/linux/Documentation/ABI/testing/ |
H A D | sysfs-bus-cdx | 92 device from the CDX bus. If the device is to be reconfigured 93 reconfigured in the Hardware, the device can be removed, so 95 being reconfigured.
|
/linux/include/xen/interface/io/ |
H A D | xenbus.h | 34 * Reconfiguring: The device is being reconfigured.
|
/linux/Documentation/userspace-api/gpio/ |
H A D | gpio-v2-get-lineinfo-watch-ioctl.rst | 37 or reconfigured.
|
H A D | gpio-get-lineinfo-watch-ioctl.rst | 41 or reconfigured.
|
/linux/drivers/net/wireless/ath/ath10k/ |
H A D | leds.c | 44 /* under some circumstances, the gpio pin gets reconfigured in ath10k_leds_start()
|
/linux/drivers/infiniband/hw/mlx5/ |
H A D | umr.h | 47 * true if an existing MR can be reconfigured to new access_flags using UMR.
|
/linux/Documentation/ABI/stable/ |
H A D | sysfs-bus-xen-backend | 84 'Closed', 'Reconfiguring', 'Reconfigured'.
|
/linux/Documentation/driver-api/serial/ |
H A D | driver.rst | 58 removed or reconfigured at inappropriate times. Since v2.6.27, this
|
/linux/drivers/staging/vc04_services/vchiq-mmal/ |
H A D | mmal-msg-port.h | 34 * whether the port supports being reconfigured via a format
|
/linux/sound/virtio/ |
H A D | virtio_pcm.h | 36 * @suspended: True if the substream is suspended and must be reconfigured on
|
/linux/drivers/clk/qcom/ |
H A D | apcs-sdx55.c | 32 * (mux and divider), while the A7 PLL is reconfigured.
|
H A D | apcs-msm8916.c | 29 * (mux and divider), while the A53 PLL is reconfigured.
|
H A D | clk-cbf-8996.c | 283 /* Ensure write goes through before PLLs are reconfigured */ in qcom_msm8996_cbf_probe()
|
/linux/drivers/usb/typec/ |
H A D | retimer.c | 100 * these retimers need to be reconfigured appropriately. This function registers retimer
|
/linux/drivers/pwm/ |
H A D | pwm-raspberrypi-poe.c | 12 * The current period is completed when HW is reconfigured.
|
/linux/drivers/net/arcnet/ |
H A D | arcdevice.h | 138 #define RECONflag 0x04 /* network reconfigured */ 167 #define CONFIGclear 0x10 /* system reconfigured */
|
/linux/arch/arm64/boot/dts/freescale/ |
H A D | imx8mq-hummingboard-pulse.dts | 166 * reconfigured to enable RTS/CTS on UART3
|
/linux/Documentation/admin-guide/blockdev/ |
H A D | ramdisk.rst | 26 The RAM disk supports up to 16 RAM disks by default, and can be reconfigured
|
/linux/drivers/gpu/drm/i915/gt/ |
H A D | intel_gt_clock_utils.c | 63 * Note that on gen11+, the clock frequency may be reconfigured. in gen11_read_clock_frequency()
|
/linux/arch/powerpc/kernel/ |
H A D | pci-hotplug.c | 172 /* Scan bridges that need to be reconfigured */ in pci_hp_add_devices()
|
/linux/drivers/net/ethernet/freescale/dpaa2/ |
H A D | dpmac.c | 221 * @protocol: New protocol for the DPMAC to be reconfigured in.
|
/linux/Documentation/userspace-api/media/drivers/ |
H A D | omap3isp-uapi.rst | 141 other subdevs. They can be enabled, disable and reconfigured when the pipeline
|
/linux/Documentation/networking/ |
H A D | netdev-features.rst | 91 Hardware should be reconfigured to match passed feature set. The set
|
/linux/drivers/net/dsa/sja1105/ |
H A D | sja1105_dynamic_config.c | 45 * that can be reconfigured is small), then the switch repurposes some of the 85 * reconfigured through the dynamic interface. If a static 86 * table can be reconfigured at all dynamically, this 613 /* MAC configuration table entries which can't be reconfigured: in sja1105et_mac_config_entry_packing()
|
/linux/Documentation/userspace-api/media/v4l/ |
H A D | vidioc-g-parm.rst | 39 output device will be reconfigured to support the requested frame
|