Home
last modified time | relevance | path

Searched +full:tc +full:- +full:resistor (Results 1 – 7 of 7) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/rtc/
H A Dabracon,abx80x.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - linux-rtc@vger.kernel.org
17 must perform auto-detection from ID register.
19 - abracon,abx80x
20 - abracon,ab0801
21 - abracon,ab0803
22 - abracon,ab0804
23 - abracon,ab0805
[all …]
H A Dabracon,abx80x.txt9 - "compatible": should one of:
21 - "reg": I2C bus address of the device
29 - "abracon,tc-diode": should be "standard" (0.6V) or "schottky" (0.3V)
30 - "abracon,tc-resistor": should be <0>, <3>, <6> or <11>. 0 disables the output
31 resistor, the other values are in kOhm.
/freebsd/sys/contrib/device-tree/src/arm64/freescale/
H A Dimx8mq-hummingboard-pulse.dts1 // SPDX-License-Identifier: (GPL-2.0 OR MIT)
3 * Copyright (C) 2018 Jon Nettleton <jon@solid-run.com>
6 /dts-v1/;
8 #include "dt-bindings/usb/pd.h"
9 #include "imx8mq-sr-som.dtsi"
13 compatible = "solidrun,hummingboard-pulse", "fsl,imx8mq";
16 stdout-path = &uart1;
19 reg_usdhc2_vmmc: regulator-usdhc2-vmmc {
20 compatible = "regulator-fixed";
21 pinctrl-names = "default";
[all …]
/freebsd/sys/contrib/device-tree/src/arm64/ti/
H A Dk3-am642-hummingboard-t.dts1 // SPDX-License-Identifier: GPL-2.0+
3 * Copyright (C) 2023 Josua Mayer <josua@solid-run.com>
5 * DTS for SolidRun AM642 HummingBoard-T,
10 /dts-v1/;
12 #include <dt-bindings/leds/common.h>
13 #include <dt-bindings/phy/phy.h>
15 #include "k3-am642.dtsi"
16 #include "k3-am642-sr-som.dtsi"
19 model = "SolidRun AM642 HummingBoard-T";
20 compatible = "solidrun,am642-hummingboard-t", "solidrun,am642-sr-som", "ti,am642";
[all …]
/freebsd/sys/dev/qlnx/qlnxe/
H A Dreg_addr.h2 * Copyright (c) 2017-2018 Cavium, Inc.
78 …- For ending "endless completion". 0 - When receiving a completion timeout while receiving a compl…
79 … DataWidth:0x4 // 0 - TXCPL sync fifo pop underflow 1 - TXR sync fifo pop underflow 2 - TXW hea…
80 …s:R DataWidth:0x6 // 0 - RX target read and config sync fifo push overflow 1 - RX header syn…
81 …ataWidth:0x14 // 4:0 - TXCPL sync fifo pop status 9:5 - TXR sync fifo pop status 14:10 - TXW hea…
88 …ffff<<0) // Vendor ID. PCI-SIG assigned Manufacturer Identifier. Note: The access attributes of …
90 …ce Identifier. Note: The access attributes of this field are as follows: - Dbi: if (DBI_RO_WR_E…
116 … (0x1<<9) // Fast back-to-back transaction ena…
128 … (0x1<<23) // Fast back-to-back capable. Not ap…
145 …l has_io_bar=0. Note: The access attributes of this field are as follows: - Dbi: if (DBI_RO_WR_E…
[all …]
/freebsd/sys/dev/sfxge/common/
H A Defx_regs_mcdi.h1 /*-
2 * SPDX-License-Identifier: BSD-2-Clause
4 * Copyright 2008-2013 Solarflare Communications Inc. All rights reserved.
32 /* Power-on reset state */
54 /* The 'doorbell' addresses are hard-wired to alert the MC when written */
57 /* The rest of these are firmware-defined */
65 /* Values to be written to the per-port status dword in shared
94 * | | \--- Response
95 * | \------- Error
96 * \------------------------------ Resync (always set)
[all …]
/freebsd/share/misc/
H A Dpci_vendors5 # Date: 2024-11-25 03:15:02
8 # the PCI ID Project at https://pci-ids.ucw.cz/.
14 # (version 2 or higher) or the 3-clause BSD License.
25 # device device_name <-- single tab
26 # subvendor subdevice subsystem_name <-- two tabs
30 # This is a relabelled RTL-8139
31 8139 AT-2500TX V3 Ethernet
41 7a09 PCI-to-PCI Bridge
50 7a19 PCI-to-PCI Bridge
55 7a29 PCI-to-PCI Bridge
[all …]