Searched +full:scl +full:- +full:has +full:- +full:no +full:- +full:pullup (Results 1 – 8 of 8) sorted by relevance
/freebsd/sys/contrib/device-tree/Bindings/i2c/ |
H A D | i2c-gpio.yaml | 1 # SPDX-License-Identifier: GPL-2.0 3 --- 4 $id: http://devicetree.org/schemas/i2c/i2c-gpio.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Wolfram Sang <wsa@kernel.org> 13 - $ref: /schemas/i2c/i2c-controller.yaml# 18 - const: i2c-gpio 20 sda-gpios: 24 from <dt-bindings/gpio/gpio.h> since the signal is by definition 28 scl-gpios: [all …]
|
/freebsd/sys/contrib/device-tree/src/arm64/rockchip/ |
H A D | rk3399-gru-kevin.dts | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT) 3 * Google Gru-Kevin Rev 6+ board device tree source 5 * Copyright 2016-2017 Google, Inc 8 /dts-v1/; 9 #include "rk3399-gru-chromebook.dtsi" 10 #include <dt-bindings/input/linux-event-codes.h> 13 * Kevin-specific things 15 * Things in this section should use names from Kevin schematic since no 21 compatible = "google,kevin-rev15", "google,kevin-rev14", 22 "google,kevin-rev13", "google,kevin-rev12", [all …]
|
H A D | rk3399-gru.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT) 5 * Copyright 2016-2017 Google, Inc 8 #include <dt-bindings/input/input.h> 9 #include "rk3399-op1.dtsi" 18 stdout-path = "serial2:115200n8"; 27 * - Rails that only connect to the EC (or devices that the EC talks to) 29 * - Rails _are_ included if the rails go to the AP even if the AP 38 * - The EC controls the enable and the EC always enables a rail as 40 * - The rails are actually connected to each other by a jumper and 45 ppvar_sys: ppvar-sys { [all …]
|
/freebsd/sys/contrib/device-tree/Bindings/mfd/ |
H A D | as3722.txt | 4 ------------------- 5 - compatible: Must be "ams,as3722". 6 - reg: I2C device address. 7 - interrupt-controller: AS3722 has internal interrupt controller which takes the 8 interrupt request from internal sub-blocks like RTC, regulators, GPIOs as well 10 - #interrupt-cells: Should be set to 2 for IRQ number and flags. 12 of AS3722 are defined at dt-bindings/mfd/as3722.h 14 interrupts.txt, using dt-bindings/irq. 17 -------------------- 18 - ams,enable-internal-int-pullup: Boolean property, to enable internal pullup on [all …]
|
/freebsd/sys/contrib/device-tree/src/arm/st/ |
H A D | ste-ux500-samsung-codina-tmo.dts | 1 // SPDX-License-Identifier: GPL-2.0-only 3 * Devicetree for the Samsung Galaxy Exhibit SGH-T599 also known as Codina-TMO, 4 * the "TMO" shall be read "T-Mobile" as this phone was produced exlusively 5 * for T-Mobile in the United States. 7 * This phone is closely related to the Codina, but has: 8 * - N [all...] |
H A D | ste-ux500-samsung-codina.dts | 1 // SPDX-License-Identifier: GPL-2.0-only 3 * Devicetree for the Samsung Galaxy Ace 2 GT-I8160 also known as Codina. 11 * The Samsung tree further talks about GT-I8160P and GT-I8160chn (China). 12 * The GT-I8160 plain is known as the "europe" variant. 13 * The GT-I8160P is the CDMA version and it appears to not use the ST 14 * Microelectronics accelerometer and reportedly has NF [all...] |
H A D | ste-ux500-samsung-janice.dts | 1 // SPDX-License-Identifier: GPL-2.0-only 3 * Devicetree for the Samsung Galaxy S Advance GT-I9070 also known as Janice. 6 /dts-v1/; 7 #include "ste-db8500.dtsi" 8 #include "ste-ab8500.dtsi" 9 #include "ste-dbx5x0-pinctr [all...] |
H A D | ste-ux500-samsung-gavini.dts | 1 // SPDX-License-Identifier: GPL-2.0-only 3 * Devicetree for the Samsung Galaxy Beam GT-I8530 also known as Gavini. 6 /dts-v1/; 7 #include "ste-db8500.dtsi" 8 #include "ste-ab8500.dtsi" 9 #include "ste-dbx5x0-pinctr [all...] |