/linux/tools/perf/pmu-events/arch/arm64/fujitsu/a64fx/ |
H A D | pipeline.json | 51 …dicate bits of request in FLA pipeline, where it is corrected so that it becomes 16 when all bits … 54 …dicate bits of request in FLA pipeline, where it is corrected so that it becomes 16 when all bits … 57 …dicate bits of request in FLB pipeline, where it is corrected so that it becomes 16 when all bits … 60 …dicate bits of request in FLB pipeline, where it is corrected so that it becomes 16 when all bits … 165 …its of request in L1D cache pipeline#0, where it is corrected so that it becomes 16 when all bits … 168 …its of request in L1D cache pipeline#0, where it is corrected so that it becomes 16 when all bits … 171 …its of request in L1D cache pipeline#1, where it is corrected so that it becomes 16 when all bits … 174 …its of request in L1D cache pipeline#1, where it is corrected so that it becomes 16 when all bits …
|
/linux/tools/lib/subcmd/ |
H A D | run-command.h | 27 * the readable pipe end becomes child's stdin 29 * it, the writable pipe end becomes child's stdout/stderr 33 * .in: a readable FD, becomes child's stdin 34 * .out: a writable FD, becomes child's stdout/stderr
|
/linux/Documentation/admin-guide/mm/damon/ |
H A D | reclaim.rst | 159 DAMON_RECLAIM becomes inactive, so it does nothing but only periodically checks 168 the low watermark, DAMON_RECLAIM becomes active, so starts the monitoring and 177 DAMON_RECLAIM becomes inactive, so it does nothing but periodically checks the 249 If DAMON_RECLAIM is enabled, this becomes the PID of the worker thread. Else, 285 works if it becomes lower than 40%. If DAMON_RECLAIM doesn't make progress and 286 therefore the free memory rate becomes lower than 20%, it asks DAMON_RECLAIM to
|
H A D | lru_sort.rst | 138 DAMON_LRU_SORT becomes inactive, so it does nothing but periodically checks the 147 the low watermark, DAMON_LRU_SORT becomes active, so starts the monitoring and 156 DAMON_LRU_SORT becomes inactive, so it does nothing but periodically checks the 219 If DAMON_LRU_SORT is enabled, this becomes the PID of the worker thread. Else, 281 50%, but start the real works if it becomes lower than 40%. If DAMON_RECLAIM 282 doesn't make progress and therefore the free memory rate becomes lower than
|
/linux/lib/ |
H A D | dhry_2.c | 45 /* Enum_Val_Par == Ident_3, Enum_Ref_Par becomes Ident_2 */ in Proc_6() 80 /* Int_Par_Ref becomes 7 */ in Proc_7() 82 /* Int_Par_Ref becomes 17 */ in Proc_7() 84 /* Int_Par_Ref becomes 18 */ in Proc_7()
|
/linux/Documentation/staging/ |
H A D | rpmsg.rst | 81 one becomes available (i.e. until the remote processor consumes 105 one becomes available (i.e. until the remote processor consumes 130 one becomes available (i.e. until the remote processor consumes 150 return -ENOMEM without waiting until one becomes available. 171 return -ENOMEM without waiting until one becomes available. 192 return -ENOMEM without waiting until one becomes available.
|
/linux/arch/arm64/boot/dts/freescale/ |
H A D | imx8mm-phygate-tauri-l-rs232-rts-cts.dtso | 7 * - UART4_TX becomes RTS 8 * - UART4_RX becomes CTS
|
H A D | imx8mm-venice-gw72xx-0x-rs232-rts.dtso | 7 * - UART4_TX becomes RTS 8 * - UART4_RX becomes CTS
|
H A D | imx8mm-venice-gw73xx-0x-rs232-rts.dtso | 7 * - UART4_TX becomes RTS 8 * - UART4_RX becomes CTS
|
/linux/Documentation/misc-devices/ |
H A D | lis3lv02d.rst | 80 * If the left side is elevated, X increases (becomes positive) 82 (becomes negative) 83 * If the laptop is put upside-down, Z becomes negative
|
/linux/Documentation/ABI/testing/ |
H A D | sysfs-class-typec | 296 value will show 0 until Discover Identity command result becomes 304 value will show 0 until Discover Identity command result becomes 312 will show 0 until Discover Identity command result becomes 320 The value will show 0 until Discover Identity command result becomes 328 The value will show 0 until Discover Identity command result becomes 336 The value will show 0 until Discover Identity command result becomes
|
H A D | sysfs-bus-intel_th-devices-msc | 52 becomes full (1/y/Y) or wraps around and continues until the next 53 window becomes available again (0/n/N).
