| /linux/Documentation/admin-guide/device-mapper/ |
| H A D | delay.rst | 6 and/or flushs and optionally maps them to different devices.
18 to write and flush operations on optionally different write_device with
19 optionally different sector offset
22 on/with optionally different flush_device/flush_offset.
|
| /linux/Documentation/networking/devlink/ |
| H A D | devlink-region.rst | 15 Regions may optionally support triggering snapshots on demand.
27 Regions may optionally support capturing a snapshot on demand via the
34 Regions may optionally allow directly reading from their contents without a
|
| /linux/drivers/pinctrl/ |
| H A D | core.h | 36 * @pin_group_tree: optionally each pin group can be stored in this radix tree
37 * @num_groups: optionally number of groups can be kept here
38 * @pin_function_tree: optionally each function can be stored in this radix tree
39 * @num_functions: optionally number of functions can be kept here
|
| /linux/include/linux/irqchip/ |
| H A D | arm-vgic-info.h | 16 /* Full GICv3, optionally with v2 compat */
18 /* Full GICv5, optionally with v3 compat */
|
| /linux/arch/arm/mach-omap2/ |
| H A D | clkt2xxx_dpll.c | 26 * REVISIT: DPLL can optionally enter low-power bypass by writing 0x1
27 * instead. Add some mechanism to optionally enter this mode.
|
| /linux/Documentation/w1/slaves/ |
| H A D | w1_ds28e04.rst | 21 during memory accesses can optionally be enabled/disabled via the device
22 attribute "crccheck". The strong pull-up can optionally be enabled/disabled
|
| /linux/Documentation/devicetree/bindings/serial/ |
| H A D | brcm,bcm7271-uart.yaml | 32 description: The UART register block and optionally the DMA register blocks.
54 description: The UART interrupt and optionally the DMA interrupt.
|
| /linux/Documentation/firmware-guide/acpi/ |
| H A D | extcon-intel-int3496.rst | 10 USB-otg port, as well as how it optionally can enable Vbus output on the
11 otg port and how it can optionally control the muxing of the data pins
|
| /linux/include/sound/sof/ |
| H A D | dai-intel.h | 138 uint16_t polarity_mic_a; /**< Optionally invert mic A signal (0 or 1) */
139 uint16_t polarity_mic_b; /**< Optionally invert mic B signal (0 or 1) */
141 uint16_t clk_edge; /**< Optionally swap data clock edge (0 or 1) */
|
| /linux/drivers/firmware/arm_scmi/transports/ |
| H A D | Kconfig | 61 transport to optionally ask for atomic SCMI transactions and operate
119 transport to optionally ask for atomic SCMI transactions and operate
|
| /linux/Documentation/devicetree/bindings/arm/keystone/ |
| H A D | ti,sci.yaml | 26 This parent node may optionally have additional children nodes which describe
46 Specifies the debug messages memory mapped region that is optionally
|
| /linux/arch/arm/lib/ |
| H A D | backtrace.S | 47 * optionally saved caller registers (r4 - r10)
52 * optionally saved arguments (r0 - r3)
|
| /linux/include/linux/usb/ |
| H A D | rndis_host.h | 158 struct rndis_keepalive { /* OUT (optionally IN) */
165 struct rndis_keepalive_c { /* IN (optionally OUT) */
|
| /linux/net/netlabel/ |
| H A D | netlabel_mgmt.h | 48 * however the following attribute may optionally be sent:
102 * however the following attribute may optionally be sent:
|
| /linux/Documentation/sound/designs/ |
| H A D | channel-mapping-api.rst | 11 and the current channel map, also optionally to modify the channel map
53 read operation. Optionally, the write operation can be provided to
|
| /linux/drivers/net/usb/ |
| H A D | cx82310_eth.c | 50 * - optionally send some data (command parameters)
51 * - optionally wait for the reply
52 * - optionally read some data from the reply
|
| /linux/include/sound/ |
| H A D | rt5660.h | 19 /* IN1 & IN3 can optionally be differential */
|
| H A D | wm9090.h | 12 /* Line inputs 1 & 2 can optionally be differential */
|
| /linux/arch/arm/boot/dts/marvell/ |
| H A D | armada-385-clearfog-gtr.dtsi | 10 0. SATA1 on CON18, or optionally mini PCIe CON3 - PCIe0
12 2. SATA0 on CON17, or optionally mini PCIe CON4 - PCIe1
15 5. SFP connector, or optionally SGMII Ethernet 1512 PHY
|
| /linux/Documentation/admin-guide/mm/ |
| H A D | pagemap.rst | 230 The ``PAGEMAP_SCAN`` IOCTL on the pagemap file can be used to get or optionally
262 operation is optionally performed depending upon if the output buffer is
315 have been written to since they were last marked and/or optionally write protect
|
| /linux/Documentation/driver-api/gpio/ |
| H A D | drivers-on-gpio.rst | 59 of wires, at least SCK and optionally MISO, MOSI and chip select lines) using
70 system, connected to a GPIO line (and optionally a GPIO alarm line),
|
| /linux/include/keys/ |
| H A D | asymmetric-parser.h | 25 * that the caller can optionally use for the key.
|
| /linux/include/linux/ |
| H A D | pfn.h | |
| /linux/Documentation/devicetree/bindings/gpio/ |
| H A D | gpio-adnp.txt | 13 The GPIO expander can optionally be used as an interrupt controller, in
|
| /linux/Documentation/devicetree/bindings/pwm/ |
| H A D | pwm.yaml | 22 optionally a number of flags (defined in <dt-bindings/pwm/pwm.h>).
|