Home
last modified time | relevance | path

Searched +full:ethernet +full:- +full:phy +full:- +full:id0007 (Results 1 – 12 of 12) sorted by relevance

/freebsd/sys/contrib/device-tree/src/arm/nxp/imx/
H A Dimx6ull-dhcom-picoitx.dts1 // SPDX-License-Identifier: GPL-2.0+ OR BSD-3-Clause
6 * DHCM-iMX6ULL-C080-R051-F0409-SPI-E2-CAN2-SD-RTC-ADC-I-01D2
7 * DHCOR PCB number: 578-200 or newer
8 * DHCOM PCB number: 579-200 or newer
9 * PicoITX PCB number: 487-600 or newer
11 /dts-v1/;
13 #include "imx6ull-dhcom-som.dtsi"
14 #include "imx6ull-dhcom-som-cfg-sdcard.dtsi"
18 compatible = "dh,imx6ull-dhcom-picoitx", "dh,imx6ull-dhcom-som",
19 "dh,imx6ull-dhcor-som", "fsl,imx6ull";
[all …]
H A Dimx6ull-dhcom-som.dtsi1 // SPDX-License-Identifier: GPL-2.0+ OR BSD-3-Clause
6 #include "imx6ull-dhcor-som.dtsi"
10 /delete-property/ spi2;
11 /delete-property/ spi3;
28 stdout-path = "serial0:115200n8";
31 reg_ext_3v3_ref: regulator-ext-3v3-ref {
32 compatible = "regulator-fixed";
33 regulator-always-on;
34 regulator-max-microvolt = <3300000>;
35 regulator-min-microvolt = <3300000>;
[all …]
H A Dimx6qdl-dhcom-som.dtsi1 // SPDX-License-Identifier: GPL-2.0+
3 * Copyright (C) 2015-2021 DH electronics GmbH
7 #include <dt-bindings/pwm/pwm.h>
8 #include <dt-bindings/gpio/gpio.h>
9 #include <dt-bindings/clock/imx6qdl-clock.h>
10 #include <dt-bindings/input/input.h>
30 memory@10000000 { /* Appropriate memory size will be filled by U-Boot */
35 reg_3p3v: regulator-3P3V {
36 compatible = "regulator-fixed";
37 regulator-always-on;
[all …]
/freebsd/sys/contrib/device-tree/src/riscv/sifive/
H A Dhifive-unleashed-a00.dts1 // SPDX-License-Identifier: (GPL-2.0 OR MIT)
2 /* Copyright (c) 2018-2019 SiFive, Inc */
4 #include "fu540-c000.dtsi"
5 #include <dt-bindings/gpio/gpio.h>
6 #include <dt-bindings/leds/common.h>
7 #include <dt-bindings/pwm/pwm.h>
14 compatible = "sifive,hifive-unleashed-a00", "sifive,fu540-c000",
18 stdout-path = "serial0";
22 timebase-frequency = <RTCCLK_FREQ>;
31 #clock-cells = <0>;
[all …]
/freebsd/sys/contrib/device-tree/src/arm/renesas/
H A Dr7s72100-gr-peach.dts1 // SPDX-License-Identifier: GPL-2.0
3 * Device Tree Source for the GR-Peach board
9 /dts-v1/;
11 #include <dt-bindings/gpio/gpio.h>
12 #include <dt-bindings/pinctrl/r7s72100-pinctrl.h>
15 model = "GR-Peach";
16 compatible = "renesas,gr-peac
[all...]
