Home
last modified time | relevance | path

Searched +full:st +full:- +full:ericsson (Results 1 – 25 of 54) sorted by relevance

123

/freebsd/sys/contrib/device-tree/Bindings/arm/
H A Dux500.yaml1 # SPDX-License-Identifier: GPL-2.0-only
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Linus Walleij <linus.walleij@linaro.org>
18 - description: ST-Ericsson HREF (pre-v60)
20 - const: st-ericsson,mop500
21 - const: st-ericsson,u8500
23 - description: ST-Ericsson HREF520
25 - const: st-ericsson,href520
26 - const: st-ericsson,u8500
[all …]
H A Dste-u300.txt1 ST-Ericsson U300 Device Tree Bindings
4 that pertain to this particular board, such as board-specific GPIOs
13 - compatible: must be "stericsson,u300-syscon".
14 - reg: the base address and size of the system controller.
21 This contains the board-specific information.
22 - compatible: must be "stericsson,s365".
23 - vana15-supply: the regulator supplying the 1.5V to drive the
25 - syscon: a pointer to the syscon node so we can access the
26 syscon registers to set the board as self-powered.
31 model = "ST-Ericsson U300";
[all …]
H A Dste-nomadik.txt1 ST-Ericsson Nomadik Device Tree Bindings
4 that pertain to this particular board, such as board-specific GPIOs.
7 - Nomadik System and reset controller used for basic chip control, clock
9 - compatible: must be "stericsson,nomadik,src"
13 Nomadik NHK-15 board manufactured by ST Microelectronics:
17 compatible="st,nomadik-nhk-15";
23 compatible="calaosystems,usb-s8815";
25 Required node: usb-s8815
29 usb-s8815 {
30 ethernet-gpio {
[all …]
/freebsd/sys/contrib/device-tree/Bindings/arm/ux500/
H A Dboards.txt1 ST-Ericsson Ux500 boards
2 ------------------------
5 compatible = "st-ericsson,mop500" (legacy)
6 compatible = "st-ericsson,u8500"
10 soc: represents the system-on-chip and contains the chip
20 compatible = "ste,dbx500-backupram"
25 interrupt-controller:
26 see binding for interrupt-controller/arm,gic.txt
29 see binding for timer/arm,twd-timer.yaml
36 /dts-v1/;
[all …]
H A Dpower_domain.txt1 * ST-Ericsson UX500 PM Domains
12 - compatible: Must be "stericsson,ux500-pm-domains".
13 - #power-domain-cells : Number of cells in a power domain specifier, must be 1.
17 compatible = "stericsson,ux500-pm-domains";
18 #power-domain-cells = <1>;
24 - power-domains: A phandle and PM domain specifier. Below are the list of
28 ----- ---------
34 power-domains = <&pm_domains DOMAIN_VAPE>
/freebsd/sys/contrib/device-tree/src/arm/st/
H A Dste-hrefprev60-tvk.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * Copyright 2012 ST-Ericsson AB
6 /dts-v1/;
7 #include "ste-db850
[all...]
H A Dste-hrefprev60-stuib.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * Copyright 2012 ST-Ericsson AB
6 /dts-v1/;
7 #include "ste-db850
[all...]
H A Dste-hrefv60plus-stuib.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * Copyright 2012 ST-Ericsson AB
5 * Device Tree for the HREF version 60 or later with the ST UIB
8 /dts-v
[all...]
H A Dste-hrefv60plus-tvk.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * Copyright 2012 ST-Ericsson AB
8 /dts-v1/;
9 #include "ste-db850
[all...]
H A Dste-href520-tvk.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
6 /dts-v1/;
7 #include "ste-db8520.dtsi"
8 #include "ste-href-ab8505.dtsi"
9 #include "ste-hrefv60plu
[all...]
H A Dste-hrefv60plus.dtsi1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * Copyright 2012 ST-Ericsson AB
6 #include "ste-href.dtsi"
9 model = "ST
[all...]
H A Dste-href-stuib.dtsi1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * Copyright 2012 ST-Ericsson AB
6 #include <dt-bindings/interrupt-controller/irq.h>
10 compatible = "gpio-keys";
11 #address-cells = <1>;
12 #size-cells = <0>;
13 vdd-supply = <&ab8500_ldo_aux1_reg>;
14 pinctrl-names = "default";
15 pinctrl-0 = <&prox_stuib_mode>, <&hall_stuib_mode>;
33 stmpe1601: port-expander@40 {
[all …]
H A Dste-nomadik-s8815.dts1 // SPDX-License-Identifier: GPL-2.0
3 * Device Tree for the ST-Ericsson Nomadik S8815 board
7 /dts-v1/;
8 #include <dt-bindings/interrupt-controller/irq.h>
9 #include "ste-nomadik-stn8815.dtsi"
12 model = "Calao Systems USB-S8815";
13 compatible = "calaosystems,usb-s8815";
26 mmcsd-gpio {
27 gpio-hog;
29 output-low;
[all …]
/freebsd/sys/contrib/device-tree/include/dt-bindings/pinctrl/
H A Dnomadik.h1 /* SPDX-License-Identifier: GPL-2.0-only */
5 * Copyright (C) ST-Ericsson SA 2013
6 * Author: Gabriel Fernandez <gabriel.fernandez@st.com> for ST-Ericsson.
/freebsd/sys/contrib/device-tree/Bindings/display/
H A Dste,mcde.txt1 ST-Ericsson Multi Channel Display Engine MCDE
3 The ST-Ericsson MCDE is a display controller with support for compositing
5 LCD displays or bridges. It is used in the ST-Ericsson U8500 platform.
9 - compatible: must be:
11 - reg: register base for the main MCDE control registers, should be
