| /linux/drivers/gpu/drm/panel/ |
| H A D | panel-samsung-s6d16d0.c | 49 struct s6d16d0 *s6 = panel_to_s6d16d0(panel); in s6d16d0_unprepare() local
50 struct mipi_dsi_device *dsi = to_mipi_dsi_device(s6->dev); in s6d16d0_unprepare()
56 dev_err(s6->dev, "failed to enter sleep mode (%d)\n", ret); in s6d16d0_unprepare()
61 gpiod_set_value_cansleep(s6->reset_gpio, 1); in s6d16d0_unprepare()
62 regulator_disable(s6->supply); in s6d16d0_unprepare()
69 struct s6d16d0 *s6 = panel_to_s6d16d0(panel); in s6d16d0_prepare() local
70 struct mipi_dsi_device *dsi = to_mipi_dsi_device(s6->dev); in s6d16d0_prepare()
73 ret = regulator_enable(s6->supply); in s6d16d0_prepare()
75 dev_err(s6->dev, "failed to enable supply (%d)\n", ret); in s6d16d0_prepare()
80 gpiod_set_value_cansleep(s6->reset_gpio, 1); in s6d16d0_prepare()
[all …]
|
| /linux/arch/riscv/kernel/ |
| H A D | kexec_relocate.S | 22 * s6: (const) Physical address of the main loop
30 mv s6, zero
45 la s6, 1f
46 sub s6, s6, s4
47 csrw CSR_STVEC, s6
74 jr s6
119 mv s6, zero
183 mv s6, zero
|
| /linux/drivers/net/wireless/mediatek/mt7601u/ |
| H A D | eeprom.h | 76 u8 raw; /* validated s6 value */
124 int s6; in s6_to_int() local
126 s6 = s6_validate(reg); in s6_to_int()
127 if (s6 & BIT(5)) in s6_to_int()
128 s6 -= BIT(6); in s6_to_int()
130 return s6; in s6_to_int()
|
| /linux/arch/mips/kernel/ |
| H A D | cps-vec-ns16550.S | 53 move s6, a0
55 1: lb a0, 0(s6)
58 PTR_ADDIU s6, s6, 1
124 move s6, a0
127 move a0, s6
|
| H A D | relocate_kernel.S | 58 li s6, (1 << _PAGE_SHIFT) / SZREG
66 LONG_ADDIU s6, s6, -1
67 beq s6, zero, process_entry
|
| /linux/arch/riscv/include/asm/ |
| H A D | compat.h | 61 compat_ulong_t s6; member
98 cregs->s6 = (compat_ulong_t) regs->s6; in regs_to_cregs()
135 regs->s6 = (unsigned long) cregs->s6; in cregs_to_regs()
|
| /linux/tools/testing/selftests/bpf/prog_tests/ |
| H A D | lwt_seg6local.c | 50 SYS(fail, "ip -n %s6 link set dev lo up", NETNS_BASE); in setup()
96 SYS(fail, "ip -n %s6 -6 addr add fb00::6/16 dev lo", NETNS_BASE); in setup()
97 SYS(fail, "ip -n %s6 -6 addr add fd00::4/16 dev lo", NETNS_BASE); in setup()
103 SYS(fail, "ip netns exec %s6 sysctl -wq net.ipv6.conf.all.seg6_enabled=1", NETNS_BASE); in setup()
104 SYS(fail, "ip netns exec %s6 sysctl -wq net.ipv6.conf.lo.seg6_enabled=1", NETNS_BASE); in setup()
105 SYS(fail, "ip netns exec %s6 sysctl -wq net.ipv6.conf.veth10.seg6_enabled=1", NETNS_BASE); in setup()
|
| /linux/arch/alpha/include/uapi/asm/ |
| H A D | regdef.h | 22 #define s6 $15 macro
23 #define fp s6 /* frame-pointer (s6 in frame-less procedures) */
|
| /linux/drivers/soc/bcm/brcmstb/pm/ |
| H A D | s2-mips.S | 30 sw s6, 28(sp)
87 move s6, t0
167 mtc0 s6, CP0_STATUS
175 lw s6, 28(sp)
|
| H A D | s3-mips.S | 33 sw s6, 28(t0)
120 lw s6, 28(t0)
|
