Home
last modified time | relevance | path

Searched full:detection (Results 1 – 25 of 1214) sorted by relevance

12345678910>>...49

/freebsd/sys/contrib/device-tree/Bindings/extcon/
H A Dwlf,arizona.yaml22 Headphone detection channel. ARIZONA_ACCDET_MODE_HPL/1 sets the
25 then headphone detection mode is set to HPDETL.
32 Use the additional JD input along with JD1 for dual pin jack detection.
37 Internal pull on JD2 is disabled when used for jack detection.
42 Invert the polarity of the jack detection switch.
52 Additional software microphone detection debounce specified in
65 detection, specified as per the ARIZONA_MICD_TIME_XXX defines.
72 Delay between successive microphone detection measurements, specified
80 Microphone detection hardware debounces specified as the number of
87 Timeout for microphone detection, specified in milliseconds.
[all …]
H A Dextcon-palmas.txt13 - ti,enable-id-detection: Perform ID detection. If id-gpio is specified
14 it performs id-detection using GPIO else using OTG core.
15 - ti,enable-vbus-detection: Perform VBUS detection.
16 - id-gpio: gpio for GPIO ID detection. See gpio binding.
/freebsd/sys/contrib/device-tree/Bindings/regulator/
H A Dregulator.yaml138 Zero can be passed to disable error detection and value '1' indicates
139 that detection should be enabled but limit setting can be omitted.
145 disable detection and value '1' indicates that detection should
158 Zero can be passed to disable error detection and value '1' indicates
159 that detection should be enabled but limit setting can be omitted. Limit
166 disable detection and value '1' indicates that detection should
180 Zero can be passed to disable error detection and value '1' indicates
181 that detection should be enabled but limit setting can be omitted. Limit
188 to disable detection and value '1' indicates that detection should
209 Zero can be passed to disable error detection and value '1' indicates
[all …]
/freebsd/sys/dev/qat/qat_hw/qat_c62x/
H A Dadf_c62x_hw_data.h26 /* Error detection and correction */
62 * BIT(2) enables error detection and reporting on the RI Parity Error.
63 * BIT(1) enables error detection and reporting on the RI CPP Pull interface.
64 * BIT(0) enables error detection and reporting on the RI CPP Push interface.
71 * BIT(4) enables parity error detection and reporting on the Secure RAM.
72 * BIT(3) enables error detection and reporting on the ETR Parity Error.
73 * BIT(2) enables error detection and reporting on the TI Parity Error.
74 * BIT(1) enables error detection and reporting on the TI CPP Pull interface.
75 * BIT(0) enables error detection and reporting on the TI CPP Push interface.
/freebsd/sys/dev/qat/qat_hw/qat_c3xxx/
H A Dadf_c3xxx_hw_data.h25 /* Error detection and correction */
59 * BIT(2) enables error detection and reporting on the RI Parity Error.
60 * BIT(1) enables error detection and reporting on the RI CPP Pull interface.
61 * BIT(0) enables error detection and reporting on the RI CPP Push interface.
68 * BIT(3) enables error detection and reporting on the ETR Parity Error.
69 * BIT(2) enables error detection and reporting on the TI Parity Error.
70 * BIT(1) enables error detection and reporting on the TI CPP Pull interface.
71 * BIT(0) enables error detection and reporting on the TI CPP Push interface.
/freebsd/sys/dev/qat/qat_hw/qat_200xx/
H A Dadf_200xx_hw_data.h27 /* Error detection and correction */
61 * BIT(2) enables error detection and reporting on the RI Parity Error.
62 * BIT(1) enables error detection and reporting on the RI CPP Pull interface.
63 * BIT(0) enables error detection and reporting on the RI CPP Push interface.
70 * BIT(3) enables error detection and reporting on the ETR Parity Error.
71 * BIT(2) enables error detection and reporting on the TI Parity Error.
72 * BIT(1) enables error detection and reporting on the TI CPP Pull interface.
73 * BIT(0) enables error detection and reporting on the TI CPP Push interface.
/freebsd/sys/contrib/device-tree/Bindings/i3c/
H A Drenesas,i3c.yaml34 - description: START condition detection interrupt
35 - description: STOP condition detection interrupt
37 - description: NACK detection interrupt
39 - description: Timeout detection interrupt
40 - description: Wake-up condition detection interrupt
41 - description: HDR Exit Pattern detection interrupt
/freebsd/contrib/tcpdump/
H A Dprint-realtek.c21 * Loop Detection Protocol (RLDP), and Realtek Echo Protocol (REP) packets,
153 * See section 8.21 "Network Loop Connection Fault Detection" of
157 * and section 7.23 "Network Loop Connection Fault Detection" of
163 * See also section 7.3.8 "Loop Detection" of
168 * detection protocol for which the payload has a 16-bit (presumably
174 * See also section 7.3.13 "Loop Detection" of
179 * loop detection protocol that lacks the TTL field - all the bytes
182 * See also section 7.3.7 "Loop Detection" of
187 * detection protocol similar to the one from the RTL8306E-CG datasheet,
/freebsd/share/man/man4/
H A Dppc.482 bit 6: disable chipset specific detection
84 bit 7: disable FIFO detection
88 detection and initialisation code has been written according to
