| /freebsd/sys/contrib/device-tree/src/arm64/rockchip/ |
| H A D | rk3588-jaguar-pre-ict-tester.dtso | 76 * routed to the mezzanine connector to report a proper
78 * incorrect value if VCC_1V8_S0_1 isn't properly routed,
80 * If VCC_IN_2 is properly routed, GPIO3_A3 should be
82 * GPIO3_A3 isn't properly routed due to soldering
88 * GPIO3_A4 is directly routed to VCC_1V8_S0_2 power
98 * routed to the mezzanine connector to report a proper
100 * incorrect value if VCC_1V8_S0_1 isn't properly routed,
102 * If VCC_IN_1 is properly routed, GPIO3_B2 should be
104 * routed due to soldering issue, because GPIO3_B2
113 * GPIO3_C6 is directly routed to VCC_1V8_S0_1 power
[all …]
|
| H A D | rk3588-jaguar-ethernet-switch.dtso | 13 * - two digital inputs (pin4 routed to GPIO3_C5 on SoC, pin5 to GPIO4_B4)
14 * - two digital outputs (pin7 routed to GPIO3_D3 on SoC, pin8 to GPIO3_D1)
113 microchip,synclko-disable; /* CLKO_25_125 only routed to TP1 */
|
| /freebsd/sys/contrib/device-tree/Bindings/leds/ |
| H A D | leds-bcm6328.txt | 207 /* USB link/activity routed to USB LED */
213 /* INET activity routed to INET LED */
219 /* EPHY0 link routed to EPHY0 LED */
225 /* EPHY1 link routed to EPHY1 LED */
231 /* EPHY2 link routed to EPHY2 LED */
237 /* EPHY3 link routed to EPHY3 LED */
259 /* USB/INET link/activity routed to USB LED */
265 /* EPHY0/1/2/3 link routed to EPHY0 LED */
287 /* USB link/act and INET act routed to USB LED */
293 /* EPHY3 link routed to EPHY0 LED */
[all …]
|
| H A D | leds-bcm6328.yaml | 275 /* USB link/activity routed to USB LED */
282 /* INET activity routed to INET LED */
289 /* EPHY0 link routed to EPHY0 LED */
296 /* EPHY1 link routed to EPHY1 LED */
303 /* EPHY2 link routed to EPHY2 LED */
310 /* EPHY3 link routed to EPHY3 LED */
333 /* USB/INET link/activity routed to USB LED */
340 /* EPHY0/1/2/3 link routed to EPHY0 LED */
363 /* USB link/act and INET act routed to USB LED */
370 /* EPHY3 link routed to EPHY0 LED */
[all …]
|
| /freebsd/sbin/routed/rtquery/ |
| H A D | rtquery.8 | 28 .Xr routed 8 ,
67 .Xr routed 8
79 .Xr routed 8 .
118 .Pa /etc/routed.trace .
127 .Xr routed 8
|
| /freebsd/sys/contrib/device-tree/Bindings/soc/fsl/cpm_qe/ |
| H A D | fsl,cpm1-scc-qmc.yaml | 14 serial controller using the same TDM physical interface routed from TSA.
95 Channel assigned Tx time-slots within the Tx time-slots routed by the
101 Channel assigned Rx time-slots within the Rx time-slots routed by the
165 /* Ch16 : First 4 even TS from all routed from TSA */
174 /* Ch17 : First 4 odd TS from all routed from TSA */
183 /* Ch19 : 8 TS (TS 8..15) from all routed from TSA */
|
| H A D | fsl,qe-ucc-qmc.yaml | 14 serial controller using the same TDM physical interface routed from TSA.
107 Channel assigned Tx time-slots within the Tx time-slots routed by the
113 Channel assigned Rx time-slots within the Rx time-slots routed by the
169 /* Ch16 : First 4 even TS from all routed from TSA */
178 /* Ch17 : First 4 odd TS from all routed from TSA */
187 /* Ch19 : 8 TS (TS 8..15) from all routed from TSA */
|
| /freebsd/sys/contrib/device-tree/Bindings/pinctrl/ |
| H A D | sunplus,sp7021-pinctrl.yaml | 43 can be routed to any pins of fully pin-mux pins.
47 routed to GPIO 10 (3 - 1 + 8 = 10).
49 routed to GPIO 11 (4 - 1 + 8 = 11).
51 be routed to GPIO 12 (5 - 1 + 8 = 12).
53 be routed to GPIO 13 (6 - 1 + 8 = 13).
57 be routed to GPIO 27 (20 - 1 + 8 = 27).
59 will be routed to GPIO 28 (21 - 1 + 9 = 28).
62 routed to any of 64 'fully pin-mux' pins.
|
| /freebsd/sbin/routed/ |
| H A D | Makefile | 1 # Make `routed` for FreeBSD
4 PROG= routed
5 MAN= routed.8
|
| H A D | pathnames.h | 38 * If this is a directory, routed will create log files in it. That
44 * when routed was started, if any, will be appended to.
