| /linux/include/linux/platform_data/ |
| H A D | gpmc-omap.h | 136 #define GPMC_MUX_AAD 1 /* Addr-Addr-Data multiplex */
137 #define GPMC_MUX_AD 2 /* Addr-Data multiplex */
157 u32 mux_add_data; /* multiplex address & data */
|
| /linux/include/linux/can/platform/ |
| H A D | cc770.h | 7 #define CPUIF_MUX 0x04 /* Multiplex */
|
| /linux/Documentation/devicetree/bindings/interrupt-controller/ |
| H A D | fsl,intmux.yaml | 24 Should contain the parent interrupt lines (up to 8) used to multiplex
|
| /linux/arch/riscv/kernel/ |
| H A D | sbi-ipi.c | 3 * Multiplex several IPIs over a single HW IPI.
|
| /linux/Documentation/devicetree/bindings/sound/ |
| H A D | nvidia,tegra210-amx.yaml | 10 The Audio Multiplexer (AMX) block can multiplex up to four input streams
|
| /linux/Documentation/userspace-api/media/v4l/ |
| H A D | vidioc-enumstd.rst | 339 multiplex. (NICAM system)
344 DQPSK modulated with a 728 kbit/s sound and data multiplex able to
|
| /linux/Documentation/devicetree/bindings/memory-controllers/ |
| H A D | intel,ixp4xx-expansion-peripheral-props.yaml | 60 description: Multiplex address and data on the data bus.
|
| H A D | ti,gpmc-child.yaml | 172 In address-data multiplex mode, specifies
|
| H A D | st,stm32mp25-omm.yaml | 15 function map) and multiplex of single/dual/quad/octal SPI interfaces over
|
| /linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | renesas,rzn1-pinctrl.yaml | 69 These identifiers collapse the IO Multiplex Configuration Level 1
|
| H A D | st,stm32-pinctrl.yaml | 16 also provides ability to multiplex and configure the output of various
|
| /linux/arch/arm/mach-davinci/ |
| H A D | mux.h | 3 * Pin-multiplex helper macros for TI DaVinci family devices
|
| /linux/kernel/irq/ |
| H A D | ipi-mux.c | 3 * Multiplex several virtual IPIs over a single HW IPI.
|
| /linux/arch/sh/include/mach-common/mach/ |
| H A D | sh2007.h | 52 /* Multiplex (0-1:0,1) */
|
| /linux/drivers/staging/fbtft/ |
| H A D | fb_sh1106.c | 43 /* Set Multiplex Ratio */ in init_display()
|
| H A D | fb_ssd1305.c | 53 /* Set Multiplex Ratio */ in init_display()
|
| H A D | fb_ssd1306.c | 52 /* Set Multiplex Ratio */ in init_display()
|
| H A D | fb_ssd1331.c | 41 write_reg(par, 0xa8, 0x3f); /* Set multiplex */ in init_display()
|
| /linux/Documentation/driver-api/ |
| H A D | pin-control.rst | 23 can control PINs. It may be able to multiplex, bias, set load capacitance,
774 multiplex
778 whether the pin is used for GPIO or not. If you multiplex a GPIO onto a
804 multiplex
811 possible that the GPIO, pin config and pin multiplex registers are placed into
|
| /linux/sound/soc/tegra/ |
| H A D | Kconfig | 156 Config to enable the Audio Multiplexer (AMX) which can multiplex
|
| /linux/drivers/gpu/drm/msm/disp/dpu1/ |
| H A D | dpu_hw_sspp.h | 170 * @multirect_mode: parallel or time multiplex multirect mode
|
| /linux/drivers/input/serio/ |
| H A D | i8042.c | 675 static int i8042_set_mux_mode(bool multiplex, unsigned char *mux_version) in i8042_set_mux_mode() argument
693 param = val = multiplex ? 0x56 : 0xf6; in i8042_set_mux_mode()
696 param = val = multiplex ? 0xa4 : 0xa5; in i8042_set_mux_mode()
|
| /linux/drivers/irqchip/ |
| H A D | irq-imx-intmux.c | 213 dev_err(&pdev->dev, "supports up to %d multiplex channels\n", in imx_intmux_probe()
|
| /linux/Documentation/networking/ |
| H A D | gtp.rst | 185 The TEID in the GTP-U header is used to de-multiplex traffic
|
| H A D | can.rst | 939 Broadcast Manager Multiplex Message Receive Filter
942 To filter for content changes in multiplex message sequences an array of more
948 Up to 257 CAN frames (multiplex filter bit mask CAN frame plus 256 CAN
996 When using CAN FD frames for multiplex filtering the MUX mask is still
|