Searched +full:dclk +full:- +full:div (Results 1 – 6 of 6) sorted by relevance
/freebsd/sys/contrib/device-tree/Bindings/display/ |
H A D | solomon,ssd1307fb.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 5 $schema: http://devicetree.org/meta-schema [all...] |
H A D | ssd1307fb.txt | 4 - compatible: Should be "solomon,<chip>fb-<bus>". The only supported bus for 7 - reg: Should contain address of the controller on the I2C bus. Most likely 9 - pwm: Should contain the pwm to use according to the OF device tree PWM 11 - solomon,height: Height in pixel of the screen driven by the controller 12 - solomon,width: Width in pixel of the screen driven by the controller 13 - solomon,page-offset: Offset of pages (band of 8 pixels) that the screen is 17 - reset-gpios: The GPIO used to reset the OLED display, if available. See 19 - vbat-supply: The supply for VBAT 20 - solomon,segment-no-remap: Display needs normal (non-inverted) data column 22 - solomon,col-offset: Offset of columns (COL/SEG) that the screen is mapped to. [all …]
|
/freebsd/sys/contrib/device-tree/src/arm/ti/omap/ |
H A D | dra7xx-clocks.dtsi | 1 // SPDX-License-Identifier: GPL-2.0-only 8 atl_clkin0_ck: clock-atl-clkin0 { 9 #clock-cells = <0>; 10 compatible = "ti,dra7-atl-clock"; 11 clock-output-names = "atl_clkin0_ck"; 15 atl_clkin1_ck: clock-atl-clkin1 { 16 #clock-cells = <0>; 17 compatible = "ti,dra7-atl-clock"; 18 clock-output-names = "atl_clkin1_ck"; 22 atl_clkin2_ck: clock-atl-clkin2 { [all …]
|
/freebsd/sys/dev/clk/rockchip/ |
H A D | rk3328_cru.c | 1 /*- 2 * SPDX-License-Identifier: BSD-2-Clause 4 * Copyright (c) 2018-2021 Emmanuel Vadot <manu@freebsd.org> 139 /* DCLK */ 260 /* Bit 7-8 unused */ 265 /* Bit 13-15 unused */ 310 /* Bit 6-7 unused */ 312 /* Bit 9-15 unused */ 326 /* Bit 11-15 unused */ 336 /* Bit 7-15 unused */ [all …]
|
/freebsd/sys/contrib/device-tree/src/arm64/rockchip/ |
H A D | rk3328.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT) 6 #include <dt-bindings/clock/rk3328-cru.h> 7 #include <dt-bindings/gpio/gpio.h> 8 #include <dt-bindings/interrupt-controller/arm-gic.h> 9 #include <dt-binding [all...] |
/freebsd/sys/dev/qlnx/qlnxe/ |
H A D | reg_addr.h | 2 * Copyright (c) 2017-2018 Cavium, Inc. 78 …- For ending "endless completion". 0 - When receiving a completion timeout while receiving a compl… 79 … DataWidth:0x4 // 0 - TXCPL sync fifo pop underflow 1 - TXR sync fifo pop underflow 2 - TXW hea… 80 …s:R DataWidth:0x6 // 0 - RX target read and config sync fifo push overflow 1 - RX header syn… 81 …ataWidth:0x14 // 4:0 - TXCPL sync fifo pop status 9:5 - TXR sync fifo pop status 14:10 - TXW hea… 88 …ffff<<0) // Vendor ID. PCI-SIG assigned Manufacturer Identifier. Note: The access attributes of … 90 …ce Identifier. Note: The access attributes of this field are as follows: - Dbi: if (DBI_RO_WR_E… 116 … (0x1<<9) // Fast back-to-back transaction ena… 128 … (0x1<<23) // Fast back-to-back capable. Not ap… 145 …l has_io_bar=0. Note: The access attributes of this field are as follows: - Dbi: if (DBI_RO_WR_E… [all …]
|