46 #define _PATH_TRACE "/etc/routed.trace"
|
| /freebsd/contrib/tcp_wrappers/ |
| H A D | BLURB | 17 modern UNIX systems that can already stop source-routed traffic in
25 receive source-routed connections and are therefore not vulnerable
26 to IP spoofing attacks with source-routed TCP connections.
|
| /freebsd/share/doc/smm/01.setup/ |
| H A D | 5.t | 201 to allow packets to be properly routed. Two schemes are
215 .Xr routed (8)
238 .Xr routed (8)
360 /sbin/routed routing table management daemon \f(CW/etc/rc\fP
376 .Xr routed
383 .Xr routed
390 .Xr routed .
398 .Xr "routed -q"
|
| /freebsd/sys/contrib/device-tree/src/arm64/marvell/ |
| H A D | cn9132-clearfog.dts | 135 /* This bus is also routed to STM32 BMC Microcontroller (U2) */
226 /* Routed to Full PCIe (J4) */
230 /* Routed to USB Hub (U29) */
234 /* Routed to M.2 (CON4) */
238 /* Routed to M.2 (CON5) */
242 /* Routed to M.2 (J21) */
250 /* Routed to mini-PCIe (J14) */
258 /* Routed to various optional PTP related components */
|
| /freebsd/libexec/rc/rc.d/ |
| H A D | routed | 5 # PROVIDE: routed dynamicrouting
12 name="routed"
|
| /freebsd/sys/contrib/device-tree/src/arm64/renesas/ |
| H A D | rzg3s-smarc-switches.h | 35 * SW_OFF - The SMARC SER0 signals are routed to M.2 Key E UART
36 * SW_ON - The SMARC SER0 signals are routed to PMOD1
|
| /freebsd/sys/contrib/device-tree/Bindings/interrupt-controller/ |
| H A D | interrupts.txt | 13 which the interrupts are routed; see section 2 below for details.
20 interrupts are routed and contains a single phandle referring to the interrupt
116 interrupts routed to them, so that they can wakeup the SoC from suspend. These
|
| H A D | riscv,cpu-intc.txt | 7 Every interrupt is ultimately routed through a hart's HLIC before it
15 interrupts connect all other device interrupts to the HLIC, which are routed
|
| /freebsd/sys/contrib/device-tree/Bindings/mailbox/ |
| H A D | omap-mailbox.txt | 11 interrupt lines. An output interrupt line is routed to an interrupt controller
25 routed to different processor sub-systems on DRA7xx as they are routed through
29 all these clusters are multiplexed and routed to different processor subsystems
|
| H A D | ti,omap-mailbox.yaml | 20 output interrupt lines. An output interrupt line is routed to an interrupt
35 lines can also be routed to different processor sub-systems on DRA7xx as they
36 are routed through the Crossbar, a kind of interrupt router/multiplexer. The
39 NavSS. The interrupt lines from all these clusters are multiplexed and routed
|
| /freebsd/tests/sys/netinet/ |
| H A D | carp.sh | 199 jexec carp_uni_v4_two routed -s -Pripv2
200 jexec carp_uni_v4_three routed -s -Pripv2
201 jexec carp_uni_v4_one routed -Pripv2
218 jexec carp_uni_v4_one killall routed
219 jexec carp_uni_v4_two killall routed
220 jexec carp_uni_v4_three killall routed
|
| /freebsd/share/man/man4/ |
| H A D | me.4 | 50 These encapsulated datagrams are routed to a destination host,
51 where they are decapsulated and further routed to their final destination.
|
| H A D | inet6.4 | 366 IPv4 traffic may be routed with certain
395 should be routed to that
407 IPv4 traffic should be routed to the
409 socket and IPv6 should be routed to the
|
| /freebsd/sys/contrib/device-tree/Bindings/connector/ |
| H A D | usb-connector.yaml | 377 # Micro-USB connector with HS lines routed via controller (MUIC).
387 # USB-C connector attached to CC controller (s2mm005), HS lines routed
389 # DisplayPort video lines are routed to the connector via SS mux in USB3 PHY.
464 # with SS 2:1 MUX. HS lines routed to SoC, SS lines routed to the MUX and
503 # Micro-USB connector with HS lines routed via controller (MUIC) and MHL
|
| /freebsd/sys/contrib/device-tree/src/arm/marvell/ |
| H A D | armada-385-turris-omnia.dts | 379 /* routed to PCIe0/mSATA connector (CN7A) */
387 /* routed to PCIe1/USB2 connector (CN61A) */
395 /* routed to PCIe2 connector (CN62A) */
403 /* routed to SFP+ */
588 /* MISO, MOSI, SCLK and CS2 are routed to pin header CN11 */
|
| /freebsd/sys/contrib/device-tree/Bindings/clock/ |
| H A D | lpc1850-ccu.txt | 22 Shall contain a list of phandles for the base clocks routed
26 Shall contain a list of names for the base clock routed
|