H A Dr8a7740-armadillo800eva.dts1 // SPDX-License-Identifier: GPL-2.0
8 /dts-v1/;
10 #include <dt-bindings/gpio/gpio.h>
11 #include <dt-bindings/input/input.h>
12 #include <dt-bindings/interrupt-controller/irq.h>
13 #include <dt-bindings/pwm/pwm.h>
25 stdout-path = "serial0:115200n8";
33 reg_3p3v: regulator-3p3v {
34 compatible = "regulator-fixed";
35 regulator-name = "fixed-3.3V";
[all …]
/freebsd/sys/contrib/device-tree/src/mips/ingenic/
H A Dcu1000-neo.dts1 // SPDX-License-Identifier: GPL-2.0
2 /dts-v1/;
5 #include <dt-bindings/gpio/gpio.h>
6 #include <dt-bindings/clock/ingenic,sysost.h>
7 #include <dt-bindings/interrupt-controller/irq.h>
10 compatible = "yna,cu1000-neo", "ingenic,x1000e";
11 model = "YSH & ATIL General Board CU1000-Neo";
18 stdout-path = "serial2:115200n8";
27 compatible = "gpio-leds";
28 led-0 {
[all …]
/freebsd/sys/contrib/device-tree/Bindings/net/
H A Dmscc-phy-vsc8531.txt1 * Microsemi - vsc8531 Giga bit ethernet phy
4 - vsc8531,vddmac : The vddmac in mV. Allowed values is listed
7 with the 'edge-slowdown' property.
9 - vsc8531,edge-slowdown : % the edge should be slowed down relative to
19 To adjust the edge-slowdown, the 'vddmac'
21 supported edge-slowdown values for a given
24 Ref: Table:1 - Edge rate change (below).
25 - vsc8531,led-[N]-mode : LED mode. Specify how the LED[N] should behave.
27 PHY.
29 "include/dt-bindings/net/mscc-phy-vsc8531.h".
[all …]
/freebsd/sys/contrib/device-tree/src/arm/nxp/mxs/
H A Dimx28-btt3.dtsi1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
6 /dts-v1/;
7 #include "imx28-lwe.dtsi"
12 compatible = "lwn,imx28-btt3", "fsl,imx28";
24 compatible = "powertip,hx8238a", "panel-dpi";
25 power-supply = <&reg_3v3>;
26 width-mm = <70>;
27 height-mm = <52>;
29 panel-timing {
30 clock-frequency = <6500000>;
[all …]
/freebsd/sys/contrib/device-tree/src/arm64/freescale/
H A Dimx8mp-dhcom-som.dtsi1 // SPDX-License-Identifier: GPL-2.0
3 * Copyright (C) 2021-2022 Marek Vasut <marex@denx.de>
10 compatible = "dh,imx8mp-dhcom-som", "fsl,imx8mp";
22 /* Memory size 512 MiB..8 GiB will be filled by U-Boot */
26 reg_eth_vio: regulator-eth-vio {
27 compatible = "regulator-fixed";
29 regulator-always-on;
30 regulator-boot-on;
31 regulator-min-microvolt = <3300000>;
32 regulator-max-microvolt = <3300000>;
[all …]
/freebsd/sys/contrib/device-tree/src/arm/st/
H A Dstm32mp15xx-dhcom-som.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)
3 * Copyright (C) 2019-2020 Marek Vasut <marex@denx.de>
6 #include "stm32mp15-pinctrl.dtsi"
7 #include "stm32mp15xxaa-pinctrl.dtsi"
8 #include <dt-bindings/gpio/gpio.h>
9 #include <dt-bindings/mfd/st,stpmic1.h>
23 stdout-path = "serial0:115200n8";
31 reserved-memory {
32 #address-cells = <1>;
33 #size-cells = <1>;
[all …]
H A Dstm32mp135f-dk.dts1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)
3 * Copyright (C) STMicroelectronics 2021 - All Rights Reserved
7 /dts-v1/;
9 #include <dt-bindings/gpio/gpio.h>
10 #include <dt-bindings/input/input.h>
11 #include <dt-bindings/leds/common.h>
12 #include <dt-bindings/regulator/st,stm32mp13-regulator.h>
15 #include "stm32mp13-pinctrl.dtsi"
18 model = "STMicroelectronics STM32MP135F-DK Discovery Board";
19 compatible = "st,stm32mp135f-dk", "st,stm32mp135";
[all …]