/freebsd/sys/contrib/device-tree/Bindings/power/supply/ |
H A D | charger-manager.txt | 11 - subnode <cable> : 12 - cm-cable-name : name of charger cable - one of USB, USB-HOST, 15 - cm-cable-extcon : name of extcon dev 16 (optional) - cm-cable-min : minimum current of cable 17 (optional) - cm-cable-max : maximum current of cable 77 cable@0 { 78 cm-cable-name = "USB"; 79 cm-cable-extcon = "extcon-dev.0"; 80 cm-cable-min = <475000>; 81 cm-cable-max = <500000>; [all …]
|
H A D | charger-manager.yaml | 125 "^cable[@-][0-9]$": 128 cm-cable-name: 129 description: name of charger cable 145 cm-cable-extcon: 149 cm-cable-min: 150 description: minimum current of cable in uA 153 cm-cable-max: 154 description: maximum current of cable in uA 158 - cm-cable-name 159 - cm-cable-extcon [all …]
|
/freebsd/sys/dts/include/dt-bindings/net/ |
H A D | qcom-qca807x.h | 58 * cable length. 61 * 1 - amplitude follows cable length, half bias current 62 * 2 - full amplitude, bias current follows cable length 63 * 3 - both amplitude and bias current follow cable length 65 * 5 - amplitude follows cable length, 1/4 bias current 66 * when cable length < 10m else half bias current 67 * 6 - full amplitude, bias current follows cable length, 68 * bias reduced further by half when cable length < 10m 69 * 7 - amplitude follows cable length, same bias current
|
/freebsd/sys/contrib/device-tree/include/dt-bindings/usb/ |
H A D | pd.h | 102 * <29:27> :: product type (UFP / Cable / VPD) 107 * <15:0> :: USB-IF assigned VID for this cable vendor 120 /* SOP' Product Type (Cable Plug / VPD) */ 140 * <31:0> : USB-IF assigned XID for this cable 235 * Cable VDO (for both Passive and Active Cable VDO in PD Rev2.0) 237 * <31:28> :: Cable HW version 238 * <27:24> :: Cable FW version 242 * <16:13> :: cable latency (0001 == <10ns(~1m length)) 243 * <12:11> :: cable termination type (11b == both ends active VCONN req) 249 * <4> :: Vbus through cable (0b == no, 1b == yes) [all …]
|
/freebsd/share/man/man4/ |
H A D | uplcom.4 | 123 Nokia CA-42 Cable 125 OTI DKU-5 cable 129 PLX CA-42 Phone Cable 143 Radio Shack USB Serial Cable 151 Sanwa KB-USB2 Multimeter cable 159 Sony QN3 Phone Cable 167 Speed Dragon USB-Serial Cable 183 YC-Cable USB-Serial Adapter
|
H A D | uslcom.4 | 60 AKTACOM ACE-1001 cable 72 B&G H3000 Data Cable 151 PLX CA-42 Phone cable 159 Siemens MC60 Cable 183 Vaisala USB Instrument cable 187 WAGO 750-923 USB Service Cable
|
H A D | ata.4 | 80 set to 0 to disable the 80pin cable check (the default is 1, check the cable). 146 .Dq Sy "DMA limited to UDMA33, non-ATA66 cable or device". 150 driver has detected that the required 80 conductor cable is not present
|
H A D | udbp.4 | 127 .%B Total Commander: Supported cables for USB cable connection 134 for a USB 3.0 SuperSpeed cable, latency is comparable to 100BaseTX Ethernet 138 A Plugable PL27A1 cable claims 24mA of USB3 bus power,
|
/freebsd/release/scripts/ |
H A D | box.ovf | 125 … <Adapter slot="0" enabled="true" MACAddress="080027D14C66" cable="true" speed="0" type="82540EM"> 132 … <Adapter slot="1" enabled="false" MACAddress="080027058FF2" cable="true" speed="0" type="82540EM"> 140 … <Adapter slot="2" enabled="false" MACAddress="08002763A181" cable="true" speed="0" type="82540EM"> 148 … <Adapter slot="3" enabled="false" MACAddress="0800279C6D17" cable="true" speed="0" type="82540EM"> 156 … <Adapter slot="4" enabled="false" MACAddress="08002760C885" cable="true" speed="0" type="82540EM"> 164 … <Adapter slot="5" enabled="false" MACAddress="0800279ECE95" cable="true" speed="0" type="82540EM"> 172 … <Adapter slot="6" enabled="false" MACAddress="08002730E8BE" cable="true" speed="0" type="82540EM"> 180 … <Adapter slot="7" enabled="false" MACAddress="080027AD8EF8" cable="true" speed="0" type="82540EM">
|
/freebsd/usr.sbin/bsdconfig/include/ |
H A D | network_device.hlp | 4 Parallel port: PLIP (laplink cable) 9 connected links, such as a serial cable running between a laptop 19 speed for a hardwired cable). 36 parallel port cable. The data rate over the parallel port is much
|
/freebsd/sys/contrib/device-tree/Bindings/net/ |
H A D | qcom,qca807x.yaml | 78 (amplitude is adjusted based on cable length) 90 (bias current is adjusted based on cable length) 108 is set to 1/4 with cable < 10m. 111 with cable < 10m.
