| /linux/drivers/net/ethernet/agere/ |
| H A D | et131x.h | 88 * located at address 0x0010
147 /* Loopback reg located at address 0x0034
153 * Located at address 0x0000
184 * located at address 0x1004
189 * located at address 0x1008
194 * map. Located at address 0x100C
237 * Located at address 0x1000
272 * Located at address 0x2000
301 * located at address 0x2004
306 * located at address 0x2008
[all …]
|
| /linux/drivers/net/ethernet/intel/ |
| H A D | Kconfig | 33 can be located at:
51 to the Adapter & Driver ID Guide that can be located at:
71 can be located at:
99 to the Adapter & Driver ID Guide that can be located at:
135 Driver ID Guide that can be located at:
157 to the Adapter & Driver ID Guide that can be located at:
209 adapter, go to the Adapter & Driver ID Guide that can be located at:
240 to the Adapter & Driver ID Guide that can be located at:
278 & Driver ID Guide that can be located at:
309 to the Adapter & Driver ID Guide that can be located at:
[all …]
|
| /linux/Documentation/devicetree/bindings/watchdog/ |
| H A D | mpc8xxx-wdt.txt | 17 On the 83xx, it is located at offset 0x910
18 On the 86xx, it is located at offset 0xe0094
19 On the 8xx, it is located at offset 0x288
|
| /linux/Documentation/devicetree/bindings/net/ |
| H A D | marvell-orion-net.txt | 43 - marvell,tx-sram-addr: address of transmit descriptor buffer located in SRAM.
44 - marvell,tx-sram-size: size of transmit descriptor buffer located in SRAM.
46 - marvell,rx-sram-addr: address of receive descriptor buffer located in SRAM.
47 - marvell,rx-sram-size: size of receive descriptor buffer located in SRAM.
|
| /linux/Documentation/hwmon/ |
| H A D | smsc47b397.rst | 40 pair is located at the HWM Base Address + 0 and the HWM Base Address + 1. The
46 The temperature information is located in the following registers:
70 The fan speed information is located in the following registers:
121 In configuration mode, the INDEX PORT is located at the CONFIG PORT address and
146 The following is an example of how to read the SIO Device ID located at 0x20:
173 The following is an example of how to read the HWM Base Address located in
|
| /linux/drivers/perf/hisilicon/ |
| H A D | hisi_uncore_pmu.h | 89 * is located.
90 * @sccl_id: ID of the SCCL on which the PMU locate is located.
91 * @sicl_id: ID of the SICL on which the PMU locate is located.
93 * @ccl_id: ID of the CCL (CPU cluster) on which the PMU is located.
99 * The ID will be -1 if the PMU isn't located on a certain topology.
|
| /linux/Documentation/admin-guide/ |
| H A D | binderfs.rst | 8 located in a new binderfs instance are independent of binder devices located in
62 binder device located under /dev/binderfs with the chosen name.
80 features supported by the binder driver can be located under
|
| /linux/drivers/net/dsa/mv88e6xxx/ |
| H A D | global1_atu.c | 144 /* ATU DBNum[7:4] are located in ATU Control 15:12 */ in mv88e6xxx_g1_atu_op()
156 /* ATU DBNum[5:4] are located in ATU Operation 9:8 */ in mv88e6xxx_g1_atu_op()
160 /* ATU DBNum[3:0] are located in ATU Operation 3:0 */ in mv88e6xxx_g1_atu_op()
192 /* ATU DBNum[7:4] are located in ATU Control 15:12 */ in mv88e6xxx_g1_atu_fid_read()
200 /* ATU DBNum[5:4] are located in ATU Operation 9:8 */ in mv88e6xxx_g1_atu_fid_read()
204 /* ATU DBNum[3:0] are located in ATU Operation 3:0 */ in mv88e6xxx_g1_atu_fid_read()
|
| /linux/Documentation/userspace-api/media/v4l/ |
| H A D | ext-ctrls-rf-tuner.rst | 68 signal path. It is located very close to tuner antenna input. Used
76 located inside mixer block, where RF signal is down-converted by the
82 located on output of RF tuner. It controls signal level of
|
| /linux/drivers/dma/dw/ |
| H A D | Kconfig | 24 Support the Renesas RZ/N1 DMAMUX which is located in front of
25 the Synopsys DesignWare AHB DMA controller located on Renesas
|
| /linux/Documentation/devicetree/bindings/mtd/partitions/ |
| H A D | u-boot.yaml | 11 located on some kind of flash device.
