Searched +full:scl +full:- +full:has +full:- +full:no +full:- +full:pullup (Results 1 – 5 of 5) sorted by relevance
1 # SPDX-License-Identifier: GPL-2.03 ---4 $id: http://devicetree.org/schemas/i2c/i2c-gpio.yaml#5 $schema: http://devicetree.org/meta-schemas/core.yaml#10 - Wolfram Sang <wsa@kernel.org>13 - $ref: /schemas/i2c/i2c-controller.yaml#18 - const: i2c-gpio20 sda-gpios:24 from <dt-bindings/gpio/gpio.h> since the signal is by definition28 scl-gpios:[all …]
4 -------------------5 - compatible: Must be "ams,as3722".6 - reg: I2C device address.7 - interrupt-controller: AS3722 has internal interrupt controller which takes the8 interrupt request from internal sub-blocks like RTC, regulators, GPIOs as well10 - #interrupt-cells: Should be set to 2 for IRQ number and flags.12 of AS3722 are defined at dt-bindings/mfd/as3722.h14 interrupts.txt, using dt-bindings/irq.17 --------------------18 - ams,enable-internal-int-pullup: Boolean property, to enable internal pullup on[all …]
1 // SPDX-License-Identifier: GPL-2.0-only3 * Devicetree for the Samsung Galaxy S Advance GT-I9070 also known as Janice.6 /dts-v1/;7 #include "ste-db8500.dtsi"8 #include "ste-ab8500.dtsi"9 #include "ste-dbx5x0-pinctrl.dtsi"10 #include <dt-bindings/gpio/gpio.h>11 #include <dt-bindings/leds/common.h>12 #include <dt-bindings/input/input.h>13 #include <dt-bindings/interrupt-controller/irq.h>[all …]
1 // SPDX-License-Identifier: GPL-2.0-only3 * Devicetree for the Samsung Galaxy Beam GT-I8530 also known as Gavini.6 /dts-v1/;7 #include "ste-db8500.dtsi"8 #include "ste-ab8500.dtsi"9 #include "ste-dbx5x0-pinctrl.dtsi"10 #include <dt-bindings/gpio/gpio.h>11 #include <dt-bindings/leds/common.h>12 #include <dt-bindings/input/input.h>13 #include <dt-bindings/interrupt-controller/irq.h>[all …]
1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)5 * Copyright 2016-2017 Google, Inc8 #include <dt-bindings/input/input.h>9 #include "rk3399-op1.dtsi"18 stdout-path = "serial2:115200n8";27 * - Rails that only connect to the EC (or devices that the EC talks to)29 * - Rails _are_ included if the rails go to the AP even if the AP38 * - The EC controls the enable and the EC always enables a rail as40 * - The rails are actually connected to each other by a jumper and45 ppvar_sys: regulator-ppvar-sys {[all …]