13 - interrupts: the interrupt line for the MCDE
14 - epod-supply: a phandle to the EPOD regulator
15 - vana-supply: a phandle to the analog voltage regulator
16 - clocks: an array of the MCDE clocks in this strict order:
21 - clock-names: must be the following array:
[all …]
/freebsd/sys/contrib/device-tree/Bindings/timer/
H A Dst,nomadik-mtu.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
4 ---
5 $id: http://devicetree.org/schemas/timer/st,nomadik-mtu.yaml#
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
8 title: ST Microelectronics Nomadik Multi-Timer Unit MTU Timer
11 - Linus Walleij <linus.walleij@linaro.org>
13 description: This timer is found in the ST Microelectronics Nomadik
14 SoCs STn8800, STn8810 and STn8815 as well as in ST-Ericsson DB8500.
19 - const: st,nomadik-mtu
32 clock-names:
[all …]
H A Dstericsson-u300-apptimer.txt1 ST-Ericsson U300 apptimer
5 - compatible : should be "stericsson,u300-apptimer"
6 - reg : Specifies base physical address and size of the registers.
7 - interrupts : A list of 4 interrupts; one for each subtimer. These
10 then GP1 and GP2, which are general-purpose timers.
15 compatible = "stericsson,u300-apptimer";
/freebsd/sys/contrib/device-tree/Bindings/pinctrl/
H A Dste,nomadik.txt1 ST Ericsson Nomadik pinmux controller
4 - compatible: "stericsson,db8500-pinctrl", "stericsson,db8540-pinctrl",
5 "stericsson,stn8815-pinctrl"
6 - nomadik-gpio-chips: array of phandles to the corresponding GPIO chips
8 - prcm: phandle to the PRCMU managing the back end of this pin controller
10 Please refer to pinctrl-bindings.txt in this directory for details of the
14 ST Ericsson's pin configuration nodes act as a container for an arbitrary number of
23 (see pinctrl-bindings.txt):
26 - function: A string containing the name of the function to mux to the
28 - groups : An array of strings. Each string contains the name of a pin
[all …]
H A Dste,abx500.txt1 ST Ericsson abx500 pinmux controller
4 - compatible: "stericsson,ab8500-gpio", "stericsson,ab8540-gpio",
5 "stericsson,ab8505-gpio", "stericsson,ab9540-gpio",
7 Please refer to pinctrl-bindings.txt in this directory for details of the
11 ST Ericsson's pin configuration nodes use the generic pin multiplexing
12 and pin configuration bindings, see pinctrl-bindings.txt
17 pinctrl-names = "default";
18 …pinctrl-0 = <&sysclkreq2_default_mode>, <&sysclkreq3_default_mode>, <&gpio3_default_mode>, <&syscl…
28 bias-disable;
40 output-low;
[all …]
/freebsd/sys/contrib/device-tree/Bindings/gpio/
H A Dgpio-stericsson-coh901.txt1 ST-Ericsson COH 901 571/3 GPIO controller
4 - compatible: Compatible property value should be "stericsson,gpio-coh901"
5 - reg: Physical base address of the controller and length of memory mapped
7 - interrupts: the 0...n interrupts assigned to the different GPIO ports/banks.
/freebsd/sys/contrib/device-tree/Bindings/rtc/
H A Dstericsson,coh901331.txt1 ST-Ericsson COH 901 331 Real Time Clock
4 - compatible: must be "stericsson,coh901331"
5 - reg: address range of rtc register set.
6 - interrupts: rtc alarm interrupt.
7 - clocks: phandle to the rtc clock source
13 interrupt-parent = <&vicb>;
/freebsd/sys/contrib/device-tree/Bindings/watchdog/
H A Dstericsson-coh901327.txt1 ST-Ericsson COH 901 327 Watchdog timer
4 - compatible: must be "stericsson,coh901327".
5 - reg: physical base address of the controller and length of memory mapped
7 - interrupts: the interrupt used for the watchdog timeout warning.
10 - timeout-sec: contains the watchdog timeout in seconds.
18 timeout-sec = <60>;
/freebsd/sys/contrib/device-tree/Bindings/clock/
H A Dstericsson,abx500.txt1 Clock bindings for ST-Ericsson ABx500 clocks
4 - compatible : shall contain the following:
5 "stericsson,ab8500-clk"
6 - #clock-cells should be <1>
12 dt-bindings/clock/ste-ab8500.h header and can be used in device
17 clock-controller {
18 compatible = "stericsson,ab8500-clk";
19 #clock-cells = <1>;
/freebsd/sys/contrib/device-tree/Bindings/i2c/
H A Dst,nomadik-i2c.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/i2c/st,nomadik-i2c.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: ST Microelectronics Nomadik I2C
9 description: The Nomadik I2C host controller began its life in the ST
11 STn8815. It was part of the prototype STn8500 which then became ST-Ericsson
15 - Linus Walleij <linus.walleij@linaro.org>
23 - st,nomadik-i2c
24 - mobileye,eyeq5-i2c
[all …]
/freebsd/sys/contrib/device-tree/Bindings/dma/
H A Dste-coh901318.txt1 ST-Ericsson COH 901 318 DMA Controller
7 - compatible: should be "stericsson,coh901318"
8 - reg: register locations and length
9 - interrupts: the single DMA IRQ
10 - #dma-cells: must be set to <1>, as the channels on the
12 - dma-channels: the number of DMA channels handled
16 dmac: dma-controller@c00020000 {
19 interrupt-parent = <&vica>;
21 #dma-cells = <1>;
22 dma-channels = <40>;
[all …]

123