132 The chipset detection process may corrupt your chipset configuration.
134 disable chipset specific detection by using the above flags.
H A Dng_lmi.451 It also supports auto-detection of the LMI type.
64 To enable LMI type auto-detection, connect the
72 Only one fixed LMI type, or auto-detection, can be active at any given time.
91 Auto-detection hook for DLCI 0.
93 Auto-detection hook for DLCI 1023.
/freebsd/sys/dev/rtwn/rtl8821a/usb/
H A Dr21au_dfs.c125 "%s: periodical radar detection task\n", __func__); in r21au_chan_check()
132 "%s: radar detection was turned off " in r21au_chan_check()
185 "%s: cannot enable radar detection\n", __func__); in r21au_newstate()
191 "%s: radar detection was enabled\n", __func__); in r21au_newstate()
209 "%s: radar detection was disabled\n", __func__); in r21au_newstate()
240 "%s: radar detection was (temporarily) disabled\n", in r21au_scan_start()
260 "%s: cannot re-enable radar detection\n", in r21au_scan_end()
269 "%s: radar detection was re-enabled\n", __func__); in r21au_scan_end()
/freebsd/sys/contrib/zlib/doc/
H A Dtxtvsbin.txt10 this may appear like a simple task, a fully accurate detection of the
16 were using a crude detection scheme: if more than 80% (4/5) of the bytes
28 In this article we propose a new, simple detection scheme that features
72 detection schemes observe the presence of non-ASCII codes from the range
93 be regarded as binary by general-purpose text detection schemes, because
95 Under this premise, it is safe to say that our detection method provides
/freebsd/sys/contrib/device-tree/Bindings/iio/light/
H A Dsharp,gp2ap002.yaml46 Hysteresis setting for "far" object detection, this setting is
47 device-unique and adjust the optical setting for proximity detection
53 Hysteresis setting for "close" object detection, this setting is
54 device-unique and adjust the optical setting for proximity detection
/freebsd/sys/contrib/device-tree/Bindings/power/supply/
H A Dmediatek,mt6370-charger.yaml14 Provides Battery Charger, Boost for OTG devices and BC1.2 detection.
24 is plugged in, and then the driver will enable BC1.2 detection.
25 After the hardware of MT6370 completes the BC1.2 detection,
27 the result of BC1.2 detection.
H A Dbq2415x.txt30 - ti,usb-charger-detection: phandle to usb charger detection device.
46 ti,usb-charger-detection = <&isp1704>;
/freebsd/sys/contrib/device-tree/Bindings/sound/
H A Dsamsung,midas-audio.yaml69 description: GPIO for detection of headset insertion
73 description: GPIO for detection of headset key press
77 description: IO channel to read micbias voltage for headset detection
95 detection, in order: "Media", "Volume Up" and "Volume Down".
H A Dnokia,rx51.txt10 - jack-detection-gpios: GPIO for jack detection
24 jack-detection-gpios = <&gpio6 17 GPIO_ACTIVE_HIGH>; /* 177 */
H A Dsamsung,aries-wm8994.yaml62 description: Extcon phandle for dock detection
76 description: GPIO for detection of headset insertion
80 description: GPIO for detection of headset key press
84 description: IO channel to read micbias voltage for headset detection
H A Deverest,es8326.yaml29 description: interrupt output for headset detection
65 Defined to invert the jack detection.
72 Bit(3) 1 means PIN9 is the irq source for jack detection. When set to 0,
74 Bit(4) 1 means PIN27 is the irq source for jack detection.
H A Ddialog,da7219.yaml14 in-built advanced accessory detection (AAD) for mobile
94 Configuration of advanced accessory detection.
117 Impedance threshold for mic detection measurement (Ohms).
129 Polarity for jack insertion detection.
135 Jack type (3/4 pole) detection latency (ms).
H A Drt5677.txt38 Configures GPIO Mic Jack detection 1.
43 Configures GPIO Mic Jack detection 2 and 3.
77 realtek,jd2-gpio = <3>; /* Enables Jack detection for GPIO6 */
H A Drt5645.txt46 1 : Mode-0 (VDD=3.3V), two port jack detection
47 2 : Mode-1 (VDD=3.3V), one port jack detection
48 3 : Mode-2 (VDD=1.8V), one port jack detection
/freebsd/sys/dev/qat/qat_hw/qat_dh895xcc/
H A Dadf_dh895xcc_hw_data.h28 /* Error detection and correction */
67 * BIT(1) enables error detection and reporting on the RI CPP Pull interface.
68 * BIT(0) enables error detection and reporting on the RI CPP Push interface.
75 * BIT(1) enables error detection and reporting on the TI CPP Pull interface.
76 * BIT(0) enables error detection and reporting on the TI CPP Push interface.
/freebsd/contrib/llvm-project/lldb/source/Plugins/Process/Utility/
H A DRegisterFlagsDetector_arm64.h20 /// This class manages the storage and detection of register field information.
22 /// abstracts out the field detection process so we can use it on live processes
51 /// Returns true if field detection has been run at least once.
80 // Becomes true once field detection has been run for all registers.
/freebsd/sys/contrib/device-tree/src/arm/nxp/imx/
H A Dimx7d-flex-concentrator.dts149 * Ethernet PHY type ID auto-detection. Otherwise this communication
172 * Detection signals for internal USB modules.
183 "", "module-b-detection", "", "module-a-detection", "", "", "", "";
254 /* Module A detection (low = present) */
256 /* Module B detection (low = present) */

12345678910>>...49