Home
last modified time | relevance | path

Searched +full:ixp4xx +full:- +full:gpio (Results 1 – 16 of 16) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/gpio/
H A Dintel,ixp4xx-gpio.txt1 Intel IXP4xx XScale Networking Processors GPIO
3 This GPIO controller is found in the Intel IXP4xx processors.
4 It supports 16 GPIO lines.
6 The interrupt portions of the GPIO controller is hierarchical:
7 the synchronous edge detector is part of the GPIO block, but the
9 main IXP4xx interrupt controller which has a 1:1 mapping for
10 the first 12 GPIO lines to 12 system interrupts.
12 The remaining 4 GPIO lines can not be used for receiving
15 The interrupt parent of this GPIO controller must be the
16 IXP4xx interrupt controller.
[all …]
/freebsd/sys/contrib/device-tree/src/arm/intel/ixp/
H A Dintel-ixp43x-gateworks-gw2358.dts1 // SPDX-License-Identifier: ISC
3 * Device Tree file for Gateworks IXP43x-based Cambria GW2358
6 /dts-v1/;
8 #include "intel-ixp43x.dtsi"
13 #address-cells = <1>;
14 #size-cells = <1>;
24 stdout-path = "uart0:115200n8";
32 compatible = "gpio-leds";
33 led-user {
36 default-state = "on";
[all …]
H A Dintel-ixp42x-arcom-vulcan.dts1 // SPDX-License-Identifier: ISC
8 /dts-v1/;
10 #include "intel-ixp42x.dtsi"
11 #include <dt-bindings/input/input.h>
16 #address-cells = <1>;
17 #size-cells = <1>;
27 stdout-path = "uart0:115200n8";
35 compatible = "w1-gpio";
42 compatible = "intel,ixp4xx-flash", "cfi-flash";
43 bank-width = <2>;
[all …]
H A Dintel-ixp4xx.dtsi1 // SPDX-License-Identifier: ISC
6 #include <dt-bindings/interrupt-controller/irq.h>
7 #include <dt-bindings/gpio/gpio.h>
11 #address-cells = <1>;
12 #size-cells = <1>;
14 compatible = "simple-bus";
15 interrupt-parent = <&intcon>;
18 * The IXP4xx expansion bus is a set of up to 7 each up to 16MB
22 /* compatible and reg filled in by per-soc device tree */
23 native-endian;
[all …]
H A Dintel-ixp42x-gateworks-gw2348.dts1 // SPDX-License-Identifier: ISC
7 /dts-v1/;
9 #include "intel-ixp42x.dtsi"
10 #include <dt-bindings/input/input.h>
15 #address-cells = <1>;
16 #size-cells = <1>;
25 stdout-path = "uart0:115200n8";
33 compatible = "gpio-leds";
34 led-user {
37 default-state = "on";
[all …]
H A Dintel-ixp4xx-reference-design.dtsi1 // SPDX-License-Identifier: ISC
5 * set-up for IXDP425, IXCDP1100, KIXRP435 and IXDP465.
20 stdout-path = "uart0:115200n8";
28 compatible = "i2c-gpio";
29 sda-gpios = <&gpio0 7 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
30 scl-gpios = <&gpio0 6 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
31 #address-cells = <1>;
32 #size-cells = <0>;
36 * Philips PCF8582C-2T/03 512byte I2C EEPROM
43 read-only;
[all …]
H A Dintel-ixp42x-goramo-multilink.dts1 // SPDX-License-Identifier: ISC
5 * - MultiLink Basic (a box)
6 * - MultiLink Max (19" rack mount)
9 * This is one of the few devices supporting the IXP4xx High-Speed Serial
14 /dts-v1/;
16 #include "intel-ixp42x.dtsi"
17 #include <dt-bindings/input/input.h>
21 compatible = "goramo,multilink-route
[all...]
