Home
last modified time | relevance | path

Searched +full:omap +full:- +full:l1x (Results 1 – 4 of 4) sorted by relevance

/linux/drivers/usb/musb/
H A DKconfig1 # SPDX-License-Identifier: GPL-2.0
3 # USB Dual Role (OTG-ready) Controller Drivers
7 # (M)HDRC = (Multipoint) Highspeed Dual-Role Controller
20 (35x, 644x ...), OMAP 243x, OMAP 3, and TUSB 6010.
27 module will be called "musb-hdrc".
74 tristate "DA8xx/OMAP-L1x"
160 depends on USB_MUSB_TUSB6010 = USB_MUSB_HDRC # both built-in or both modules
163 Enable DMA transfers on TUSB 6010 when OMAP DMA is available.
H A Dda8xx.c1 // SPDX-License-Identifier: GPL-2.0
3 * Texas Instruments DA8xx/OMAP-L1x "glue layer"
5 * Copyright (c) 2008-2009 MontaVista Software, Inc. <source@mvista.com>
8 * Copyright (C) 2005-2006 by Texas Instruments
25 #include <linux/dma-mapping.h>
48 #define DA8XX_USB_GENERIC_RNDIS_EP_SIZE_REG(n) (0x50 + (((n) - 1) << 2))
78 * - not read/write INTRUSB/INTRUSBE (except during
80 * - use INTSET/INTCLR instead.
84 * da8xx_musb_enable - enable interrupts
88 void __iomem *reg_base = musb->ctrl_base; in da8xx_musb_enable()
[all …]
/linux/Documentation/devicetree/bindings/interrupt-controller/
H A Dti,cp-intc.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/interrupt-controller/ti,cp-intc.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Bartosz Golaszewski <brgl@bgdev.pl>
13 Common Platform Interrupt Controller (cp_intc) is used on OMAP-L1x SoCs and
18 const: ti,cp-intc
23 interrupt-controller: true
25 '#interrupt-cells':
29 ti,intc-size:
[all …]
/linux/Documentation/devicetree/bindings/usb/
H A Dda8xx-usb.txt3 For DA8xx/OMAP-L1x/AM17xx/AM18xx platforms.
7 - compatible : Should be set to "ti,da830-musb".
9 - reg: Offset and length of the USB controller register set.
11 - interrupts: The USB interrupt number.
13 - interrupt-names: Should be set to "mc".
15 - dr_mode: The USB operation mode. Should be one of "host", "peripheral" or "otg".
17 - phys: Phandle for the PHY device
19 - phy-names: Should be "usb-phy"
21 - dmas: specifies the dma channels
23 - dma-names: specifies the names of the channels. Use "rxN" for receive
[all …]