| /freebsd/crypto/openssh/regress/ |
| H A D | reconfigure.sh | 1 # $OpenBSD: reconfigure.sh,v 1.9 2021/06/10 09:46:28 dtucker Exp $
4 tid="simple connect after reconfigure"
23 fail "ssh connect with failed before reconfigure"
42 fail "ssh connect with failed after reconfigure"
45 trace "reconfigure with active clients"
64 fail "ssh connect with failed after reconfigure"
|
| H A D | README.regress | 107 reconfigure.sh: simple connect after reconfigure
|
| /freebsd/sys/contrib/libsodium/m4/ |
| H A D | ax_valgrind_check.m4 | 93 … AC_MSG_ERROR([Could not find valgrind; either install it or reconfigure with --disable-valgrind])
130 AC_MSG_ERROR([Valgrind does not support ]vgtool[; reconfigure with --disable-valgrind-]vgtool)
193 @echo "Need to use GNU make and reconfigure with --enable-valgrind"
216 @echo "Need to reconfigure with --enable-valgrind-$(1)"
218 @echo "Need to reconfigure with --enable-valgrind"
236 @echo "Need to use GNU make and reconfigure with --enable-valgrind"'
|
| /freebsd/sys/dev/sfxge/common/ |
| H A D | siena_sram.c | 94 /* Reconfigure into HALF buffer table mode */ in siena_sram_test()
162 * We don't need to reconfigure SRAM again because the API in siena_sram_test()
|
| /freebsd/sys/netpfil/ipfw/ |
| H A D | dummynet.txt | 282 DN_CMD_CONFIG is followed by objects to add/reconfigure. In general,
389 function with the RECONFIGURE flag active.
503 this packet arrives, the reconfigure() function is called because the
779 - int (*config_scheduler)(char *command, void *sch, int reconfigure);
780 Configure a scheduler, or reconfigure if 'reconfigure' == 1.
821 - int (*create_alg_fs)(char *command, struct gen *g, int reconfigure);
826 size allocated by the system. If the reconfigure flag is set, it means
|
| /freebsd/contrib/byacc/test/yacc/ |
| H A D | big_b.error | 1 YACC: w - -B flag unsupported, reconfigure with --enable-btyacc
|
| H A D | big_l.error | 1 YACC: w - -L flag unsupported, reconfigure with --enable-btyacc
|
| /freebsd/sys/kern/ |
| H A D | kern_clocksource.c | 437 * Reconfigure specified per-CPU timer on other CPU. Called from IPI handler.
472 * Reconfigure specified timer.
473 * For per-CPU timers use IPI to make other CPUs to reconfigure.
539 /* Set reconfigure flags for other CPUs. */
545 /* Broadcast reconfigure IPI. */
|
| /freebsd/sys/contrib/device-tree/Bindings/power/reset/ |
| H A D | gpio-poweroff.yaml | 34 Initially configure the GPIO line as an input. Only reconfigure
|
| H A D | gpio-poweroff.txt | 26 - input : Initially configure the GPIO line as an input. Only reconfigure
|
| /freebsd/contrib/unbound/doc/ |
| H A D | README.DNS64 | 45 standard 64:FF9B::/96 prefix. You can reconfigure it with:
|
| /freebsd/contrib/tcpdump/ |
| H A D | print-dhcp6.c | 91 { DH6_RECONFIGURE, "reconfigure" },
216 { DH6OPT_RECONF_MSG, "reconfigure-message" },
217 { DH6OPT_RECONF_ACCEPT, "reconfigure-accept" },
464 ND_PRINT(" proto: reconfigure"); in dhcp6opt_print()
|
| /freebsd/crypto/openssl/ |
| H A D | configdata.pm.in | 75 # If run directly, we can give some answers, and even reconfigure
226 'reconfigure|reconf|r' => \$reconf,
475 =item B<--reconfigure> | B<--reconf> | B<-r>
|
| /freebsd/sys/contrib/device-tree/Bindings/serial/ |
| H A D | mtk-uart.txt | 35 one must create an addtional pinctrl to reconfigure Rx pin to normal
|
| /freebsd/contrib/dma/ |
| H A D | dma.conf | 6 # Please use dpkg-reconfigure dma to change this value.
|
| /freebsd/usr.sbin/wpa/hostapd/ |
| H A D | hostapd.8 | 85 .Dq Li "hostapd_cli reconfigure" .
|
| /freebsd/sys/contrib/openzfs/tests/zfs-tests/tests/functional/replacement/ |
| H A D | scrub_cancel.ksh | 69 # Healing resilvers abort the dsl_scan and reconfigure it for
|
| H A D | attach_multiple.ksh | 60 # Resilvers abort the dsl_scan and reconfigure it for resilvering.
|
| /freebsd/share/man/man4/ |
| H A D | qat.4 | 104 Following variables may be used to reconfigure the QAT device.\&
|
| H A D | ukbd.4 | 59 Make sure you reconfigure your kernel with the following option in the kernel
|
| H A D | hkbd.4 | 63 Make sure you reconfigure your kernel with the following option in the kernel
|
| /freebsd/usr.sbin/wpa/wpa_supplicant/ |
| H A D | wpa_supplicant.8 | 100 .Dq Li "wpa_cli reconfigure" .
|
| /freebsd/sys/contrib/device-tree/Bindings/pinctrl/ |
| H A D | pinctrl-bindings.txt | 15 need to reconfigure pins at run-time, for example to tri-state pins when the
|
| /freebsd/libexec/rbootd/ |
| H A D | rbootd.8 | 124 Drop all active connections and reconfigure.
|
| /freebsd/crypto/openssl/doc/man3/ |
| H A D | OPENSSL_ia32cap.pod | 76 effect. Alternatively you can reconfigure the toolkit with no-sse2
|