Searched full:doze (Results 1 – 12 of 12) sorted by relevance
48 #define HID0_DOZE 0x00800000 /* Enable doze mode */88 "\030DOZE\027NAP\026SLEEP\025DPM\024RISEG\023EIEC\022res\021NHR" \102 "\030DOZE\027NAP\026SLEEP\025b11\024b12\023b13\022b14\021b15" \108 "\040ONEPPC\037SINGLE\036ISYNCSC\035SERGP\031DEEPNAP\030DOZE" \138 * 8 DOZE - DOZE DOZE DOZE - HBATEN DOZE
20 - syna,doze-holdoff-ms: The delay to wait after the last finger lift and the21 first doze cycle.22 - syna,doze-interval-ms: The time period that the device sleeps between finger
20 - idle-doze : specifier consist of one cell. For each49 idle-doze = <0x02000000>;
94 idle-doze = <0x02000000>;
90 idle-doze = <0x02000000>;
113 idle-doze = <0x02000000>;
199 GPT_CR_DOZEEN | /* Run in DOZE mode */ in imx_gpt_attach()
51 * SLOW or DOZE state.
488 /* Select DOZE mode. */ in cpu_6xx_setup()
1052 * operate in doze mode.1055 * exit from doze mode. The driver sends this event after it enters or1056 * exits the doze mode with the updated AP doze mode settings.16186 * enum qca_wlan_dozed_ap_state - Doze states for AP interface16188 * @QCA_WLAN_DOZED_AP_DISABLE: Disable doze state on the AP interface.16190 * @QCA_WLAN_DOZED_AP_ENABLE: Enable doze state on the AP interface. AP starts16204 * Configures the doze state for an AP interface. Possible values are defined16215 * doze mode configuration. Next TBTT TSF is the time at which the AP sends16338 * in doze state always and does not monitor the beacons.16341 * It may enter doze state and comes out based on the transmit data traffic and
4642 * alternate between Active and Doze states, but will wake up for4645 * alternate between Active and Doze states, but may not wake up
57509 doze