Home
last modified time | relevance | path

Searched +full:lane +full:- +full:polarities (Results 1 – 12 of 12) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/media/
H A Dvideo-interfaces.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/media/video-interface
[all...]
H A Dti,omap3isp.txt4 The DT definitions can be found in include/dt-bindings/media/omap3-isp.h.
9 compatible : must contain "ti,omap3-isp"
17 syscon : the phandle and register offset to the Complex I/O or CSI-PHY
19 ti,phy-type : 0 -- OMAP3ISP_PHY_TYPE_COMPLEX_IO (e.g. 3430)
20 1 -- OMAP3ISP_PHY_TYPE_CSIPHY (e.g. 3630)
21 #clock-cells : Must be 1 --- the ISP provides two external clocks,
24 clock bindings in ../clock/clock-bindings.txt.
27 ---------------------
30 video-interfaces.txt in the same directory.
33 0 - parallel (CCDC)
[all …]
/freebsd/sys/contrib/device-tree/Bindings/media/i2c/
H A Dst,st-mipid02.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/media/i2c/st,st-mipid0
[all...]
H A Dst,st-mipid02.txt1 STMicroelectronics MIPID02 CSI-2 to PARALLEL bridge
3 MIPID02 has two CSI-2 input ports, only one of those ports can be active at a
4 time. Active port input stream will be de-serialized and its content outputted
6 CSI-2 first input port is a dual lane 800Mbps per lane whereas CSI-2 second
7 input port is a single lane 800Mbps. Both ports support clock and data lane
8 polarity swap. First port also supports data lane swap.
11 YUV420 8-bit, YUV422 8-bit and YUV420 10-bit.
14 - compatible: shall be "st,st-mipid02"
15 - clocks: reference to the xclk input clock.
16 - clock-names: shall be "xclk".
[all …]
/freebsd/sys/contrib/device-tree/Bindings/display/bridge/
H A Dti,sn65dsi86.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Sandeep Panda <spanda@codeaurora.org>
23 enable-gpios:
27 suspend-gpios:
31 no-hpd:
37 vccio-supply:
40 vpll-supply:
43 vcca-supply:
[all …]
H A Dti,sn65dsi86.txt2 --------------------------------
8 - compatible: Must be "ti,sn65dsi86"
9 - reg: i2c address of the chip, 0x2d as per datasheet
10 - enable-gpios: gpio specification for bridge_en pin (active high)
12 - vccio-supply: A 1.8V supply that powers up the digital IOs.
13 - vpll-supply: A 1.8V supply that powers up the displayport PLL.
14 - vcca-supply: A 1.2V supply that powers up the analog circuits.
15 - vcc-supply: A 1.2V supply that powers up the digital core.
18 - interrupts-extended: Specifier for the SN65DSI86 interrupt line.
20 - gpio-controller: Marks the device has a GPIO controller.
[all …]
H A Dsamsung,mipi-dsim.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/display/bridge/samsung,mipi-dsim.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Inki Dae <inki.dae@samsung.com>
11 - Jagan Teki <jagan@amarulasolutions.com>
12 - Marek Szyprowski <m.szyprowski@samsung.com>
21 - enum:
22 - samsung,exynos3250-mipi-dsi
23 - samsung,exynos4210-mipi-dsi
[all …]
/freebsd/sys/contrib/device-tree/src/arm64/qcom/
H A Dsc7180-trogdor-lazor-r0.dts1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
8 /dts-v1/;
10 #include "sc7180-trogdor.dtsi"
11 #include "sc7180-trogdor-ti-sn65dsi86.dtsi"
12 #include "sc7180-trogdor-lazor.dtsi"
16 compatible = "google,lazor-rev0", "qcom,sc7180";
21 * Lane 0 was incorrectly mapped on the cable, but we've now decided
22 * that the cable is canon and in -rev1+ we'll make a board change
25 lane-polarities = <1 0>;
29 vdd-supply = <&pp3300_l7c>;
[all …]
/freebsd/sys/contrib/device-tree/src/arm64/renesas/
H A Dr8a779a0-falcon-csi-dsi.dtsi1 // SPDX-License-Identifier: GPL-2.0
3 * Device Tree Source for the Falcon CSI/DSI sub-board
8 #include <dt-bindings/media/video-interfaces.h>
14 #address-cells = <1>;
15 #size-cells = <0>;
21 clock-lanes = <0>;
22 data-lanes = <1 2 3 4>;
23 remote-endpoint = <&max96712_out0>;
33 #address-cells = <1>;
34 #size-cells = <0>;
[all …]
/freebsd/sys/contrib/device-tree/src/arm/ti/omap/
H A Domap3-n9.dts1 // SPDX-License-Identifier: GPL-2.0-only
3 * omap3-n9.dts - Device Tree file for Nokia N9
8 /dts-v1/;
10 #include "omap3-n950-n9.dtsi"
11 #include <dt-bindings/input/input.h>
15 compatible = "nokia,omap3-n9", "ti,omap3630", "ti,omap3";
23 vana-supply = <&vaux3>;
25 clock-frequency = <9600000>;
26 flash-leds = <&as3645a_flash &as3645a_indicator>;
29 link-frequencies = /bits/ 64 <199200000 210000000 499200000>;
[all …]
H A Domap3-n950.dts1 // SPDX-License-Identifier: GPL-2.0-only
3 * omap3-n950.dts - Device Tree file for Nokia N950
8 /dts-v1/;
10 #include "omap3-n950-n9.dtsi"
11 #include <dt-bindings/input/input.h>
15 compatible = "nokia,omap3-n950", "ti,omap3630", "ti,omap3";
18 compatible = "gpio-keys";
23 linux,input-type = <EV_SW>;
25 wakeup-source;
26 pinctrl-names = "default";
[all …]
/freebsd/sys/contrib/device-tree/src/arm64/freescale/
H A Dimx8mm-phg.dts1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 /dts-v1/;
8 #include "imx8mm-tqma8mqml.dtsi"
12 compatible = "cloos,imx8mm-phg", "tq,imx8mm-tqma8mqml", "fsl,imx8mm";
20 stdout-path = &uart2;
24 compatible = "gpio-beeper";
25 pinctrl-
[all...]