| /linux/Documentation/devicetree/bindings/clock/ |
| H A D | imx28-clock.yaml | 7 title: Freescale i.MX28 Clock Controller
14 ID in its "clocks" phandle cell. The following is a full list of i.MX28
|
| /linux/drivers/clocksource/ |
| H A D | mxs_timer.c | 22 * The v1 on MX23 only gets 16 bits counter, while v2 on MX28
26 * another for clocksource. MX28 uses timrot 0 and 1, while MX23
43 * on MX28 while timrot2 on MX23.
|
| /linux/arch/arm/mach-mxs/ |
| H A D | Kconfig | 17 bool "Freescale MXS (i.MX23, i.MX28) support"
|
| /linux/arch/arm/boot/dts/nxp/mxs/ |
| H A D | mxs-pinfunc.h | 3 * Header providing constants for i.MX28 pinctrl bindings.
|
| H A D | imx28-ts4600.dts | 13 model = "Technologic Systems i.MX28 TS-4600";
|
| H A D | imx28-amarula-rmm.dts | 14 model = "Amarula i.MX28 rmm";
|
| H A D | imx28-evk.dts | 9 model = "Freescale i.MX28 Evaluation Kit";
|
| H A D | imx28-pinfunc.h | 3 * Header providing constants for i.MX28 pinctrl bindings.
|
| /linux/Documentation/devicetree/bindings/nvmem/ |
| H A D | mxs-ocotp.yaml | 7 title: On-Chip OTP Memory for Freescale i.MX23/i.MX28
|
| /linux/Documentation/devicetree/bindings/spi/ |
| H A D | mxs-spi.yaml | 7 title: Freescale MX233/MX28 SSP/SPI
|
| /linux/drivers/gpu/drm/mxsfb/ |
| H A D | mxsfb_drv.h | 5 * i.MX23/i.MX28/i.MX6SX MXSFB LCD controller driver.
|
| H A D | mxsfb_regs.h | 6 * i.MX23/i.MX28/i.MX6SX MXSFB LCD controller driver.
|
| /linux/Documentation/devicetree/bindings/crypto/ |
| H A D | fsl-dcp.yaml | 7 title: Freescale DCP (Data Co-Processor) found on i.MX23/i.MX28
|
| /linux/Documentation/devicetree/bindings/soc/fsl/ |
| H A D | fsl,imx23-digctl.yaml | 7 title: Freescale mxs digctrl for i.MX23/i.MX28
|
| /linux/Documentation/devicetree/bindings/net/ |
| H A D | microchip,enc28j60.txt | 28 Example (for NXP i.MX28 with pin control stuff for GPIO irq):
|
| /linux/Documentation/networking/device_drivers/can/freescale/ |
| H A D | flexcan.rst | 18 The older flexcan cores (integrated into the i.MX25, i.MX28, i.MX35
|
| /linux/Documentation/devicetree/bindings/dma/ |
| H A D | fsl,mxs-dma.yaml | 7 title: Freescale Direct Memory Access (DMA) Controller from i.MX23/i.MX28
|
| /linux/drivers/i2c/busses/ |
| H A D | i2c-mxs.c | 106 * @dev_type: distinguish i.MX23/i.MX28 features
143 * For details, see i.MX233 [25.4.2 - 25.4.4] and i.MX28 [27.5.2 - 27.5.4]. in mxs_i2c_reset()
575 * The MX28 I2C IP block can only do PIO READ for transfer of to up in mxs_i2c_xfer_msg()
740 * The hardware (of the i.MX28 at least) seems to add 2 additional in mxs_i2c_derive_timing()
|
| /linux/drivers/rtc/ |
| H A D | rtc-stmp3xxx.c | 125 int timeout = 5000; /* 3ms according to i.MX28 Ref Manual */ in stmp3xxx_wait_time()
127 * The i.MX28 Applications Processor Reference Manual, Rev. 1, 2010 in stmp3xxx_wait_time()
|
| /linux/drivers/mtd/nand/raw/gpmi-nand/ |
| H A D | gpmi-regs.h | 169 /* MX28 uses this to detect READY. */
|
| /linux/include/linux/spi/ |
| H A D | mxs-spi.h | 5 * Freescale i.MX233/i.MX28 SPI controller register definition
|
| /linux/drivers/nvmem/ |
| H A D | mxs-ocotp.c | 194 MODULE_DESCRIPTION("driver for OCOTP in i.MX23/i.MX28");
|
| /linux/drivers/net/can/flexcan/ |
| H A D | flexcan.h | 26 * MX28 FlexCAN2 03.00.04.00 yes yes no no no no 64
|
| /linux/drivers/mfd/ |
| H A D | mxs-lradc.c | 251 MODULE_DESCRIPTION("Freescale i.MX23/i.MX28 LRADC driver");
|
| /linux/drivers/net/can/usb/kvaser_usb/ |
| H A D | kvaser_usb.h | 19 * - Leaf: Based on Renesas M32C or Freescale i.MX28, running firmware labeled
|