Home
last modified time | relevance | path

Searched full:vmon (Results 1 – 25 of 41) sorted by relevance

12

/linux/drivers/regulator/
H A Dda9063-regulator.c88 struct reg_field vmon; member
154 struct regmap_field *vmon; member
225 return regmap_field_write(regl->vmon, enable ? 1 : 0); in da9063_set_xvp()
610 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BCORE1_MON_EN),
617 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BCORE2_MON_EN),
624 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BPRO_MON_EN),
631 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BMEM_MON_EN),
638 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BIO_MON_EN),
645 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BPERI_MON_EN),
653 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BCORE1_MON_EN),
[all …]
/linux/Documentation/hwmon/
H A Dzl6100.rst214 in2_label "vmon"
215 in2_input Measured voltage on VMON (ZL2004) or VDRV (ZL9101M,
218 in2_lcrit Critical minimum VMON/VDRV Voltage.
219 in2_crit Critical maximum VMON/VDRV voltage.
220 in2_lcrit_alarm VMON/VDRV voltage critical low alarm.
221 in2_crit_alarm VMON/VDRV voltage critical high alarm.
223 vmon attributes are supported on ZL2004, ZL8802,
H A Dlt7182s.rst67 in[3-5]_label "vmon[1-3]"
H A Dlm25066.rst106 in2_label "vmon"
/linux/Documentation/devicetree/bindings/sound/
H A Dmaxim,max98925.yaml28 vmon-slot-no:
50 Interleave mode provides a means to output VMON and IMON data from two
68 vmon-slot-no:
95 vmon-slot-no = <1>;
H A Dcs35l32.txt29 0 = Left/right channels VMON[11:0], IMON[11:0], VPMON[7:0].
30 1 = Left/right channels VMON[11:0], IMON[11:0], STATUS.
31 2 = (Default) left/right channels VMON[15:0], IMON [15:0].
H A Dmax98373.txt13 - maxim,vmon-slot-no : slot number used to send voltage information
36 maxim,vmon-slot-no = <0>;
H A Dadi,max98388.yaml31 adi,vmon-slot-no:
74 adi,vmon-slot-no = <0>;
H A Dcs35l35.txt125 - cirrus,vmon : 3 8 bit values to set the depth, location, and frame
126 of the VMON monitor signal.
174 cirrus,vmon = /bits/ 8 <0x03 0x00 0x00>;
H A Dadi,max98396.yaml42 adi,vmon-slot-no:
137 adi,vmon-slot-no = <0>;
H A Dcs35l36.txt49 - cirrus,vmon-pol-inv : Boolean to determine Amplifier will invert the
50 polarity of outbound VMON feedback data
/linux/sound/soc/codecs/
H A Dcs35l41.c265 "Zero", "ASPRX1", "ASPRX2", "VMON", "IMON",
564 SND_SOC_DAPM_SUPPLY("VMON", CS35L41_PWR_CTRL2, 12, 0, NULL, 0),
570 SND_SOC_DAPM_ADC("VMON ADC", NULL, SND_SOC_NOPM, 0, 0),
601 {"ASP TX1 Source", "VMON", "VMON ADC"},
609 {"ASP TX2 Source", "VMON", "VMON ADC"},
617 {"ASP TX3 Source", "VMON", "VMON ADC"},
625 {"ASP TX4 Source", "VMON", "VMO
[all...]
H A Dcs35l36.c604 "Zero Fill", "ASPRX1", "VMON", "IMON", "ERRVOL", "VPMON", "VBSTMON"
682 SND_SOC_DAPM_ADC("VMON ADC", NULL, CS35L36_PWR_CTRL2, 12, 0),
