Searched +full:mipi +full:- +full:to +full:- +full:edp (Results 1 – 14 of 14) sorted by relevance
/freebsd/sys/contrib/device-tree/Bindings/display/bridge/ |
H A D | ps8640.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: MIPI DSI to eDP Video Format Converter 10 - Nicolas Boichat <drinkcat@chromium.org> 13 The PS8640 is a low power MIPI-to-eDP video format converter supporting 14 mobile devices with embedded panel resolutions up to 2048 x 1536. The 15 device accepts a single channel of MIPI DSI v1.1, with up to four lanes 16 plus clock, at a transmission rate up to 1.5Gbit/sec per lane. The 17 device outputs eDP v1.4, one or two lanes, at a link rate of up to [all …]
|
H A D | ti,sn65dsi86.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: SN65DSI86 DSI to eDP bridge chip 10 - Douglas Anderson <dianders@chromium.org> 13 The Texas Instruments SN65DSI86 bridge takes MIPI DSI in and outputs eDP. 23 enable-gpios: 27 suspend-gpios: 31 no-hpd: 34 Set if the HPD line on the bridge isn't hooked up to anything or is [all …]
|
/freebsd/sys/contrib/device-tree/Bindings/display/mediatek/ |
H A D | mediatek,dsi.txt | 5 drive up to 4-lane MIPI DSI output. Two DSIs can be synchronized for dual- 9 - compatible: "mediatek,<chip>-dsi" 10 - the supported chips are mt2701, mt7623, mt8167, mt8173 and mt8183. 11 - reg: Physical base address and length of the controller's registers 12 - interrupts: The interrupt signal from the function block. 13 - clocks: device clocks 14 See Documentation/devicetree/bindings/clock/clock-bindings.txt for details. 15 - clock-names: must contain "engine", "digital", and "hs" 16 - phys: phandle link to the MIPI D-PHY controller. 17 - phy-names: must contain "dphy" [all …]
|
H A D | mediatek,dsi.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Chun-Kuang Hu <chunkuang.hu@kernel.org> 11 - Philipp Zabel <p.zabel@pengutronix.de> 12 - Jitao Shi <jitao.shi@mediatek.com> 16 drive up to 4-lane MIPI DSI output. Two DSIs can be synchronized for dual- 20 - $ref: /schemas/display/dsi-controller.yaml# 25 - enum: 26 - mediatek,mt2701-dsi [all …]
|
/freebsd/sys/contrib/device-tree/src/arm64/qcom/ |
H A D | sc7180-trogdor-mrbland.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT) 8 /dts-v1/; 10 #include "sc7180-trogdor.dtsi" 12 /* This board only has 1 USB Type-C port. */ 13 /delete-node/ &usb_c1; 16 avdd_lcd: avdd-lcd-regulator { 17 compatible = "regulator-fixed"; 18 regulator-name = "avdd_lcd"; 21 enable-active-high; 22 pinctrl-names = "default"; [all …]
|
H A D | sc7180-trogdor-wormdingler.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT) 8 /dts-v1/; 10 #include "sc7180-trogdor.dtsi" 11 #include "sc7180-trogdor-detachable.dtsi" 14 avdd_lcd: avdd-lcd-regulator { 15 compatible = "regulator-fixed"; 16 regulator-name = "avdd_lcd"; 19 enable-active-high; 20 pinctrl-names = "default"; 21 pinctrl-0 = <&avdd_lcd_en>; [all …]
|
/freebsd/sys/contrib/device-tree/Bindings/arm/tegra/ |
H A D | nvidia,tegra186-pmc.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/arm/tegra/nvidia,tegra186-pmc.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Thierry Reding <thierry.reding@gmail.com> 11 - Jon Hunter <jonathanh@nvidia.com> 16 - nvidia,tegra186-pmc 17 - nvidia,tegra194-pmc 18 - nvidia,tegra234-pmc 24 reg-names: [all …]
|
