Searched +full:sgmii +full:- +full:enable +full:- +full:pll (Results 1 – 10 of 10) sorted by relevance
/freebsd/sys/contrib/device-tree/src/arm/broadcom/ |
H A D | bcm958625-meraki-alamo.dtsi | 1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT 5 * Copyright (C) 2020-2021 Matthew Hagan <mnhagan88@gmail.com> 8 #include "bcm958625-meraki-mx6x-common.dtsi" 12 compatible = "gpio-keys-polled"; 14 poll-interval = <20>; 16 button-reset { 24 compatible = "gpio-leds"; 26 led-0 { 27 /* green:wan1-left */ 29 function-enumerator = <0>; [all …]
|
/freebsd/sys/contrib/device-tree/Bindings/net/dsa/ |
H A D | qca8k.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 5 $schema: http://devicetree.org/meta-schema [all...] |
/freebsd/sys/dev/e1000/ |
H A D | e1000_82575.c | 2 SPDX-License-Identifier: BSD-3-Clause 4 Copyright (c) 2001-2020, Intel Corporation 121 * e1000_sgmii_uses_mdio_82575 - Determine if I2C pins are for external MDIO 134 switch (hw->mac.type) { in e1000_sgmii_uses_mdio_82575() 155 * e1000_init_phy_params_82575 - Initialize PHY function ptrs 160 struct e1000_phy_info *phy = &hw->phy; in e1000_init_phy_params_82575() 166 phy->ops.read_i2c_byte = e1000_read_i2c_byte_generic; in e1000_init_phy_params_82575() 167 phy->ops.write_i2c_byte = e1000_write_i2c_byte_generic; in e1000_init_phy_params_82575() 169 if (hw->phy.media_type != e1000_media_type_copper) { in e1000_init_phy_params_82575() 170 phy->type = e1000_phy_none; in e1000_init_phy_params_82575() [all …]
|
H A D | e1000_regs.h | 2 SPDX-License-Identifier: BSD-3-Clause 4 Copyright (c) 2001-2020, Intel Corporation 38 #define E1000_CTRL 0x00000 /* Device Control - RW */ 39 #define E1000_CTRL_DUP 0x00004 /* Device Control Duplicate (Shadow) - RW */ 40 #define E1000_STATUS 0x00008 /* Device Status - RO */ 41 #define E1000_EECD 0x00010 /* EEPROM/Flash Control - RW */ 42 #define E1000_EERD 0x00014 /* EEPROM Read - RW */ 43 #define E1000_CTRL_EXT 0x00018 /* Extended Device Control - RW */ 44 #define E1000_FLA 0x0001C /* Flash Access - RW */ 45 #define E1000_MDIC 0x00020 /* MDI Control - RW */ [all …]
|
/freebsd/sys/dev/neta/ |
H A D | if_mvnetareg.h | 46 /* XXX: Currently multi-queue can be used on the Tx side only */ 53 #if MVNETA_TX_QNUM_MAX & (MVNETA_TX_QNUM_MAX - 1) != 0 56 #if MVNETA_RX_QNUM_MAX & (MVNETA_RX_QNUM_MAX - 1) != 0 62 #define MVNETA_TX_QUEUE_ALL ((1<<MVNETA_TX_QNUM_MAX)-1) 63 #define MVNETA_RX_QUEUE_ALL ((1<<MVNETA_RX_QNUM_MAX)-1) 76 #define MVNETA_BARE 0x2290 /* Base Address Enable */ 85 #define MVNETA_MBUS_RETRY_EN 0x20 /* MBUS transactions retry enable */ 134 /* Rx DMA Wake on LAN Registers 0x3690 - 0x36b8 */ 149 #define MVNETA_TXTBC(q) (0x3ca0 + ((q) << 2)) /* TX Trans-ed Buf Count*/ 159 #define MVNETA_TQTBC_V1 0x24e0 /* Transmit Queue Token-Bucket Cfg */ [all …]
|
/freebsd/sys/contrib/alpine-hal/ |
