by TI's TRM) with a mixture of switch
settings (vlans) and specific features of CPSW subsystem.
The driver was splitted to accommodate the shared parts (RX and TX rings
for example) while it still provides two independent ethernets.
Each of the ethernet ports driver has it's own set of MDIO registers among
the other private settings.
Previously this driver always operate in promisc mode, now the Switch ALE
(address table entry) is properly initialized and enabled.
The driver is also tested (and known to work) with both ports operating in
single port mode (active_slave 0 or 1).
Tested on uBMC (dual emac mode, both ports in single mode, giga and fast
ethernet) and BBB (single port, fast ethernet).
Sponsored by: Rubicon Communications (Netgate)
|