Home
last modified time | relevance | path

Searched +full:xshutdown +full:- +full:gpios (Results 1 – 14 of 14) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/media/
H A Dsamsung,s5c73m3.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
11 - Sylwester Nawrocki <s.nawrocki@samsung.com>
14 The S5C73M3 camera ISP supports MIPI CSI-2 and parallel (ITU-R BT.656)
31 clock-names:
33 - const: cis_extclk
35 clock-frequency:
39 standby-gpios:
[all …]
H A Dsamsung-s5c73m3.txt2 ------------------------------
4 The S5C73M3 camera ISP supports MIPI CSI-2 and parallel (ITU-R BT.656) video
11 ---------------------
15 - compatible : "samsung,s5c73m3";
16 - reg : I2C slave address of the sensor;
17 - vdd-int-supply : digital power supply (1.2V);
18 - vdda-supply : analog power supply (1.2V);
19 - vdd-reg-supply : regulator input power supply (2.8V);
20 - vddio-host-supply : host I/O power supply (1.8V to 2.8V);
21 - vddio-cis-supply : CIS I/O power supply (1.2V to 1.8V);
[all …]
/freebsd/sys/contrib/device-tree/Bindings/media/i2c/
H A Dad5820.txt5 - compatible: Must contain one of:
6 - "adi,ad5820"
7 - "adi,ad5821"
8 - "adi,ad5823"
10 - reg: I2C slave address
12 - VANA-supply: supply of voltage for VANA pin
16 - enable-gpios : GPIO spec for the XSHUTDOWN pin. The XSHUTDOWN signal is
25 VANA-supply = <&vaux4>;
26 enable-gpios = <&msmgpio 26 GPIO_ACTIVE_HIGH>;
H A Dtoshiba,et8ek8.txt6 Documentation/devicetree/bindings/media/video-interfaces.txt .
10 --------------------
12 - compatible: "toshiba,et8ek8"
13 - reg: I2C address (0x3e, or an alternative address)
14 - vana-supply: Analogue voltage supply (VANA), 2.8 volts
15 - clocks: External clock to the sensor
16 - clock-frequency: Frequency of the external clock to the sensor. Camera
18 a pre-determined frequency known to be suitable to the board.
19 - reset-gpios: XSHUTDOWN GPIO. The XSHUTDOWN signal is active low. The sensor
24 -------------------
[all …]
H A Dov7251.txt1 * Omnivision 1/7.5-Inch B&W VGA CMOS Digital Image Sensor
3 The Omnivision OV7251 is a 1/7.5-Inch CMOS active pixel digital image sensor
8 - compatible: Value should be "ovti,ov7251".
9 - clocks: Reference to the xclk clock.
10 - clock-names: Should be "xclk".
11 - clock-frequency: Frequency of the xclk clock.
12 - enable-gpios: Chip enable GPIO. Polarity is GPIO_ACTIVE_HIGH. This corresponds
13 to the hardware pin XSHUTDOWN which is physically active low.
14 - vdddo-supply: Chip digital IO regulator.
15 - vdda-supply: Chip analog regulator.
[all …]
H A Dovti,og01a1b.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
2 # Copyright (c) 2023-2024 Linaro Ltd.
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Vladimir Zapolskiy <vladimir.zapolskiy@linaro.org>
15 image sensor controlled over an I2C-compatible SCCB bus.
16 The sensor transmits images on a MIPI CSI-2 output interface with one or
20 - $ref: /schemas/media/video-interface-devices.yaml#
32 reset-gpios:
33 description: Active low GPIO connected to XSHUTDOWN pad of the sensor.
[all …]
H A Dovti,ov5670.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jacopo Mondi <jacopo.mondi@ideasonboard.com>
12 description: |-
13 The OV5670 is a 5 Megapixels raw image sensor which provides images in 10-bits
14 RAW BGGR Bayer format on a 2 data lanes MIPI CSI-2 serial interface and is
28 powerdown-gpios:
31 reset-gpios:
32 description: Reference to the GPIO connected to the XSHUTDOWN pin. Active low.
[all …]
H A Dhynix,hi846.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schema
[all...]
H A Dovti,ov2680.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Rui Miguel Silva <rmfrfs@gmail.com>
12 description: |-
14 megapixel) CMOS image sensor that provides a single-chip UXGA (1600 x 1200)
15 camera. It provides full-frame, sub-sampled, or windowed 10-bit images in
30 clock-names:
33 reset-gpios:
36 This corresponds to the hardware pin XSHUTDOWN which is physically
[all …]
H A Dnokia,smia.txt8 Documentation/devicetree/bindings/media/video-interfaces.txt .
12 Documentation/devicetree/bindings/media/video-interfaces.txt .
15 --------------------
17 - compatible: "nokia,smia"
18 - reg: I2C address (0x10, or an alternative address)
19 - vana-supply: Analogue voltage supply (VANA), typically 2,8 volts (sensor
21 - clocks: External clock to the sensor
22 - clock-frequency: Frequency of the external clock to the sensor
23 - link-frequencies: List of allowed data link frequencies. An array of
24 64-bit elements.
[all …]
H A Dovti,ov8856.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Sakari Ailus <sakari.ailus@linux.intel.com>
13 description: |-
14 The Omnivision OV8856 is a high performance, 1/4-inch, 8 megapixel, CMOS
15 image sensor that delivers 3264x2448 at 30fps. It provides full-frame,
16 sub-sampled, and windowed 10-bit MIPI images in various formats via the
18 through I2C and two-wire SCCB. The sensor output is available via CSI-2
19 serial data output (up to 4-lane).
[all …]
H A Dov8856.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Sakar
[all...]
H A Dmipi-ccs.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
2 # Copyright (C) 2014--2020 Intel Corporation
4 ---
5 $id: http://devicetree.org/schemas/media/i2c/mipi-ccs.yaml#
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Sakari Ailus <sakari.ailus@linux.intel.com>
17 <URL:https://www.mipi.org/specifications/camera-command-set>.
24 Documentation/devicetree/bindings/media/video-interfaces.txt .
29 - items:
30 - const: mipi-ccs-1.1
[all …]
/freebsd/sys/contrib/device-tree/src/arm/samsung/
H A Dexynos4412-midas.dtsi1 // SPDX-License-Identifier: GPL-2.0
12 /dts-v1/;
14 #include "exynos4412-ppmu-common.dtsi"
16 #include <dt-bindings/gpio/gpio.h>
17 #include <dt-bindings/input/input.h>
18 #include <dt-bindings/interrupt-controlle
[all...]