Searched full:mx53 (Results 1 – 23 of 23) sorted by relevance
| /linux/arch/arm/mach-imx/ |
| H A D | Kconfig | 109 bool "i.MX53 support"
113 This enables support for Freescale i.MX53 processor.
|
| H A D | mach-imx53.c | 34 DT_MACHINE_START(IMX53_DT, "Freescale i.MX53 (Device Tree Support)")
|
| H A D | hardware.h | 73 * mx53:
|
| H A D | pm-imx5.c | 142 * mx5 because it can be used for mx51, and mx53.
|
| /linux/Documentation/devicetree/bindings/rtc/ |
| H A D | rtc-mxc_v2.yaml | 7 title: i.MX53 Secure Real Time Clock (SRTC)
|
| /linux/Documentation/devicetree/bindings/nvmem/ |
| H A D | imx-iim.yaml | 16 i.MX25, i.MX27, i.MX31, i.MX35, i.MX51 and i.MX53 SoCs.
|
| /linux/Documentation/networking/device_drivers/can/freescale/ |
| H A D | flexcan.rst | 19 and i.MX53 SOCs) only receive RTR frames if the controller is
|
| /linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx53-qsb.dts | 10 model = "Freescale i.MX53 Quick Start Board";
|
| H A D | imx53-usbarmory.dts | 79 * Not every i.MX53 P/N supports clock > 800MHz.
|
| /linux/drivers/rtc/ |
| H A D | rtc-mxc_v2.c | 3 * Real Time Clock (RTC) Driver for i.MX53
390 MODULE_DESCRIPTION("Real Time Clock (RTC) Driver for i.MX53");
|
| H A D | Kconfig | 1815 tristate "Freescale MXC Real Time Clock for i.MX53"
1821 SRTC module in i.MX53 processor.
|
| /linux/drivers/net/can/flexcan/ |
| H A D | flexcan.h | 28 * MX53 FlexCAN2 03.00.00.00 yes no no no no no 64
|
| H A D | flexcan-core.c | 232 u32 gfwr_mx28; /* MX28, MX53 */
253 * (mx25, mx28, mx35, mx53)
|
| /linux/drivers/soc/imx/ |
| H A D | soc-imx.c | 83 soc_id = "i.MX53"; in imx_soc_device_init()
|
| /linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | fsl,imx35-pinctrl.yaml | 89 Common i.MX50/i.MX51/i.MX53 bits
|
| /linux/drivers/gpu/ipu-v3/ |
| H A D | ipu-di.c | 360 /* PIN4: HSYNC for VGA via TVEv2 on i.MX53-QSB */ in ipu_di_sync_config_noninterlaced()
369 /* PIN6: VSYNC for VGA via TVEv2 on i.MX53-QSB */ in ipu_di_sync_config_noninterlaced()
|
| H A D | ipu-common.c | 344 * i.MX53 channel arbitration locking doesn't seem to work properly. in ipu_idmac_lock_enable()
|
| /linux/drivers/clk/imx/ |
| H A D | clk-imx5.c | 305 * it comes closest in scope to the main_bus_clk of i.MX51 and i.MX53 in mx50_clocks_init()
606 imx_print_silicon_rev("i.MX53", mx53_revision()); in mx53_clocks_init()
|
| /linux/drivers/gpu/drm/imx/ipuv3/ |
| H A D | imx-ldb.c | 532 * i.MX53: ipu1_di0_sel, ipu1_di1_sel in imx_ldb_probe()
|
| /linux/drivers/ata/ |
| H A D | ahci_imx.c | 961 * TIMER1MS register on i.MX53, i.MX6Q and i.MX6QP only. in imx_ahci_probe()
|
| /linux/sound/soc/fsl/ |
| H A D | fsl_asrc.c | 61 /* i.MX53 uses the same map for input and output */
|
| /linux/drivers/mtd/nand/raw/ |
| H A D | mxc_nand.c | 1345 /* v3.2b: i.MX53 */
|
| /linux/drivers/spi/ |
| H A D | spi-imx.c | 70 IMX53_ECSPI, /* ECSPI on i.mx53 and later */
|