Home
last modified time | relevance | path

Searched +full:touchscreen +full:- +full:x +full:- +full:plate +full:- +full:ohms (Results 1 – 17 of 17) sorted by relevance

/linux/Documentation/devicetree/bindings/input/touchscreen/
H A Dbu21029.txt4 - compatible : must be "rohm,bu21029"
5 - reg : i2c device address of the chip (0x40 or 0x41)
6 - interrupt-parent : the phandle for the gpio controller
7 - interrupts : (gpio) interrupt to which the chip is connected
8 - rohm,x-plate-ohms : x-plate resistance in Ohm
11 - reset-gpios : gpio pin to reset the chip (active low)
12 - touchscreen-size-x : horizontal resolution of touchscreen (in pixels)
13 - touchscreen-size-y : vertical resolution of touchscreen (in pixels)
14 - touchscreen-max-pressure: maximum pressure value
15 - vdd-supply : power supply for the controller
[all …]
H A Dti,tsc2005.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/input/touchscreen/ti,tsc2005.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Texas Instruments TSC2004 and TSC2005 touchscreen controller
10 - Marek Vasut <marex@denx.de>
11 - Michael Welling <mwelling@ieee.org>
15 pattern: "^touchscreen(@.*)?$"
19 - ti,tsc2004
20 - ti,tsc2005
[all …]
/linux/arch/arm/boot/dts/nxp/imx/
H A Dimx53-sk-imx53-atm0700d4.dtsi1 // SPDX-License-Identifier: GPL-2.0+
5 /dts-v1/;
7 #include <dt-bindings/pwm/pwm.h>
8 #include "imx53-sk-imx53.dts"
11 panel: panel-rgb {
12 compatible = "powertip,ph800480t013-idf02";
21 compatible = "spi-gpio";
22 #address-cells = <0x1>;
23 #size-cells = <0x0>;
25 num-chipselects = <1>;
[all …]
H A Dimx6qdl-skov-cpu-revc.dtsi1 // SPDX-License-Identifier: (GPL-2.0 OR MIT)
6 touchscreen {
7 compatible = "resistive-adc-touch";
8 io-channels = <&adc_ts 1>, <&adc_ts 3>, <&adc_ts 4>, <&adc_ts 5>;
9 io-channel-names = "y", "z1", "z2", "x";
10 touchscreen-min-pressure = <65000>;
11 touchscreen-inverted-y;
12 touchscreen-swapped-x-y;
13 touchscreen-x-plate-ohms = <300>;
14 touchscreen-y-plate-ohms = <800>;
[all …]
H A Dimx6dl-victgo.dts1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
7 /dts-v1/;
9 #include "imx6qdl-vicut1.dtsi"
15 gpio-keys {
16 compatible = "gpio-keys";
17 pinctrl-names = "default";
18 pinctrl-0 = <&pinctrl_gpiokeys>;
21 key-power {
25 wakeup-source;
28 key-enter {
[all …]
H A Dimx6dl-plym2m.dts1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
7 /dts-v1/;
8 #include <dt-bindings/gpio/gpio.h>
9 #include <dt-bindings/leds/common.h>
17 stdout-path = &uart4;
21 compatible = "pwm-backlight";
23 brightness-levels = <0 1000>;
24 num-interpolated-steps = <20>;
25 default-brightness-level = <19>;
26 power-supply = <&reg_12v0>;
[all …]
H A Dimx53-tx53-x03x.dts1 // SPDX-License-Identifier: (GPL-2.0-only OR MIT)
3 * Copyright 2013-2017 Lothar Waßmann <LW@KARO-electronics.de>
6 /dts-v1/;
7 #include "imx53-tx53.dtsi"
8 #include <dt-bindings/input/input.h>
9 #include <dt-bindings/interrupt-controller/irq.h>
10 #include <dt-bindings/pwm/pwm.h>
13 model = "Ka-Ro electronics TX53 module (LCD)";
21 compatible = "fsl,imx-parallel-display";
22 interface-pix-fmt = "rgb24";
[all …]
/linux/drivers/input/touchscreen/
H A Dresistive-adc-touch.c1 // SPDX-License-Identifier: GPL-2.0
3 * ADC generic resistive touchscreen (GRTS)
13 #include <linux/input/touchscreen.h>
21 #define DRIVER_NAME "resistive-adc-touch"
37 * struct grts_state - generic resistive touch screen information struct
38 * @x_plate_ohms: resistance of the X plate
44 * @prop: touchscreen properties struct
45 * @ch_map: map of channels that are defined for the touchscreen
62 unsigned int x, y, press = 0; in grts_cb() local
64 x = touch_info[st->ch_map[GRTS_CH_X]]; in grts_cb()
[all …]
H A Dbu21029_ts.c1 // SPDX-License-Identifier: GPL-2.0
3 * Rohm BU21029 touchscreen controller driver
5 * Copyright (C) 2015-2018 Bosch Sicherheitssysteme GmbH
16 #include <linux/input/touchscreen.h>
25 * +--------+--------+--------+--------+--------+--------+--------+--------+
27 * +--------+--------+--------+--------+--------+--------+--------+--------+
29 * +--------+--------+--------+--------+--------+--------+--------+--------+
31 * +--------+--------+--------+--------+--------+--------+--------+--------+
33 * +--------+--------+--------+--------+--------+--------+--------+--------+
35 * +--------+--------+--------+--------+--------+--------+--------+--------+
[all …]
H A Dads7846.c1 // SPDX-License-Identifier: GPL-2.0-only
3 * ADS7846 based touchscreen and sensor driver
10 * - corgi_ts.c
11 * Copyright (C) 2004-2005 Richard Purdie
12 * - omap_ts.[hc], ads7846.h, ts_osk.c
23 #include <linux/input/touchscreen.h>
39 * Support for ads7843 tested on Atmel at91sam926x-EK.