H A Dintel-ixp42x-linksys-nslu2.dts1 // SPDX-License-Identifier: ISC
6 /dts-v1/;
8 #include "intel-ixp42x.dtsi"
9 #include <dt-bindings/input/input.h>
14 #address-cells = <1>;
15 #size-cells = <1>;
25 stdout-path = "uart0:115200n8";
33 compatible = "gpio-leds";
34 led-status {
37 default-state = "on";
[all …]
H A Dintel-ixp42x-linksys-wrv54g.dts1 // SPDX-License-Identifier: ISC
9 /dts-v1/;
11 #include "intel-ixp42x.dtsi"
12 #include <dt-bindings/input/input.h>
17 #address-cells = <1>;
18 #size-cells = <1>;
28 stdout-path = "uart1:115200n8";
37 /* There is an unpopulated LED slot (3) connected to GPIO 8 */
39 compatible = "gpio
[all...]
H A Dintel-ixp42x-freecom-fsg-3.dts1 // SPDX-License-Identifier: ISC
3 * Device Tree file for the Freecom FSG-3 router.
8 /dts-v1/;
10 #include "intel-ixp42x.dtsi"
11 #include <dt-bindings/input/input.h>
14 model = "Freecom FSG-3";
15 compatible = "freecom,fsg-3", "intel,ixp42x";
16 #address-cells = <1>;
17 #size-cell
[all...]
H A Dintel-ixp42x-dlink-dsm-g600.dts1 // SPDX-License-Identifier: ISC
3 * Device Tree file for D-Link DSM-G600 revision A based on IXP420
11 /dts-v1/;
13 #include "intel-ixp42x.dtsi"
14 #include <dt-bindings/input/input.h>
17 model = "D-Link DSM-G600 rev A";
18 compatible = "dlink,dsm-g60
[all...]
H A Dintel-ixp42x-iomega-nas100d.dts1 // SPDX-License-Identifier: ISC
6 /dts-v1/;
8 #include "intel-ixp42x.dtsi"
9 #include <dt-bindings/input/input.h>
13 compatible = "iom,nas-100d", "intel,ixp42x";
14 #address-cells = <1>;
15 #size-cells = <1>;
25 stdout-path = "uart0:115200n8";
33 compatible = "gpio
[all...]
/freebsd/sys/contrib/device-tree/Bindings/net/
H A Dintel,ixp4xx-hss.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
4 ---
5 $id: http://devicetree.org/schemas/net/intel,ixp4xx-hss.yaml#
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
8 title: Intel IXP4xx V.35 WAN High Speed Serial Link (HSS)
11 - Linus Walleij <linus.walleij@linaro.org>
14 The Intel IXP4xx HSS makes use of the IXP4xx NPE (Network
15 Processing Engine) and the IXP4xx Queue Manager to process
20 const: intel,ixp4xx-hss
26 intel,npe-handle:
[all …]
/freebsd/sys/contrib/device-tree/Bindings/firmware/
H A Dintel,ixp4xx-network-processing-engine.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
4 ---
5 $id: http://devicetree.org/schemas/firmware/intel,ixp4xx-networ
[all...]
/freebsd/sys/contrib/device-tree/Bindings/mtd/
H A Dmtd-physmap.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/mtd/mtd-physmap.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: CFI or JEDEC memory-mapped NOR flash, MTD-RAM (NVRAM...)
10 - Rob Herring <robh@kernel.org>
17 - $ref: mtd.yaml#
18 - $ref: /schemas/memory-controllers/mc-peripheral-props.yaml#
23 - items:
24 - enum:
[all …]
/freebsd/share/misc/
H A Dpci_vendors5 # Date: 2025-10-18 03:15:01
8 # the PCI ID Project at https://pci-ids.ucw.cz/.
14 # (version 2 or higher) or the 3-clause BSD License.
25 # device device_name <-- single tab
26 # subvendor subdevice subsystem_name <-- two tabs
30 # This is a relabelled RTL-8139
31 8139 AT-2500TX V3 Ethernet
41 7a09 PCI-to-PCI Bridge
51 7a19 PCI-to-PCI Bridge
57 7a29 PCI-to-PCI Bridge
[all …]