| /linux/tools/testing/selftests/drivers/net/hw/ |
| H A D | ethtool.sh | 181 # Test that when one device advertises a subset of speeds and another
182 # advertises a specific speed (but all modes of this speed), the links
219 # Test that when one device advertises a subset of speeds, the other
|
| /linux/drivers/net/phy/ |
| H A D | linkmode.c | 87 * if the other end also advertises Pause.
|
| /linux/drivers/gpu/drm/imagination/ |
| H A D | pvr_mmu.h | 72 * hardware has been created which advertises an unsupported value.
|
| /linux/include/linux/ |
| H A D | usb_usual.h | 74 /* Device advertises UAS but it is broken */ \
|
| /linux/Documentation/driver-api/ |
| H A D | switchtec.rst | 7 Switchtec device advertises a special management endpoint which
|
| /linux/include/ufs/ |
| H A D | ufs_quirks.h | 62 * if device advertises RX_MIN_ACTIVATETIME_CAPABILITY less than 1ms.
|
| /linux/drivers/mtd/spi-nor/ |
| H A D | issi.c | 17 * IS25LP256 supports 4B opcodes, but the BFPT advertises in is25lp256_post_bfpt_fixups()
|
| /linux/Documentation/infiniband/ |
| H A D | ipoib.rst | 60 If the IB HW supports IPoIB stateless offloads, IPoIB advertises
|
| /linux/Documentation/ABI/stable/ |
| H A D | sysfs-bus-usb | 129 than it advertises. The bLength field of each (sub) descriptor
|
| /linux/drivers/hwmon/pmbus/ |
| H A D | dps920ab.c | 24 * PSU advertises that all features are supported, in dps920ab_read_word_data()
|
| /linux/drivers/virtio/ |
| H A D | Kconfig | 187 advertises and to set filter for features used by driver.
|
| /linux/Documentation/networking/ |
| H A D | checksum-offloads.rst | 63 which only advertises NETIF_F_IP[V6]_CSUM must still obey the csum_start and
|
| /linux/drivers/cxl/core/ |
| H A D | pmem.c | 16 * platform firmware advertises at least one persistent memory capable
|
| /linux/arch/arm/include/asm/ |
| H A D | cputype.h | 271 * but advertises itself as v5 as it does not support the v6 ISA. For
|
| /linux/drivers/staging/greybus/ |
| H A D | i2c.c | 36 * can support it (based on the protocol version it advertises).
|
| /linux/drivers/mmc/core/ |
| H A D | quirks.h | 150 * Kingston EMMC04G-M627 advertises TRIM but it does not seems to
|
| /linux/drivers/acpi/apei/ |
| H A D | hest.c | 179 * Check if firmware advertises firmware first mode. We need FF bit to be set
|
| /linux/include/xen/interface/io/ |
| H A D | netif.h | 45 * advertises it via xenstore as 0 (disabled) or 1 (enabled).
125 * it may set "request-multicast-control". If the backend only advertises
129 * value will have no effect. However, if the backend also advertises
|
| /linux/drivers/perf/ |
| H A D | arm_pmu_acpi.c | 33 * have an interrupt. QEMU advertises this by using a GSI of zero, in arm_pmu_acpi_register_irq()
|
| /linux/drivers/iommu/intel/ |
| H A D | pasid.c | 492 * If hardware advertises no support for second level in intel_pasid_setup_second_level()
537 * If hardware advertises no support for second level in intel_pasid_replace_second_level()
|
| /linux/drivers/net/ethernet/netronome/nfp/ |
| H A D | nfp_net_repr.c | 370 netdev_warn(netdev, "Device advertises both TSO2 and TXVLAN. Refusing to enable TXVLAN.\n"); in nfp_repr_init()
|
| /linux/drivers/parisc/ |
| H A D | iosapic.c | 72 ** when lba driver advertises the presence of the I/O sapic by calling
716 * it advertises INT D for INT_PIN. Use that IRT entry to get the in iosapic_fixup_irq()
|
| /linux/Documentation/arch/arm64/ |
| H A D | memory-tagging-extension.rst | 30 supported by the hardware, the kernel advertises the feature to
|
| /linux/Documentation/admin-guide/ |
| H A D | thunderbolt.rst | 18 software connection manager in Linux also advertises security level
|
| /linux/Documentation/networking/device_drivers/ethernet/intel/ |
| H A D | e1000.rst | 346 - The default operation is auto-negotiate. The board advertises all
|