|
/linux/Documentation/hwmon/ |
H A D | ds620.rst | 31 output pin PO becomes active when the temperature falls below temp1_min and 35 output pin becomes active when the temperature goes above temp1_max and stays
|
/linux/Documentation/mm/ |
H A D | balance.rst | 59 it becomes less significant to consider the free dma pages while 61 becomes more attractive then. 87 low_on_memory gets set. This stays set till the number of free pages becomes
|
/linux/arch/um/include/asm/ |
H A D | tlbflush.h | 16 * we catch all PTE transitions where memory that was unusable becomes usable. 17 * While with flush_tlb_* we can track any memory that becomes unusable and
|
/linux/fs/quota/ |
H A D | quotaio_v2.h | 65 __le32 dqi_bgrace; /* Time before block soft limit becomes hard limit */ 66 __le32 dqi_igrace; /* Time before inode soft limit becomes hard limit */
|
/linux/tools/perf/Documentation/ |
H A D | perf-amd-ibs.txt | 54 -e cpu-cycles:p becomes -e ibs_op// 55 -e r076:p becomes -e ibs_op// 56 -e r0C1:p becomes -e ibs_op/cnt_ctl=1/
|
/linux/tools/perf/pmu-events/arch/x86/grandridge/ |
H A D | virtual-memory.json | 41 …ery cycle. A PMH page walk is outstanding from page walk start till PMH becomes idle again (ready… 84 …very cycle. A PMH page walk is outstanding from page walk start till PMH becomes idle again (ready… 136 …ery cycle. A PMH page walk is outstanding from page walk start till PMH becomes idle again (ready…
|
/linux/drivers/video/fbdev/aty/ |
H A D | mach64_cursor.c | 49 * physical cursor position becomes negative. It will be displayed 52 * If x becomes negative the cursor manager must adjust the CURS_HORZ_OFFSET 55 * if Y becomes negative, CUR_VERT_OFFSET must be adjusted to a larger number,
|
/linux/tools/perf/pmu-events/arch/x86/sierraforest/ |
H A D | virtual-memory.json | 41 …ery cycle. A PMH page walk is outstanding from page walk start till PMH becomes idle again (ready… 84 …very cycle. A PMH page walk is outstanding from page walk start till PMH becomes idle again (ready… 136 …ery cycle. A PMH page walk is outstanding from page walk start till PMH becomes idle again (ready…
|
/linux/tools/perf/pmu-events/arch/arm64/thead/yitian710/sys/ |
H A D | ali_drw.json | 52 "BriefDescription": "A high priority read becomes critical.", 59 "BriefDescription": "A low priority read becomes critical.", 66 "BriefDescription": "A write becomes critical.",
|
/linux/include/linux/ |
H A D | mii_timestamper.h | 21 * netif_rx() as soon as a timestamp becomes available. One of 27 * as soon as a timestamp becomes available. One of the PTP_CLASS_
|
/linux/tools/testing/selftests/bpf/progs/ |
H A D | refcounted_kptr_fail.c | 46 /* m becomes an owning ref but is never drop'd or added to a tree */ in rbtree_refcounted_node_ref_escapes() 85 /* m becomes an owning ref but is never drop'd or added to a tree */ in rbtree_refcounted_node_ref_escapes_owning_input()
|
/linux/rust/kernel/sync/ |
H A D | locked_by.rs | 90 // If `T` is `Sync`, then the `access` method also becomes available, which allows you to obtain 99 /// data becomes inaccessible; if another instance of the owner is allocated *on the same 100 /// memory location*, the data becomes accessible again: none of this affects memory safety
|
/linux/drivers/rpmsg/ |
H A D | rpmsg_core.c | 149 * one becomes available, or a timeout of 15 seconds elapses. When the latter 178 * one becomes available, or a timeout of 15 seconds elapses. When the latter 209 * one becomes available, or a timeout of 15 seconds elapses. When the latter 239 * return -ENOMEM without waiting until one becomes available. 267 * return -ENOMEM without waiting until one becomes available. 317 * return -ENOMEM without waiting until one becomes available.
|