Searched +full:vs +full:- +full:soft +full:- +full:start +full:- +full:strength (Results 1 – 3 of 3) sorted by relevance
| /linux/arch/arm/boot/dts/qcom/ |
| H A D | pm8941.dtsi | 1 // SPDX-License-Identifier: GPL-2.0
2 #include <dt-bindings/iio/qcom,spmi-vadc.h>
3 #include <dt-bindings/interrupt-controller/irq.h>
4 #include <dt-bindings/spmi/spmi.h>
8 thermal-zones {
9 pm8941-thermal {
10 polling-delay-passive = <100>;
11 polling-delay = <0>;
12 thermal-sensors = <&pm8941_temp>;
40 compatible = "qcom,pm8941", "qcom,spmi-pmic";
[all …]
|
| /linux/Documentation/devicetree/bindings/regulator/ |
| H A D | qcom,spmi-regulator.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/regulator/qcom,spmi-regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Robert Marko <robimarko@gmail.com>
15 - qcom,pm6125-regulators
16 - qcom,pm660-regulators
17 - qcom,pm660l-regulators
18 - qcom,pm8004-regulators
19 - qcom,pm8005-regulators
[all …]
|
| /linux/drivers/regulator/ |
| H A D | qcom_spmi-regulator.c | 1 // SPDX-License-Identifier: GPL-2.0-only
3 * Copyright (c) 2012-2015, The Linux Foundation. All rights reserved.
8 #include <linux/devm-helpers.h>
47 /* Soft start strength of a voltage switch type regulator */
57 * struct spmi_regulator_init_data - spmi-regulator initialization data
75 * @vs_soft_start_strength: This parameter sets the soft start strength for
79 * then the soft start strength will be left at its
300 /* LDO regulator soft start control register layout */
303 /* VS regulator over current protection control register layout */
307 /* VS regulator soft start control register layout */
[all …]
|