53 * note. The strength of filtering can be set in the board-* specific
76 * driver is used with DMA-based SPI controllers (like atmel_spi) on
77 * systems where main memory is not DMA-coherent (most non-x86 boards).
[all …]
/linux/arch/arm64/boot/dts/freescale/
H A Dimx8mm-var-som.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
10 model = "Variscite VAR-SOM-MX8MM module";
13 stdout-path = &uart4;
21 reg_eth_phy: regulator-eth-phy {
22 compatible = "regulator-fixed";
23 pinctrl-names = "default";
24 pinctrl-0 = <&pinctrl_reg_eth_phy>;
25 regulator-name = "eth_phy_pwr";
26 regulator-min-microvolt = <3300000>;
27 regulator-max-microvolt = <3300000>;
[all …]
H A Dimx8mn-var-som.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
4 * Copyright 2019-2020 Variscite Ltd.
11 model = "Variscite VAR-SOM-MX8MN module";
12 compatible = "variscite,var-som-mx8mn", "fsl,imx8mn";
15 stdout-path = &uart4;
23 reg_eth_phy: regulator-eth-phy {
24 compatible = "regulator-fixed";
25 pinctrl-names = "default";
26 pinctrl-0 = <&pinctrl_reg_eth_phy>;
27 regulator-name = "eth_phy_pwr";
[all …]
/linux/arch/arm/boot/dts/ti/omap/
H A Dlogicpd-torpedo-baseboard.dtsi1 // SPDX-License-Identifier: GPL-2.0-only
5 compatible = "gpio-keys";
6 pinctrl-names = "default";
7 pinctrl-0 = <&gpio_key_pins &gpio_key_pins_wkup>;
13 wakeup-source;
20 wakeup-source;
27 wakeup-source;
34 wakeup-source;
39 compatible = "ti,omap-twl4030";
45 compatible = "gpio-leds";
[all …]
H A Domap3-n900.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
4 * Copyright (C) 2013-2014 Aaro Koskinen <aaro.koskinen@iki.fi>
7 /dts-v1/;
10 #include <dt-bindings/input/input.h>
11 #include <dt-bindings/leds/common.h>
12 #include <dt-bindings/media/video-interfaces.h>
15 * Default secure signed bootloader (Nokia X-Loader) does not enable L3 firewall
17 * blocks then kernel receive "Unhandled fault: external abort on non-linefetch"
18 * and crash. Until somebody fix omap-aes.c and omap_hwmod_3xxx_data.c code (no
34 compatible = "nokia,omap3-n900", "ti,omap3430", "ti,omap3";
[all …]
/linux/arch/arm/boot/dts/nxp/mxs/
H A Dimx28-tx28.dts1 // SPDX-License-Identifier: GPL-2.0 OR MIT
4 * Copyright 2013-2017 Lothar Waßmann <LW@KARO-electronics.de>
7 /dts-v1/;
9 #include <dt-bindings/gpio/gpio.h>
10 #include <dt-bindings/interrupt-controller/irq.h>
13 model = "Ka-Ro electronics TX28 module";
34 reg = <0x40000000 0>; /* will be filled in by U-Boot */
38 compatible = "w1-gpio";
43 reg_usb0_vbus: regulator-usb0-vbus {
44 compatible = "regulator-fixed";
[all …]
/linux/arch/arm64/boot/dts/rockchip/
H A Drk3566-bigtreetech-cb2.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
3 /dts-v1/;
5 #include <dt-bindings/gpio/gpio.h>
6 #include <dt-bindings/pwm/pwm.h>
7 #include <dt-bindings/pinctrl/rockchip.h>
8 #include <dt-bindings/soc/rockchip,vop2.h>
9 #include <dt-bindings/leds/common.h>
20 stdout-path = "serial2:1500000n8";
23 ext_cam_clk: clock-25000000-cam {
24 compatible = "fixed-clock";
[all …]
/linux/arch/arm/mach-pxa/
H A Dspitz.c1 // SPDX-License-Identifier: GPL-2.0-only
3 * Support for Sharp SL-Cxx00 Series of PDAs
4 * Models: SL-C3000 (Spitz), SL-C1000 (Akita) and SL-C3100 (Borzoi)
20 #include <linux/platform_data/i2c-pxa.h>
28 #include <linux/input-event-codes.h>
37 #include <asm/mach-types.h>
43 #include "pxa27x-udc.h"
45 #include <linux/platform_data/mmc-pxamci.h>
46 #include <linux/platform_data/usb-ohci-pxa27x.h>
47 #include <linux/platform_data/video-pxafb.h>
[all …]