Searched full:modesel (Results 1 – 3 of 3) sorted by relevance
| /freebsd/sys/contrib/device-tree/Bindings/gpio/ |
| H A D | gpio-max3191x.txt | 18 - maxim,modesel-gpios: GPIO pins to configure modesel of each chip.
30 - maxim,modesel-8bit: Boolean whether the modesel pin of the chips is
31 pulled high (8-bit mode). Use this if the modesel pin
32 is hardwired and consequently "maxim,modesel-gpios"
34 "maxim,modesel-gpios" is given, the driver assumes
35 that modesel is pulled low (16-bit mode).
53 maxim,modesel-gpios = <&gpio2 23>;
|
| H A D | maxim,max31910.yaml | 34 maxim,modesel-gpios:
36 GPIO pins to configure modesel of each chip. The number of GPIOs must
55 maxim,modesel-8bit:
57 Boolean whether the modesel pin of the chips is pulled high (8-bit mode).
58 Use this if the modesel pin is hardwired and consequently
59 "maxim,modesel-gpios" cannot be specified. By default if neither this nor
60 "maxim,modesel-gpios" is given, the driver assumes that modesel is pulled
97 maxim,modesel-gpios = <&gpio2 23>;
|
| /freebsd/sys/dev/qlnx/qlnxe/ |
| H A D | reg_addr.h | 65982 …, typically after a change of selection (either mode or set) When either modesel and setsel change…
|