| /linux/drivers/media/dvb-frontends/ |
| H A D | zl10353.c | 363 int s6, s9; in zl10353_get_parameters() local
376 s6 = zl10353_read_register(state, STATUS_6); in zl10353_get_parameters()
378 if (s6 < 0 || s9 < 0) in zl10353_get_parameters()
380 if ((s6 & (1 << 5)) == 0 || (s9 & (1 << 4)) == 0) in zl10353_get_parameters()
453 int s6, s7, s8; in zl10353_read_status() local
455 if ((s6 = zl10353_read_register(state, STATUS_6)) < 0) in zl10353_read_status()
463 if (s6 & (1 << 2)) in zl10353_read_status()
465 if (s6 & (1 << 1)) in zl10353_read_status()
467 if (s6 & (1 << 5)) in zl10353_read_status()
|
| /linux/arch/arm64/boot/dts/amlogic/ |
| H A D | amlogic-s6-s905x5-bl209.dts | 8 #include "amlogic-s6.dtsi"
11 compatible = "amlogic,bl209", "amlogic,s6";
|
| /linux/arch/mips/include/asm/ |
| H A D | asmmacro-64.h | 24 LONG_S s6, THREAD_REG22(\thread)
37 LONG_L s6, THREAD_REG22(\thread)
|
| H A D | asmmacro-32.h | 71 LONG_S s6, THREAD_REG22(\thread)
84 LONG_L s6, THREAD_REG22(\thread)
|
| H A D | regdef.h | 138 #define s6 $22
181 #define s6 $22
|
| /linux/arch/mips/power/ |
| H A D | hibernate_asm.S | 26 PTR_S s6, PT_R22(t0)
56 PTR_L s6, PT_R22(t0)
|
| /linux/arch/loongarch/power/ |
| H A D | hibernate_asm.S | 27 PTR_S s6, t0, PT_R29
61 PTR_L s6, t0, PT_R29
|
| /linux/arch/loongarch/kernel/ |
| H A D | rethook_trampoline.S | 34 cfi_st s6, PT_R29
68 cfi_ld s6, PT_R29
|
| /linux/arch/arm64/crypto/ |
| H A D | sm4-neon-core.S | 50 #define transpose_4x4_2x(s0, s1, s2, s3, s4, s5, s6, s7) \ argument
56 zip1 RTMP5.4s, s6.4s, s7.4s; \
58 zip2 RTMP7.4s, s6.4s, s7.4s; \
65 zip1 s6.2d, RTMP6.2d, RTMP7.2d; \
78 #define rotate_clockwise_4x4_2x(s0, s1, s2, s3, s4, s5, s6, s7) \ argument
84 zip1 RTMP6.4s, s7.4s, s6.4s; \
86 zip2 RTMP7.4s, s7.4s, s6.4s; \
93 zip1 s6.2d, RTMP7.2d, RTMP5.2d; \
|
| /linux/drivers/gpu/drm/amd/amdkfd/ |
| H A D | cwsr_trap_handler_gfx10.asm | 623 s_movrels_b64 s6, s6 //s6 = s[6+m0], s7 = s[7+m0]
650 s_movrels_b64 s6, s6 //s6 = s[6+m0], s7 = s[7+m0]
1155 s_movreld_b64 s6, s6
1167 s_movreld_b64 s6, s6
|
| /linux/lib/crypto/mips/ |
| H A D | chacha-core.S | 22 #define X11 $s6
221 sw $s6, 24($sp)
300 lw $s6, 24($sp)
444 /* Save X11(s6) */
|
| /linux/lib/crypto/riscv/ |
| H A D | chacha-riscv64-zvkb.S | 70 #define KEY6 s6
152 sd s6, 48(sp)
288 ld s6, 48(sp)
|
| /linux/arch/loongarch/include/asm/ |
| H A D | stackframe.h | 116 cfi_st s6, PT_R29, \docfi
235 cfi_ld s6, PT_R29, \docfi
|
| H A D | regdef.h | 37 #define s6 $r29 macro
|
| /linux/tools/testing/selftests/kvm/lib/riscv/ |
| H A D | processor.c | 262 core.regs.s6 = vcpu_get_reg(vcpu, RISCV_CORE_REG(regs.s6)); in vcpu_arch_dump()
291 " S4: 0x%016lx S5: 0x%016lx S6: 0x%016lx S7: 0x%016lx\n", in vcpu_arch_dump()
292 core.regs.s4, core.regs.s5, core.regs.s6, core.regs.s7); in vcpu_arch_dump()
|