Searched full:ospm (Results 1 – 20 of 20) sorted by relevance
114 firmware and OSPM. It is a mechanism for coordinating processor117 The PCC driver (pcc-cpufreq) allows OSPM to take advantage of the PCC150 or throttle states (_PSS, _TSS and related ACPI objects) to OSPM. Therefore,154 However, OSPM remains in control of policy. The governor (eg: "ondemand")167 This command is used by the OSPM to query the running frequency of the175 This command is used by the OSPM to communicate to the platform firmware the177 ignored by OSPM. The next invocation of "Get Average Frequency" will inform178 OSPM if the desired frequency was achieved or not.238 by OSPM. An example:267 PCC do not implement SW_ALL. So OSPM doesn't need to perform any coordination
102 ISA bus), OSPM enumerates the devices' identifier(s) and the ACPI104 enable OSPM to do that.114 [_SRS]. The information is used by the Plug and Play OS (OSPM) to118 OSPM uses device configuration objects to configure hardware resources124 When OSPM enumerates a device, it calls _PRS to determine the resource
15 /* Only 2 out of 4 is allowed for OSPM */
4 * for Intel processors. Those bits are used to convey OSPM
48 On reading this entry after an OSPM resume,50 the card was previously shutdown during OSPM
87 这些信息被即插即用操作系统（OSPM）用来配置设备。
9 * handler receives control and processes the error. This gives OSPM a
428 * OSPM supports platform coordinated low power idle(LPI) states434 * ACPI 6.2 Section 6.2.11.2 'Platform-Wide OSPM Capabilities':437 * spaces. OSPM support for this more flexible register space scheme is734 * After initiating graceful shutdown, the ACPI spec requires OSPM in sb_notify_work()
62 * We need to take read_lock and check if channel belongs to OSPM369 * "The minimum amount of time that OSPM must wait after the completion in send_pcc_cmd()2153 * is still with OSPM. in cppc_set_perf()2205 * These bits are sticky and remain set until OSPM explicitly clears them.2255 * pcc_mrtt - The minimum amount of time that OSPM must wait after the in cppc_get_transition_latency()
22 management (OSPM) software. This option will enlarge your
630 * of the OSPM to clear the status bit [ implying that the in acpi_suspend_enter()
50 /* FIXME: Move APM/OSPM base into relevant device code */ in gma_power_init()
14 that OSPM supports"
66 OSPM Loading |
20 * by the SCMI platform to an OSPM like Linux.
663 * Check whether the system is DMI table. If yes, OSPM in acpi_proc_quirk_mwait_check()
258 * bit 0 indicates that Platform is sending a notification and OSPM in pcc_mbox_cmd_complete_check()
727 to notify the OSPM of errors that have occurred but can be corrected and the
587 * 2) SCI_EN: OSPM always preserves this bit position
712 /* _OST Source Event Code (OSPM Action) */