H A D | al_hal_serdes_interface.h | 9 found at http://www.gnu.org/licenses/gpl-2.0.html 53 /* *INDENT-OFF* */ 57 /* *INDENT-ON* */ 178 * Tx de-emphasis parameters 183 AL_SERDES_TX_DEEMP_C_MINUS, /*< c(-1) */ 196 * Transmit Amplitude control signal. Used to define the full-scale 198 * 000 - Not Supported 199 * 001 - 952mVdiff-pkpk 200 * 010 - 1024mVdiff-pkpk 201 * 011 - 1094mVdiff-pkpk [all …]
|
/freebsd/sys/dev/bxe/ |
H A D | bxe_elink.c | 1 /*- 2 * SPDX-License-Identifier: BSD-2-Clause 4 * Copyright (c) 2007-2017 QLogic Corporation. All rights reserved. 508 /* When this pin is active high during reset, 10GBASE-T core is power 509 * down, When it is active low the 10GBASE-T is power up 774 #define I2C_WA_PWR_ITER (I2C_WA_RETRY_CNT - 1) 936 (_phy)->def_md_devad, \ 942 (_phy)->def_md_devad, \ 970 * elink_check_lfa - This function checks if link reinitialization is required, 982 struct bxe_softc *sc = params->sc; in elink_check_lfa() [all …]
|
/freebsd/sys/dev/qlnx/qlnxe/ |
H A D | reg_addr.h | 2 * Copyright (c) 2017-2018 Cavium, Inc. 73 … 0x003818UL //Access:RW DataWidth:0x6 // Statistic mask enable Bit5 : Mask Messa… 78 …- For ending "endless completion". 0 - When receiving a completion timeout while receiving a compl… 79 … DataWidth:0x4 // 0 - TXCPL sync fifo pop underflow 1 - TXR sync fifo pop underflow 2 - TXW hea… 80 …s:R DataWidth:0x6 // 0 - RX target read and config sync fifo push overflow 1 - RX header syn… 81 …ataWidth:0x14 // 4:0 - TXCPL sync fifo pop status 9:5 - TXR sync fifo pop status 14:10 - TXW hea… 88 …ffff<<0) // Vendor ID. PCI-SIG assigned Manufacturer Identifier. Note: The access attributes of … 90 …ce Identifier. Note: The access attributes of this field are as follows: - Dbi: if (DBI_RO_WR_E… 98 … (0x1<<0) // I/O space access enable. There are no I/O… 100 … (0x1<<1) // Memory space access enable. [all …]
|
/freebsd/sys/dev/sfxge/common/ |
H A D | efx_regs_mcdi.h | 1 /*- 2 * SPDX-License-Identifier: BSD-2-Clause 4 * Copyright 2008-2013 Solarflare Communications Inc. All rights reserved. 32 /* Power-on reset state */ 54 /* The 'doorbell' addresses are hard-wired to alert the MC when written */ 57 /* The rest of these are firmware-defined */ 65 /* Values to be written to the per-port status dword in shared 94 * | | \--- Response 95 * | \------- Error 96 * \------------------------------ Resync (always set) [all …]
|
/freebsd/sys/dev/bnxt/bnxt_en/ |
H A D | hsi_struct_def.h | 1 /*- 34 * Copyright(c) 2001-2025, Broadcom. All rights reserved. The 71 * * 0x0-0xFFF8 - The function ID 72 * * 0xFFF8-0xFFFC, 0xFFFE - Reserved for internal processors 73 * * 0xFFFD - Reserved for user-space HWRM interface 74 * * 0xFFFF - HWRM 122 /* Engine CKV - The Alias key EC curve and ECC public key information. */ 124 /* Engine CKV - Initialization vector. */ 126 /* Engine CKV - Authentication tag. */ 128 /* Engine CKV - The encrypted data. */ [all …]
|