| /linux/arch/arm64/boot/dts/rockchip/ |
| H A D | rk3588-jaguar-pre-ict-tester.dtso | 89 * rail. It should be HIGH if all is properly soldered.
114 * rail. It should be HIGH if all is properly soldered.
132 * It should be HIGH if all is properly soldered.
142 * It should be HIGH if all is properly soldered.
152 * It should be HIGH if all is properly soldered.
162 * It should be HIGH if all is properly soldered.
|
| /linux/arch/arm/boot/dts/allwinner/ |
| H A D | sun6i-a31s-sina31s.dts | 43 /* The SinA31s development board has the SinA31s core board soldered on */
|
| /linux/Documentation/devicetree/bindings/arm/ |
| H A D | fsl.yaml | 762 - const: dh,imx6ull-dhcom-som # The DHCOR is soldered on the DHCOM
1042 variants. It is designed to be soldered on different carrier boards.
1075 variants. It is designed to be soldered on different carrier boards.
1224 variants. It is designed to be soldered on different carrier boards.
1413 TQMa93xxLA is designed to be soldered on different carrier boards.
1419 soldered on an adapter board or for the connector variant
1422 soldered on an adapter board or for the connector variant
|
| /linux/Documentation/security/tpm/ |
| H A D | xen-tpmfront.rst | 109 The physical TPM that is soldered onto the motherboard.
|
| /linux/arch/arm/boot/dts/marvell/ |
| H A D | armada-xp-openblocks-ax3-4.dts | 25 reg = <0 0x00000000 0 0x40000000>; /* 1 GB soldered on */
|
| /linux/arch/arm64/boot/dts/amlogic/ |
| H A D | meson-gxl-s805x-libretech-ac.dts | 32 * The pads are present but no connector is soldered on
|
| /linux/drivers/bluetooth/ |
| H A D | btsdio.c | 287 /* Broadcom devices soldered onto the PCB (non-removable) use an in btsdio_probe()
|
| /linux/Documentation/firmware-guide/acpi/ |
| H A D | enumeration.rst | 587 For example, some systems use PCI devices soldered directly on the mother board,
597 Exar XR17V3521, soldered on the main board. This UART chip also includes
|
| /linux/Documentation/networking/device_drivers/can/ |
| H A D | can327.rst | 326 Your adapter may have resistors soldered in which are meant to terminate
|
| /linux/Documentation/i2c/ |
| H A D | instantiating-devices.rst | 264 * You are developing a driver on a test board, where you soldered the I2C
|
| /linux/include/linux/ssb/ |
| H A D | ssb.h | 197 /* Information about the PCB the circuitry is soldered on. */
|
| /linux/Documentation/driver-api/gpio/ |
| H A D | driver.rst | 236 In discrete designs, a pull-up or pull-down resistor is simply soldered on
|
| /linux/arch/arm/boot/dts/st/ |
| H A D | stm32mp13-pinctrl.dtsi | 252 * has been soldered onto the reset line which forces
|
| /linux/drivers/net/can/usb/ |
| H A D | ucan.c | 1581 /* Mule (soldered onto compute modules) */
|
| /linux/drivers/media/pci/bt8xx/ |
| H A D | bttv-cards.c | 1804 not soldered here, though unknown wiring.
2999 * xxxFFF: No remote control chip soldered in flyvideo_gpio()
3000 * xxxF00(LR26/LR50), xxxFE0(LR90): Remote control chip (LVA001 or CF45) soldered in flyvideo_gpio()
|
| /linux/Documentation/admin-guide/media/ |
| H A D | bttv.rst | 885 .. [#f2] Sony NE41S soldered (stereo sound?)
|
| /linux/drivers/hid/ |
| H A D | hid-sony.c | 450 struct sixaxis_led _reserved; /* LED5, not actually soldered */
|
| /linux/include/linux/ |
| H A D | pci.h | 2724 * Thunderbolt-attached. (But rather soldered to the mainboard usually.)
|
| /linux/drivers/gpu/drm/radeon/ |
| H A D | atombios.h | 2203 #define SET_VOLTAGE_GET_MAX_VOLTAGE 6 //Gets the Max. voltage for the soldered Asic
|
| /linux/drivers/gpu/drm/amd/include/ |
| H A D | atombios.h | 2586 …ET_VOLTAGE_GET_MAX_VOLTAGE 6 //Gets the Max. voltage for the soldered Asic
|
| /linux/drivers/net/ethernet/sfc/siena/ |
| H A D | mcdi_pcol.h | 7576 /* Discrete (soldered) DDR resistor strap info */
|