696 {"VMON ADC", NULL, "VSENSE"},
699 {"ASPTX1SRC", "VMON", "VMON ADC"},
704 {"ASPTX2SRC", "VMON", "VMON ADC"},
709 {"ASPTX3SRC", "VMON", "VMON ADC"},
714 {"ASPTX4SRC", "VMON", "VMON ADC"},
719 {"ASPTX5SRC", "VMON", "VMON ADC"},
724 {"ASPTX6SRC", "VMON", "VMON ADC"},
1477 "cirrus,vmon-pol-inv"); in cs35l36_handle_of_data()
H A Dmax98926.c56 { 0x22, 0x00 }, /* DOUT Configuration VMON */
301 /* set VMON slots */ in max98926_set_sense_data()
535 if (!of_property_read_u32(i2c->dev.of_node, "vmon-slot-no", &value)) { in max98926_i2c_probe()
537 dev_err(&i2c->dev, "vmon slot number is wrong:\n"); in max98926_i2c_probe()
H A Dmax98373.c80 SND_SOC_DAPM_SIGGEN("VMON"),
316 { "VI Sense", "Switch", "VMON" },
377 /* Enable IMON VMON DC blocker */ in max98373_probe()
471 if (!device_property_read_u32(dev, "maxim,vmon-slot-no", &value)) in max98373_slot_config()
H A Dmax98925.c59 { 0x22, 0x00 }, /* DOUT Configuration VMON */
277 /* set VMON slots */ in max98925_set_sense_data()
580 if (!of_property_read_u32(i2c->dev.of_node, "vmon-slot-no", &value)) { in max98925_i2c_probe()
582 dev_err(&i2c->dev, "vmon slot number is wrong:\n"); in max98925_i2c_probe()
H A Dtas2770.c194 SND_SOC_DAPM_SIGGEN("VMON"),
206 {"VSENSE", "Switch", "VMON"},
779 rc = fwnode_property_read_u32(dev->fwnode, "ti,vmon-slot-no", in tas2770_parse_dt()
783 "ti,vmon-slot-no"); in tas2770_parse_dt()
H A Dcs35l45.c303 "VMON", "IMON", "ERR_VOL",
337 "VMON", "IMON", "ERR_VOL",
444 SND_SOC_DAPM_ADC("VMON", NULL, SND_SOC_NOPM, 0, 0),
489 { name" Source", "VMON", "VMON" }, \
509 { "VMON", NULL, "VMON_SRC" },
515 { "VMON", NULL, "VMON_EN" },
H A Dtas2780.c114 SND_SOC_DAPM_SIGGEN("VMON"),
125 {"VSENSE", "Switch", "VMON"},
583 ret = fwnode_property_read_u32(dev->fwnode, "ti,vmon-slot-no", in tas2780_parse_dt()
H A Dmax98927.c528 SND_SOC_DAPM_SIGGEN("VMON"),
621 { "VI Sense", "Switch", "VMON" },
670 /* Enable IMON VMON DC blocker */ in max98927_probe()
787 if (!device_property_read_u32(dev, "vmon-slot-no", &value)) in max98927_slot_config()
H A Dmax98388.c127 SND_SOC_DAPM_SIGGEN("VMON"),
381 { "ADC Voltage", NULL, "VMON"},
432 /* Enable IMON VMON DC blocker */ in max98388_probe()
907 if (!device_property_read_u32(dev, "adi,vmon-slot-no", &value)) in max98388_read_deveice_property()
H A Dtas2764.c212 SND_SOC_DAPM_SIGGEN("VMON"),
224 {"VSENSE", "Switch", "VMON"},
861 ret = fwnode_property_read_u32(dev->fwnode, "ti,vmon-slot-no", in tas2764_parse_dt()
/linux/drivers/hwmon/pmbus/
H A Dzl6100.c339 * an extra voltage (VMON for ZL2004, ZL8802 and ZLS4009, in zl6100_probe()
340 * VDRV for ZL9101M and ZL9117M). Report it as vmon. in zl6100_probe()
/linux/tools/arch/x86/include/uapi/asm/
H A Dvmx.h124 { EXIT_REASON_VMON, "VMON" }, \
/linux/arch/x86/include/uapi/asm/
H A Dvmx.h125 { EXIT_REASON_VMON, "VMON" }, \

12