Searched +full:xmem +full:- +full:address +full:- +full:hold +full:- +full:enable (Results 1 – 2 of 2) sorted by relevance
| /linux/drivers/bus/ |
| H A D | qcom-ebi2.c | 1 // SPDX-License-Identifier: GPL-2.0-only
41 * Bits 31-28: RECOVERY recovery cycles (0 = 1, 1 = 2 etc) this is the time the
42 * memory continues to drive the data bus after OE is de-asserted.
45 * Bits 27-24: WR_HOLD write hold cycles, these are extra cycles inserted after
47 * asserted until CS is asserted. With a hold of 1, the CS stays
49 * Bits 23-16: WR_DELTA initial latency for write cycles inserted for the first
51 * Bits 15-8: RD_DELTA initial latency for read cycles inserted for the first
53 * Bits 7-4: WR_WAIT number of wait cycles for every write access, 0=1 cycle
55 * Bits 3-0: RD_WAIT number of wait cycles for every read access, 0=1 cycle
74 * Bits 31-28: ?
[all …]
|
| /linux/arch/arm/boot/dts/qcom/ |
| H A D | qcom-apq8060-dragonboard.dts | 1 // SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
2 #include <dt-bindings/input/input.h>
3 #include <dt-bindings/gpio/gpio.h>
4 #include <dt-bindings/leds/common.h>
5 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
6 #include <dt-bindings/pinctrl/qcom,pmic-mpp.h>
7 #include "qcom-msm8660.dtsi"
12 compatible = "qcom,apq8060-dragonboard", "qcom,msm8660";
19 stdout-path = "serial0:115200n8";
23 vph: regulator-fixed {
[all …]
|