Home
last modified time | relevance | path

Searched +full:gpi0 +full:- +full:mode (Results 1 – 4 of 4) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/input/
H A Ddlg,da7280.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Dialog Semiconductor DA7280 Low Power High-Definition Haptic Driver
10 - Roy Im <roy.im.opensource@diasemi.com>
23 dlg,actuator-type:
25 - LRA # Linear Resonance Actuator type
26 - ERM-bar # Bar type Eccentric Rotating Mass
27 - ERM-coin # Coin type Eccentric Rotating Mass
29 dlg,const-op-mode:
[all …]
H A Ddlg,da7280.txt4 - compatible: Should be "dlg,da7280".
5 - reg: Specifies the I2C slave address.
7 - interrupt-parent : Specifies the phandle of the interrupt controller to
10 - dlg,actuator-type: Set Actuator type. it should be one of:
11 "LRA" - Linear Resonance Actuator type.
12 "ERM-bar" - Bar type Eccentric Rotating Mass.
13 "ERM-coin" - Coin type Eccentric Rotating Mass.
15 - dlg,const-op-mode: Haptic operation mode for FF_CONSTANT.
17 1 - Direct register override(DRO) mode triggered by i2c(default),
18 2 - PWM data source mode controlled by PWM duty,
[all …]
/freebsd/sys/contrib/device-tree/src/arm64/freescale/
H A Dimx8mp-tqma8mpql-mba8mpxl.dts1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
3 * Copyright 2021-2022 TQ-Systems GmbH
4 * Author: Alexander Stein <alexander.stein@tq-group.com>
7 /dts-v1/;
9 #include <dt-bindings/leds/common.h>
10 #include <dt-bindings/net/ti-dp83867.h>
11 #include <dt-bindings/phy/phy-imx8-pcie.h>
12 #include <dt-bindings/pwm/pwm.h>
13 #include "imx8mp-tqma8mpql.dtsi"
16 model = "TQ-Systems i.MX8MPlus TQMa8MPxL on MBa8MPxL";
[all …]
/freebsd/sys/contrib/device-tree/src/arm/aspeed/
H A Daspeed-bmc-ampere-mtmitchell.dts1 // SPDX-License-Identifier: GPL-2.0-only
4 /dts-v1/;
6 #include "aspeed-g6.dtsi"
7 #include <dt-bindings/i2c/i2c.h>
8 #include <dt-bindings/gpio/aspeed-gpio.h>
12 compatible = "ampere,mtmitchell-bmc", "aspeed,ast2600";
27 * i2c bus 30-31 assigned to OCP slot 0-1
33 * i2c bus 32-33 assigned to Riser slot 0-1
39 * i2c bus 38-39 assigned to FRU on Riser slot 0-1
82 stdout-path = &uart5;
[all …]