| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-platform-msi-laptop | 38 Contains either 0 or 1 and indicates if touchpad is turned on. 46 Contains either 0 or 1 and indicates if turbo mode is turned 59 Contains either 0 or 1 and indicates if ECO mode is turned on. 71 * 1 -> Turbo mode is on, cannot be turned off yet 72 * 2 -> Turbo mode is off, cannot be turned on yet
|
| H A D | sysfs-platform-dell-privacy-wmi | 59 Identifies the privacy device is turned off 63 Identifies the privacy device is turned on,
|
| H A D | sysfs-block-device | 60 turned off. If the device does not support the SATA NCQ 116 By default this feature is turned off.
|
| H A D | sysfs-driver-altera-cvp | 7 error checking in altera-cvp driver is turned on or
|
| H A D | sysfs-bus-iio-adc-ad7280a | 12 Time in seconds for which balance switch will be turned on.
|
| H A D | sysfs-devices-resource_in_use | 10 resource is not in use and therefore it has been turned off).
|
| H A D | sysfs-devices-power_resources_D0 | 10 representing ACPI power resources that need to be turned on for
|
| /linux/tools/testing/selftests/damon/ |
| H A D | reclaim.sh | 30 echo "kdamond is not turned on" 38 echo "kdamond is not turned off"
|
| H A D | lru_sort.sh | 29 echo "kdamond is not turned on" 37 echo "kdamond is not turned off"
|
| /linux/sound/ppc/ |
| H A D | Kconfig | 31 If this feature is enabled, DRC is turned off when the 32 headphone/line jack is plugged, and turned on when unplugged.
|
| /linux/Documentation/networking/ |
| H A D | switchdev.rst | 461 - with VLAN filtering turned off: the bridge is strictly VLAN unaware and its 464 have no effect while VLAN filtering is turned off. Frames ingressing the 468 - with VLAN filtering turned on: the bridge is VLAN-aware and frames ingressing 477 - with VLAN filtering turned off, the bridge will process all ingress traffic 494 - with VLAN filtering turned on, these VLAN devices can be created as long as 505 Because VLAN filtering can be turned on/off at runtime, the switchdev driver 513 Even when VLAN filtering in the bridge is turned off, the underlying switch 541 - when IGMP snooping is turned off, multicast traffic must be flooded to all 549 - when IGMP snooping is turned on, multicast traffic must selectively flow 557 Because IGMP snooping can be turned on/off at runtime, the switchdev driver
|
| /linux/include/linux/platform_data/ |
| H A D | i2c-gpio.h | 19 * @sda_is_output_only: SDA output drivers can't be turned off. 25 * @scl_is_output_only: SCL output drivers cannot be turned off.
|
| /linux/Documentation/devicetree/bindings/regulator/ |
| H A D | maxim,max77686.yaml | 31 Regulators which can be turned off during system suspend: 61 Regulators which can be turned off during system suspend:
|
| /linux/tools/perf/pmu-events/arch/powerpc/power10/ |
| H A D | others.json | 25 …ruction cache reloads includes demand, prefetch, prefetch turned into demand and demand turned int…
|
| H A D | cache.json | 15 …"BriefDescription": "Counts all instruction cache prefetch reloads (includes demand turned into pr…
|
| /linux/drivers/misc/lis3lv02d/ |
| H A D | lis3lv02d_i2c.c | 201 /* Turn on for wakeup if turned off by runtime suspend */ in lis3lv02d_i2c_suspend() 205 /* For non wakeup turn off if not already turned off by runtime suspend */ in lis3lv02d_i2c_suspend() 217 /* Turn back off if turned on for wakeup and runtime suspended*/ in lis3lv02d_i2c_resume()
|
| /linux/drivers/phy/st/ |
| H A D | phy-stm32-combophy.c | 380 * Clocks should be turned off since it is not needed for in stm32_combophy_suspend_noirq() 382 * combo-phy is already turned off by HCD driver using exit callback in stm32_combophy_suspend_noirq() 400 * If clocks was turned off by suspend call for wakeup then needs in stm32_combophy_resume_noirq() 401 * to be turned back ON in resume. In case usb-remote wakeup is not in stm32_combophy_resume_noirq() 402 * enabled, clocks already turned ON by HCD driver using init callback in stm32_combophy_resume_noirq()
|
| /linux/include/drm/ |
| H A D | drm_audio_component.h | 24 * Request the power well to be turned on. 33 * Allow the power well to be turned off.
|
| /linux/drivers/pmdomain/renesas/ |
| H A D | rmobile-sysc.c | 225 * only be turned off if the CPU is not in use. in rmobile_setup_pm_domain() 240 * therefore it should only be turned off if the debug module in rmobile_setup_pm_domain() 250 * should only be turned off if memory is not in use. in rmobile_setup_pm_domain()
|
| H A D | rcar-gen4-sysc.c | 228 * only be turned off if the CPU is not in use. in rcar_gen4_sysc_pd_setup() 235 * therefore it should only be turned off if the CPU cores are in rcar_gen4_sysc_pd_setup() 242 * This domain cannot be turned off. in rcar_gen4_sysc_pd_setup()
|
| /linux/Documentation/infiniband/ |
| H A D | ipoib.rst | 64 Large Receive (LRO) offloading is also implemented and may be turned 84 turned on by setting the module parameters debug_level and
|
| /linux/drivers/phy/intel/ |
| H A D | phy-intel-keembay-emmc.c | 148 * We turned on the DLL even though the rate was 0 because we the in keembay_emmc_phy_power() 149 * clock might be turned on later. ...but we can't wait for the DLL in keembay_emmc_phy_power() 154 * is turned on, but for now we won't. in keembay_emmc_phy_power()
|
| /linux/arch/arm64/boot/dts/qcom/ |
| H A D | sm6115p-lenovo-j606f.dts | 181 /* Broken hw, this one can't be turned off or SDHCI will break! */ 195 * TODO: SDHCI seems to also work with this one turned off, however 280 /* Broken hw, this one can't be turned off or SDHCI will break! */
|
| /linux/Documentation/sound/cards/ |
| H A D | cmipci.rst | 32 As default it's turned on. 146 (441100 or 48000) and channels (2) are used. Otherwise it's turned 199 turned off so that non-audio data is heard from the analog line-out.
|
| /linux/drivers/pmdomain/thead/ |
| H A D | Kconfig | 13 turned on/off.
|