14 located in a (usually standalone) block of data.
|
| /linux/Documentation/devicetree/bindings/soc/fsl/ |
| H A D | fsl,bman.yaml | 33 The BMan revision information is located in the BMAN_IP_REV_1/2
34 registers which are located at offsets 0xbf8 and 0xbfc
|
| H A D | fsl,qman.yaml | 34 The QMan revision information is located in the QMAN_IP_REV_1/2
35 registers which are located at offsets 0xbf8 and 0xbfc
|
| /linux/fs/crypto/ |
| H A D | crypto.c | 159 * In the bounce page, the ciphertext data will be located at the same offset at
160 * which the plaintext data was located in the source page. Any other parts of
221 * Encrypt a possibly-compressed filesystem block that is located in an
248 * be located in a pagecache folio that is still locked and not yet uptodate.
295 * Decrypt a possibly-compressed filesystem block that is located in an
|
| /linux/Documentation/firmware-guide/acpi/ |
| H A D | aml-debugger.rst | 30 The resultant userspace tool binary is then located at::
55 The detailed debugger commands reference is located in Chapter 12 "ACPICA
|
| /linux/drivers/scsi/qedf/ |
| H A D | qedf_hsi.h | 297 __le16 ox_id /* OX_ID that is located in the FCP_RSP FC header */;
298 __le16 rx_id /* RX_ID that is located in the FCP_RSP FC header */;
300 /* PARAM that is located in the FCP_RSP FC header */
|
| /linux/drivers/gpu/drm/xe/ |
| H A D | xe_gsc_submit.c | 105 * @offset_in: offset within the iosys at which the input buffer is located
107 * @offset_out: offset within the iosys at which the output buffer is located
131 * @offset: offset within the iosys at which the output buffer is located
|
| /linux/Documentation/power/ |
| H A D | swsusp-and-swap-files.rst | 22 header is located. For convenience, this offset is expressed in <PAGE_SIZE>
42 where <swap_file_partition> is the partition on which the swap file is located
|
| /linux/drivers/pcmcia/ |
| H A D | cardbus.c | 61 * @s: the pcmcia_socket where the CardBus device is located
100 * @s: the pcmcia_socket where the CardBus device was located
|
| /linux/Documentation/scsi/ |
| H A D | cxgb3i.rst | 56 * in the case of recompiling the kernel, the cxgb3i selection is located at::
63 2. Create an interface file located under /etc/iscsi/ifaces/ for the new
|
| /linux/Documentation/devicetree/bindings/cpufreq/ |
| H A D | cpufreq-st.txt | 14 Located in CPU's node:
36 Located in CPU's node:
|
| /linux/Documentation/devicetree/bindings/power/ |
| H A D | fsl,imx-gpcv2.yaml | 77 power-up sequencing to ensure reset propagation into devices located
91 located inside the power domain, which need to be held in reset
|
| /linux/drivers/power/supply/ |
| H A D | ds2781_battery.c | 170 * The voltage value is located in 10 bits across the voltage MSB in ds2781_get_voltage()
199 * The temperature value is located in 10 bits across the temperature in ds2781_get_temperature()
244 * The current value is located in 16 bits across the current MSB in ds2781_get_current()
282 * The ACR value is located in 16 bits across the ACR MSB and in ds2781_get_accumulated_current()
343 * The RAAC value is located in 16 bits across the RAAC MSB and in ds2781_get_charge_now()
|
| H A D | ds2780_battery.c | 162 * The voltage value is located in 10 bits across the voltage MSB in ds2780_get_voltage()
190 * The temperature value is located in 10 bits across the temperature in ds2780_get_temperature()
243 * The current value is located in 16 bits across the current MSB in ds2780_get_current()
281 * The ACR value is located in 16 bits across the ACR MSB and in ds2780_get_accumulated_current()
341 * The RAAC value is located in 16 bits across the RAAC MSB and in ds2780_get_charge_now()
|
| /linux/net/dccp/ |
| H A D | feat.h | |