|
/freebsd/sys/contrib/device-tree/Bindings/mips/brcm/ |
H A D | soc.yaml | 7 title: Broadcom cable/DSL/settop platforms 13 Boards Broadcom cable/DSL/settop SoC shall have the following properties. 15 BMIPS4355 cable modem CPU instead of the BMIPS5000 application processor.
|
/freebsd/sys/dev/isci/scil/ |
H A D | scu_bios_definitions.h | 630 * This field indicates length of the SAS/SATA cable between 633 * the phy in the silicon and length of the cable. 640 * For short cable corresponding bit shall be reset, 641 * for long cable shall be set. 840 * This field indicates length of the SAS/SATA cable between 843 * the phy in the silicon and length of the cable. 844 * Supported cable attenuation levels: 849 * ASSIGNMENT: <phy3><phy2><phy1><phy0> - Medium cable length assignment 851 * ASSIGNMENT: <phy3><phy2><phy1><phy0> - Long cable length assignment 853 * BITS 7-4 are set when the cable length is assigned to medium [all …]
|
/freebsd/sys/contrib/device-tree/src/arm64/qcom/ |
H A D | sc7180-trogdor-lazor-r0.dts | 21 * Lane 0 was incorrectly mapped on the cable, but we've now decided 22 * that the cable is canon and in -rev1+ we'll make a board change
|
/freebsd/lib/libifconfig/ |
H A D | sfp.lua | 176 "Channel/Cable technology, byte 7-8", 179 description = "Channel/cable technology", 189 {0x0008, "ACTIVE", "Active Cable"}, 190 {0x0004, "PASSIVE", "Passive Cable"}, 238 {0x01, "40G_ACTIVE", "40G Active Cable"}, 333 "100G ACC (Active Copper Cable"}, 341 "100G AOC (Active Optical Cable"},
|
/freebsd/contrib/ntp/html/drivers/ |
H A D | driver43.html | 25 …cable sold by Trimble to connect to this wire is a very thick cable. Certainly not something you w…
|
/freebsd/contrib/file/magic/Magdir/ |
H A D | avm | 10 # Note: only tested with models 4040 and 6490 Cable (lgi) 15 # router model name like "4040" , "6490 Cable (lgi)" followed by " CONFIGURATION EXPORT"
|
/freebsd/sys/contrib/device-tree/Bindings/usb/ |
H A D | qcom,pmic-typec.yaml | 51 - description: Type-C Legacy cable detect 71 - const: legacy-cable-detect 166 "legacy-cable-detect",
|
H A D | msm-hsusb.txt | 82 cable events, the second should point to external connector 83 device, which provide "USB-HOST" cable events. If one of
|
/freebsd/sys/contrib/device-tree/Bindings/sound/ |
H A D | fsl,spdif.txt | 4 processor to receive and transmit digital audio via an coaxial cable or 5 a fibre cable.
|
H A D | fsl,spdif.yaml | 14 processor to receive and transmit digital audio via an coaxial cable or 15 a fibre cable.
|
/freebsd/sys/dev/e1000/ |
H A D | e1000_phy.c | 44 /* Cable length tables */ 1165 * Automatic Correction for Reversed Cable Polarity in e1000_copper_link_setup_m88() 1318 * Automatic Correction for Reversed Cable Polarity in e1000_copper_link_setup_m88_gen2() 2282 * e1000_check_polarity_ife - Check cable polarity for IFE PHY 2404 * e1000_get_cable_length_m88 - Determine cable length for m88 PHY 2407 * Reads the PHY specific status register to retrieve the cable length 2408 * information. The cable length is determined by averaging the minimum and 2409 * maximum values to get the "average" cable length. The m88 PHY has four 2410 * possible cable length values, which are: 2411 * Register Value Cable Length [all …]
|
/freebsd/sys/contrib/device-tree/src/arm/aspeed/ |
H A D | aspeed-bmc-ibm-fuji.dts | 409 "presence-cable-card1", 410 "presence-cable-card2", 411 "presence-cable-card3", 412 "presence-cable-card4", 413 "presence-cable-card5", 414 "expander-cable-card1", 415 "expander-cable-card2", 416 "expander-cable-card3", 417 "expander-cable-card4", 418 "expander-cable-card5"; [all …]
|
/freebsd/share/misc/ |
H A D | usb_vendors | 775 0008 Platform Cable USB II 877 bd90 PICAXE Download Cable [AXE027] 1677 0800 Connectivity Cable DKU-5 1678 0801 Data Cable DKU-6 2379 028f Xbox360 Wireless Controller via Plug & Charge Cable 3277 0814 DCCX38/P data cable 4732 0002 ISD Smart Cable for Mac 4733 0003 ISD Smart Cable 6538 2922 HomeConnect Cable Modem External with 6554 050b Cable System International [all …]
|
/freebsd/sys/net/ |
H A D | sff8436.h | 58 * Page 03 (optional for Cable Assmeblies) 154 SFF_8436_LEN_ASM = 144, /* Link length of passive cable assembly 174 * (Passive/Active Cable
|