Searched +full:spi +full:- +full:fsi (Results 1 – 11 of 11) sorted by relevance
| /linux/arch/arm/boot/dts/aspeed/ |
| H A D | ibm-power11-quad.dtsi | 1 // SPDX-License-Identifier: GPL-2.0-or-later 125 #address-cells = <2>; 126 #size-cells = <0>; 128 bus-frequency = <100000000>; 129 cfam-reset-gpios = <&gpio0 ASPEED_GPIO(Q, 0) GPIO_ACTIVE_HIGH>; 133 #address-cells = <1>; 134 #size-cells = <1>; 135 chip-id = <0>; 138 compatible = "ibm,p9-scom"; 143 compatible = "ibm,i2c-fsi"; [all …]
|
| H A D | aspeed-bmc-opp-tacoma.dts | 1 // SPDX-License-Identifier: GPL-2.0-or-later 3 /dts-v1/; 5 #include "aspeed-g6.dtsi" 6 #include <dt-bindings/gpio/aspeed-gpio.h> 7 #include <dt-bindings/i2c/i2c.h> 8 #include <dt-bindings/leds/leds-pca955x.h> 12 compatible = "ibm,tacoma-bmc", "aspeed,ast2600"; 15 stdout-path = &uart5; 24 reserved-memory { 25 #address-cells = <1>; [all …]
|
| /linux/Documentation/devicetree/bindings/fsi/ |
| H A D | ibm,fsi2spi.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-or-later) 3 --- 4 $id: http://devicetree.org/schemas/fsi/ibm,fsi2spi.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: IBM FSI-attached SPI controllers 10 - Eddie James <eajames@linux.ibm.com> 13 This binding describes an FSI CFAM engine called the FSI2SPI. Therefore this 14 node will always be a child of an FSI CFAM node. This FSI2SPI engine provides 15 access to a number of SPI controllers. 20 - ibm,fsi2spi [all …]
|
| H A D | fsi-controller.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/fsi/fsi-controller.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: FSI Controller Common Properties 10 - Eddie James <eajames@linux.ibm.com> 13 FSI (FRU (Field Replaceable Unit) Service Interface) is a two wire bus. The 14 FSI bus is connected to a CFAM (Common FRU Access Macro) which contains 15 various engines such as I2C controllers, SPI controllers, etc. 18 "#address-cells": [all …]
|
| /linux/Documentation/devicetree/bindings/spi/ |
| H A D | ibm,spi-fsi.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/spi/ibm,spi-fsi.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: IBM FSI-attached SPI Controller 10 - Eddie James <eajames@linux.ibm.com> 13 A SPI controller found on IBM Power processors, accessed over FSI from a 20 - ibm,spi-fsi 26 - compatible 27 - reg [all …]
|
| /linux/drivers/base/regmap/ |
| H A D | Kconfig | 1 # SPDX-License-Identifier: GPL-2.0 47 depends on SPI 89 depends on SPI 93 depends on FSI
|
| H A D | Makefile | 1 # SPDX-License-Identifier: GPL-2.0 3 CFLAGS_regmap.o := -I$(src) 5 obj-$(CONFIG_REGMAP) += regmap.o regcache.o 6 obj-$(CONFIG_REGMAP) += regcache-rbtree.o regcache-flat.o regcache-maple.o 7 obj-$(CONFIG_DEBUG_FS) += regmap-debugfs.o 8 obj-$(CONFIG_REGMAP_KUNIT) += regmap-kunit.o 9 obj-$(CONFIG_REGMAP_AC97) += regmap-ac97.o 10 obj-$(CONFIG_REGMAP_I2C) += regmap-i2c.o 11 obj-$(CONFIG_REGMAP_RAM) += regmap-ram.o regmap-raw-ram.o 12 obj-$(CONFIG_REGMAP_SLIMBUS) += regmap-slimbus.o [all …]
|
| /linux/arch/sh/boards/mach-ecovec24/ |
| H A D | setup.c | 1 // SPDX-License-Identifier: GPL-2.0 33 #include <linux/spi/mmc_spi.h> 34 #include <linux/spi/sh_msiof.h> 35 #include <linux/spi/spi.h> 39 #include <linux/dma-map-ops.h> 41 #include <media/drv-intf/renesas-ceu.h> 52 *----------------------------------------- 62 *------------------------------ 71 * DS2[6-7] = MMC / SD ON-OFF : SD 72 * OFF-ON : MMC [all …]
|
| /linux/drivers/ |
| H A D | Makefile | 1 # SPDX-License-Identifier: GPL-2.0 6 # Rewritten to use lists instead of if-statements. 9 obj-y += cache/ 10 obj-y += irqchip/ 11 obj-y += bus/ 13 obj-$(CONFIG_GENERIC_PHY) += phy/ 16 obj-$(CONFIG_PINCTRL) += pinctrl/ 17 obj-$(CONFIG_GPIOLIB) += gpio/ 18 obj-y += pwm/ 21 obj-y += leds/ [all …]
|
| /linux/sound/soc/codecs/ |
| H A D | rt5514.c | 1 // SPDX-License-Identifier: GPL-2.0-only 3 * rt5514.c -- RT5514 ALSA SoC audio codec driver 24 #include <sound/soc-dapm.h> 31 #include "rt5514-spi.h" 120 regmap_write(rt5514->i2c_regmap, 0x18002000, 0x000010ec); in rt5514_enable_dsp_prepare() 122 regmap_write(rt5514->i2c_regmap, 0x18002200, 0x00028604); in rt5514_enable_dsp_prepare() 124 regmap_write(rt5514->i2c_regmap, 0xfafafafa, 0x00000001); in rt5514_enable_dsp_prepare() 125 /* mini-core reset */ in rt5514_enable_dsp_prepare() 126 regmap_write(rt5514->i2c_regmap, 0x18002f00, 0x0005514b); in rt5514_enable_dsp_prepare() 127 regmap_write(rt5514->i2c_regmap, 0x18002f00, 0x00055149); in rt5514_enable_dsp_prepare() [all …]
|
| /linux/ |
| H A D | MAINTAINERS | 5 --------------------------------------------------- 21 W: *Web-page* with status/info 23 B: URI for where to file *bugs*. A web-page with detailed bug 28 patches to the given subsystem. This is either an in-tree file, 29 or a URI. See Documentation/maintainer/maintainer-entry-profile.rst 46 N: [^a-z]tegra all files whose path contains tegra 64 ---------------- 83 3WARE SAS/SATA-RAID SCSI DRIVERS (3W-XXXX, 3W-9XXX, 3W-SAS) 85 L: linux-scsi@vger.kernel.org 88 F: drivers/scsi/3w-* [all …]
|