Home
last modified time | relevance | path

Searched +full:i2c +full:- +full:lt +full:- +full:enable (Results 1 – 10 of 10) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/regulator/
H A Dnxp,pca9450-regulator.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/regulator/nxp,pca9450-regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Robin Gong <yibin.gong@nxp.com>
18 https://www.nxp.com/docs/en/data-sheet/PCA9450DS.pdf
28 - nxp,pca9450a
29 - nxp,pca9450b
30 - nxp,pca9450c
31 - nxp,pca9451a
[all …]
/freebsd/sys/dev/al_eth/
H A Dal_init_eth_lm.h1 /*-
211 /* i2c bus id of the SFP for this port */
213 /* i2c addr of the SFP for this port */
222 /* the i2c bus id and addr of the retimer in case it exist */
234 * - if retimer_exist is set, the retimer will be configured based on DA len.
235 * - if link_training is set and DA detected run link training. if succeed return 0
236 * - if rx_equal is set serdes equalization will be run to configure the rx parameters.
237 * - if static_values is set, tx and rx values will be set based on static values.
244 /* enable / disable fec capabilities in AN */
249 * in case no eeprom is connected should return -ETIMEDOUT
[all …]
H A Dal_init_eth_lm.c1 /*-
73 /* 40GBASE-LR4 and 40GBASE-SR4 are optic modules */
185 /* Enable loop filter auto-adjust */
193 /* Enable FIR (6.12) */
195 /* Set Main-cursor tap sign to positive (6.12) */
197 /* Set Post-cursor tap sign to negative (6.12) */
199 /* Set Pre-cursor tap sign to negative (6.12) */
201 /* Set Main-cursor tap magnitude to 13 (6.12) */
239 if (lm_context->debug) \
257 rc = lm_context->i2c_read(lm_context->i2c_context, in al_eth_sfp_detect()
[all …]
/freebsd/sys/contrib/device-tree/Bindings/pinctrl/
H A Dmediatek,mt8188-pinctrl.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/pinctrl/mediatek,mt8188-pinctrl.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Hui Liu <hui.liu@mediatek.com>
17 const: mediatek,mt8188-pinctrl
19 gpio-controller: true
21 '#gpio-cells':
25 are defined in <dt-bindings/gpio/gpio.h>.
28 gpio-ranges:
[all …]
/freebsd/sys/contrib/device-tree/src/arm64/freescale/
H A Dimx93-kontron-osm-s.dtsi1 // SPDX-License-Identifier: GPL-2.0+ OR MIT
6 #include <dt-bindings/interrupt-controller/irq.h>
10 model = "Kontron OSM-S i.MX93";
11 compatible = "kontron,imx93-osm-s", "fsl,imx93";
24 stdout-path = &lpuart1;
27 reg_usdhc2_vcc: regulator-usdhc2-vcc {
28 compatible = "regulator-fixed";
29 pinctrl-names = "default";
30 pinctrl-0 = <&pinctrl_reg_usdhc2_vcc>;
32 enable-active-high;
[all …]
/freebsd/sys/dev/mlx4/mlx4_en/
H A Dmlx4_en_netdev.c14 * - Redistributions of source code must retain the above
18 * - Redistributions in binary form must reproduce the above
67 if_t dev = cq->dev; in mlx4_en_low_latency_recv()
69 struct mlx4_en_rx_ring *rx_ring = priv->rx_ring[cq->ring]; in mlx4_en_low_latency_recv()
72 if (!priv->port_up) in mlx4_en_low_latency_recv()
81 rx_ring->cleaned += done; in mlx4_en_low_latency_recv()
83 rx_ring->misses++; in mlx4_en_low_latency_recv()
134 struct mlx4_en_priv *priv = filter->priv; in mlx4_en_filter_work()
136 .id = mlx4_ip_proto_to_trans_rule_id(filter->ip_proto), in mlx4_en_filter_work()
139 .dst_port = filter->dst_port, in mlx4_en_filter_work()
[all …]
/freebsd/sys/dev/qlnx/qlnxe/
H A Dreg_addr.h2 * Copyright (c) 2017-2018 Cavium, Inc.
73 … 0x003818UL //Access:RW DataWidth:0x6 // Statistic mask enable Bit5 : Mask Messa…
78 …- For ending "endless completion". 0 - When receiving a completion timeout while receiving a compl…
79 … DataWidth:0x4 // 0 - TXCPL sync fifo pop underflow 1 - TXR sync fifo pop underflow 2 - TXW hea…
80 …s:R DataWidth:0x6 // 0 - RX target read and config sync fifo push overflow 1 - RX header syn…
81 …ataWidth:0x14 // 4:0 - TXCPL sync fifo pop status 9:5 - TXR sync fifo pop status 14:10 - TXW hea…
88 …ffff<<0) // Vendor ID. PCI-SIG assigned Manufacturer Identifier. Note: The access attributes of …
90 …ce Identifier. Note: The access attributes of this field are as follows: - Dbi: if (DBI_RO_WR_E…
98 … (0x1<<0) // I/O space access enable. There are no I/O…
100 … (0x1<<1) // Memory space access enable.
[all …]
/freebsd/share/misc/
H A Dusb_vendors6 # http://www.linux-usb.org/usb-ids.html
7 # or send entries as patches (diff -u old new) in the
10 # http://www.linux-usb.org/usb.ids
13 # Date: 2025-09-15 20:34:02
20 # device device_name <-- single tab
21 # interface interface_name <-- two tabs
38 5301 GW-US54ZGL 802.11bg
54 145f NW-3100 802.11b/g 54Mbps Wireless Network Adapter [zd1211]
64 0200 TP-Link
86 120e ASI120MC-S Planetary Camera
[all …]
/freebsd/sys/dev/sound/pci/
H A Denvy24.c1 /*-
2 * SPDX-License-Identifier: BSD-2-Clause
46 /* -------------------------------------------------------------------- */
179 /* -------------------------------------------------------------------- */
208 /* M-Audio Delta series AK4524 access interface */
215 /* -------------------------------------------------------------------- */
221 /* API -> hardware channel map */
236 /* mixer -> API channel map. see above */
238 -1, /* Master output level. It is depend on codec support */
239 -1, /* Treble level of all output channels */
[all …]
H A Denvy24ht.c1 /*-
2 * SPDX-License-Identifier: BSD-2-Clause
35 * generous gift - an 'Audiotrak Prodigy HD2' audio card! I also want to
58 /* -------------------------------------------------------------------- */
178 /* -------------------------------------------------------------------- */
214 /* -------------------------------------------------------------------- */
220 /* API -> hardware channel map */
235 /* mixer -> API channel map. see above */
237 -1, /* Master output level. It is depend on codec support */
238 -1, /* Treble level of all output channels */
[all …]