Home
last modified time | relevance | path

Searched +full:precharge +full:- +full:current +full:- +full:microamp (Results 1 – 14 of 14) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/power/supply/
H A Dbattery.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Sebastian Reichel <sre@kernel.org>
14 In smart batteries, these are typically stored in non-volatile memory
16 no appropriate non-volatile memory, or it is unprogrammed/incorrect.
27 Batteries must be referenced by chargers and/or fuel-gauges using a phandle.
28 The phandle's property should be named "monitored-battery".
32 const: simple-battery
34 device-chemistry:
[all …]
H A Dbq24190.txt1 TI BQ24190 Li-Ion Battery Charger
4 - compatible: contains one of the following:
9 - reg: integer, I2C address of the charger.
10 - interrupts[-extended]: configuration for charger INT pin.
13 - monitored-battery: phandle of battery characteristics devicetree node
15 + precharge-current-microamp: maximum charge current during precharge
17 + charge-term-current-microamp: a charge cycle terminates when the
18 battery voltage is above recharge threshold, and the current is below
21 - ti,system-minimum-microvolt: when power is connected and the battery is below
25 - usb-otg-vbus:
[all …]
H A Dbq24190.yaml1 # SPDX-License-Identifier: GPL-2.0
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
8 title: TI BQ2419x Li-Ion Battery Charger
11 - Sebastian Reichel <sre@kernel.org>
14 -
[all...]
H A Drichtek,rt5033-charger.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/power/supply/richtek,rt5033-charger.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jakob Hauser <jahau@rocketmail.com>
14 under sub-node named "charger" using the following format.
18 const: richtek,rt5033-charger
20 monitored-battery:
26 precharge-current-microamp:
27 Current of pre-charge mode. The pre-charge current levels are 350 mA
[all …]
H A Drohm,bd99954.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Matti Vaittinen <mazziesaccount@gmail.com>
11 - Markus Laine <markus.laine@fi.rohmeurope.com>
12 - Mikko Mutanen <mikko.mutanen@fi.rohmeurope.com>
15 The ROHM BD99954 is a Battery Management LSI for 1-4 cell Lithium-Ion
16 secondary battery intended to be used in space-constraint equipment such
18 provides a Dual-source Battery Charger, two port BC1.2 detection and a
21 $ref: power-supply.yaml#
[all …]
H A Dbq25980.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Andrew Davis <afd@ti.com>
15 for use in high-power density portable electronics. These inductorless
20 - $ref: power-supply.yaml#
25 - ti,bq25980
26 - ti,bq25975
27 - ti,bq25960
32 ti,watchdog-timeout-ms:
[all …]
H A Dbq2515x.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
8 title: TI bq2515x 500-mA Linear charger family
11 - Andrew Davis <afd@ti.com>
17 push-button controller.
26 - ti,bq25150
27 - ti,bq25155
33 ac-detect-gpios:
39 reset-gpios:
[all …]
H A Dbq256xx.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
4 ---
6 $schema: http://devicetree.org/meta-schema
[all...]
/freebsd/sys/contrib/device-tree/Bindings/mfd/
H A Drichtek,rt5033.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jakob Hauser <jahau@rocketmail.com>
14 flash LED current source, LDO and synchronous Buck converter for portable
30 The regulators of RT5033 have to be instantiated under a sub-node named
44 $ref: /schemas/power/supply/richtek,rt5033-charger.yaml#
47 - compatible
48 - reg
49 - interrupts
[all …]
/freebsd/sys/contrib/device-tree/src/arm64/qcom/
H A Dmsm8939-samsung-a7.dts1 // SPDX-License-Identifier: GPL-2.0-only
3 /dts-v1/;
5 #include "msm8939-pm8916.dtsi"
6 #include "msm8916-modem-qdsp6.dtsi"
8 #include <dt-bindings/gpio/gpio.h>
9 #include <dt-bindings/input/input.h>
10 #include <dt-bindings/interrupt-controller/irq.h>
11 #include <dt-bindings/sound/apq8016-lpass.h>
16 chassis-type = "handset";
25 stdout-path = "serial0";
[all …]
H A Dmsm8916-samsung-fortuna-common.dtsi1 // SPDX-License-Identifier: GPL-2.0-only
3 #include "msm8916-pm8916.dtsi"
4 #include "msm8916-modem-qdsp6.dtsi"
6 #include <dt-bindings/gpio/gpio.h>
7 #include <dt-bindings/input/input.h>
8 #include <dt-bindings/interrupt-controller/irq.h>
9 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
19 stdout-path = "serial0";
22 reserved-memory {
24 tz-apps@85a00000 {
[all …]
H A Dmsm8916-samsung-a2015-common.dtsi1 // SPDX-License-Identifier: GPL-2.0-only
3 #include "msm8916-pm8916.dtsi"
4 #include "msm8916-modem-qdsp6.dtsi"
6 #include <dt-bindings/gpio/gpio.h>
7 #include <dt-bindings/input/input.h>
8 #include <dt-bindings/interrupt-controller/irq.h>
9 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
10 #include <dt-bindings/sound/apq8016-lpass.h>
20 stdout-path = "serial0";
23 reserved-memory {
[all …]
/freebsd/sys/contrib/device-tree/src/arm/samsung/
H A Dexynos4412-p4note.dtsi1 // SPDX-License-Identifier: GPL-2.0
4 * Based on exynos4412-midas.dtsi.
10 /dts-v1/;
12 #include "exynos4412-ppmu-common.dtsi"
14 #include <dt-bindings/clock/maxim,max77686.h>
15 #include <dt-bindings/gpio/gpio.h>
16 #include <dt-bindings/input/linux-event-codes.h>
17 #include <dt-bindings/interrupt-controller/irq.h>
18 #include <dt-bindings/power/summit,smb347-charger.h>
19 #include "exynos-pinctrl.h"
[all …]
/freebsd/sys/contrib/device-tree/src/arm64/freescale/
H A Dimx8mq-librem5.dtsi1 // SPDX-License-Identifier: GPL-2.0+
3 * Copyright 2018-2020 Purism SPC
6 /dts-v1/;
8 #include "dt-bindings/input/input.h"
9 #include <dt-bindings/interrupt-controller/irq.h>
10 #include <dt-bindings/leds/common.h>
11 #include "dt-bindings/pwm/pwm.h"
12 #include "dt-bindings/usb/pd.h"
18 chassis-type = "handset";
20 backlight_dsi: backlight-dsi {
[all …]