/freebsd/sys/contrib/device-tree/Bindings/sound/ |
H A D | cs35l36.txt | 79 When the threshold is met, the overtemperature warning attenuation is applied 113 - cirrus,cirrus,vpbr-atk-rate : Attenuation attack step rate. Configures the 114 amount delay between consecutive volume attenuation steps when a brownout 118 brownout prevention attacking attenuation step size when operating in either 121 - cirrus,vpbr-max-attn : Maximum attenuation that the VP brownout prevention 125 no longer being present and the VP brownout prevention entering an attenuation 128 - cirrus,vpbr-rel-rate : Attenuation release step rate. Configures the delay 129 between consecutive volume attenuation release steps when a brownout condition 130 is not longer present and the VP brownout is in an attenuation release state.
|
H A D | max98504.txt | 19 - maxim,brownout-attenuation - the brownout attenuation to the speaker gain
|
H A D | maxim,max98504.yaml | 39 maxim,brownout-attenuation: 44 Brownout attenuation to the speaker gain applied during the "attack hold"
|
H A D | nvidia,tegra210-mvc.yaml | 10 The Master Volume Control (MVC) provides gain or attenuation to a digital
|
/freebsd/sys/contrib/device-tree/Bindings/iio/frequency/ |
H A D | adi,admfm2000.yaml | 64 attenuation-gpios: 66 Choice of attenuation: 86 - attenuation-gpios 107 attenuation-gpios = <&gpio 17 GPIO_ACTIVE_LOW>, 120 attenuation-gpios = <&gpio 0 GPIO_ACTIVE_LOW>,
|
/freebsd/sys/dev/sound/macio/ |
H A D | davbusreg.h | 98 /* Attenuation of each analog output port. */ 257 /* cc2: headphones/external port attenuation */ 258 /* cc4: internal speaker attenuation */ 260 * Bits 9-6 specify left DAC output attenuation. 261 * Bits 3-0 specify right DAC output attenuation. 263 * The attenuation is a 4-bit value expressed in units of -1.5 dB,
|
/freebsd/sys/dev/bwi/ |
H A D | bwimac.c | 519 /* Set BBP attenuation */ in bwi_mac_set_tpctl_11bg() 522 /* Set RF attenuation */ in bwi_mac_set_tpctl_11bg() 597 /* Calc BBP attenuation */ in bwi_mac_setup_tpctl() 618 * Calc RF attenuation in bwi_mac_setup_tpctl() 1694 * RF attenuation affects TX power BWI_RF_ATTEN_FACTOR times in bwi_mac_balance_atten() 1695 * as much as BBP attenuation, so we try our best to keep RF in bwi_mac_balance_atten() 1696 * attenuation within range. BBP attenuation will be clamped in bwi_mac_balance_atten() 1699 * BWI_RF_ATTEN_MAX0 is used as RF attenuation upper limit. in bwi_mac_balance_atten() 1703 * Use BBP attenuation to balance RF attenuation in bwi_mac_balance_atten() 1716 * If possible, use RF attenuation to balance BBP attenuation in bwi_mac_balance_atten() [all …]
|
H A D | if_bwivar.h | 373 uint16_t bbp_atten; /* BBP attenuation: 4bits */ 374 uint16_t rf_atten; /* RF attenuation */
|
/freebsd/sys/contrib/device-tree/Bindings/scsi/ |
H A D | hisilicon-sas.txt | 56 - hisilicon,signal-attenuation : array of 3 32-bit values, containing de-emphasis, 57 preshoot, and boost attenuation readings for the board. They 58 are used to describe the signal attenuation of the board. These
|
/freebsd/sys/contrib/device-tree/Bindings/phy/ |
H A D | fsl,imx8mq-usb-phy.yaml | 71 fsl,phy-pcs-tx-deemph-3p5db-attenuation-db: 73 Adjust TX de-emphasis attenuation in dB at nominal
|
/freebsd/sys/contrib/device-tree/Bindings/ata/ |
H A D | imx-sata.txt | 20 - fsl,transmit-atten-16ths : transmit attenuation, in 16ths
|
H A D | sata_highbank.yaml | 59 Contains TX attenuation override codes, one per port.
|
H A D | imx-sata.yaml | 54 description: transmit attenuation, in 16ths.
|
/freebsd/sys/contrib/device-tree/Bindings/iio/light/ |
H A D | us5182d.txt | 8 - upisemi,glass-coef: glass attenuation factor - compensation factor of
|
H A D | upisemi,us5182.yaml | 22 glass attenuation factor - compensation factor of resolution 1000
|
/freebsd/tools/tools/ath/athprom/ |
H A D | eeprom-3 | 19 | txrx Attenuation $txrxAtten | Capabilities $capField | 85 | txrx Attenuation $txrxAtten | Capabilities $capField | 133 | txrx Attenuation $txrxAtten | Capabilities $capField |
|
H A D | eeprom-4 | 22 | txrx Attenuation $txrxAtten | Capabilities $capField | 95 | txrx Attenuation $txrxAtten | Capabilities $capField | 160 | txrx Attenuation $txrxAtten | Capabilities $capField |
|
H A D | eeprom-5 | 23 | txrx Attenuation $txrxAtten | Capabilities $capField | 109 | txrx Attenuation $txrxAtten | Capabilities $capField | 187 | txrx Attenuation $txrxAtten | Capabilities $capField |
|
/freebsd/sys/contrib/device-tree/Bindings/iio/amplifiers/ |
H A D | adi,hmc425a.yaml | 14 Offer various frequency and attenuation ranges.
|
/freebsd/sys/arm/freescale/imx/ |
H A D | imx6_ahci.c | 274 IOMUX_GPR13_SATA_PHY_4(4) | /* Tx Attenuation 9/16 */ in imx6_ahci_attach()
|
/freebsd/sys/contrib/dev/iwlwifi/mvm/ |
H A D | phy-ctxt.c | 93 * the case where we're far enough from the AP that attenuation in iwl_mvm_phy_ctxt_set_rxchain()
|
/freebsd/sys/dev/iwm/ |
H A D | if_iwm_phy_ctxt.c | 222 * the case where we're far enough from the AP that attenuation in iwm_phy_ctxt_cmd_data()
|
/freebsd/sys/dev/ath/ath_hal/ar5212/ |
H A D | ar5212_rfgain.c | 176 * region of our current variable attenuation window
|
/freebsd/share/man/man4/ |
H A D | pcm.4 | 404 Increase to give more room for attenuation control.
|
/freebsd/sys/dev/sound/pcm/ |
H A D | feeder_matrix.c | 245 * multiple channels, apply a slight attenuation to in feed_matrix_setup()
|