H A D | nvidia,tegra186-pmc.txt | 4 - compatible: Should contain one of the following: 5 - "nvidia,tegra186-pmc": for Tegra186 6 - "nvidia,tegra194-pmc": for Tegra194 7 - "nvidia,tegra234-pmc": for Tegra234 8 - reg: Must contain an (offset, length) pair of the register set for each 9 entry in reg-names. 10 - reg-names: Must include the following entries: 11 - "pmc" 12 - "wake" 13 - "aotag" [all …]
|
/freebsd/sys/contrib/device-tree/Bindings/display/tegra/ |
H A D | nvidia,tegra20-host1x.txt | 4 - compatible: "nvidia,tegra<chip>-host1x" 5 - reg: Physical base address and length of the controller's registers. 6 For pre-Tegra186, one entry describing the whole register area. 7 For Tegra186, one entry for each entry in reg-names: 8 "vm" - VM region assigned to Linux 9 "hypervisor" - Hypervisor region (only if Linux acts as hypervisor) 10 - interrupts: The interrupt outputs from the controller. 11 - #address-cells: The number of cells used to represent physical base addresses 13 - #size-cells: The number of cells used to represent the size of an address 15 - ranges: The mapping of the host1x address space to the CPU address space. [all …]
|
/freebsd/sys/contrib/device-tree/src/arm/rockchip/ |
H A D | rk3288.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT) 3 #include <dt-bindings/gpio/gpio.h> 4 #include <dt-bindings/interrupt-controller/irq.h> 5 #include <dt-bindings/interrupt-controller/arm-gic.h> 6 #include <dt-bindings/pinctrl/rockchip.h> 7 #include <dt-bindings/clock/rk3288-cru.h> 8 #include <dt-bindings/power/rk3288-power.h> 9 #include <dt-bindings/thermal/thermal.h> 10 #include <dt-bindings/soc/rockchip,boot-mode.h> 13 #address-cells = <2>; [all …]
|
/freebsd/sys/contrib/device-tree/src/arm64/nvidia/ |
H A D | tegra210.dtsi | 1 // SPDX-License-Identifier: GPL-2.0 2 #include <dt-bindings/clock/tegra210-car.h> 3 #include <dt-bindings/gpio/tegra-gpio.h> 4 #include <dt-bindings/memory/tegra210-mc.h> 5 #include <dt-bindings/pinctrl/pinctrl-tegra.h> 6 #include <dt-bindings/pinctrl/pinctrl-tegra-io-pad.h> 7 #include <dt-bindings/reset/tegra210-car.h> 8 #include <dt-bindings/interrupt-controller/arm-gic.h> 9 #include <dt-bindings/thermal/tegra124-soctherm.h> 10 #include <dt-bindings/soc/tegra-pmc.h> [all …]
|
H A D | tegra132.dtsi | 1 // SPDX-License-Identifier: GPL-2.0 2 #include <dt-bindings/clock/tegra124-car.h> 3 #include <dt-bindings/gpio/tegra-gpio.h> 4 #include <dt-bindings/memory/tegra124-mc.h> 5 #include <dt-bindings/pinctrl/pinctrl-tegra.h> 6 #include <dt-bindings/pinctrl/pinctrl-tegra-xusb.h> 7 #include <dt-bindings/interrupt-controller/arm-gic.h> 8 #include <dt-bindings/thermal/tegra124-soctherm.h> 9 #include <dt-bindings/soc/tegra-pmc.h> 11 #include "tegra132-peripherals-opp.dtsi" [all …]
|
/freebsd/sys/contrib/device-tree/src/arm/nvidia/ |
H A D | tegra124.dtsi | 1 // SPDX-License-Identifier: GPL-2.0 2 #include <dt-bindings/clock/tegra124-car.h> 3 #include <dt-bindings/gpio/tegra-gpio.h> 4 #include <dt-bindings/memory/tegra124-mc.h> 5 #include <dt-binding [all...] |
/freebsd/sys/contrib/device-tree/src/arm64/mediatek/ |
H A D | mt8195.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0 OR MIT) 7 /dts-v1/; 8 #include <dt-bindings/clock/mt8195-clk.h> 9 #include <dt-bindings/gce/mt8195-gce.h> 10 #include <dt-bindings/interrupt-controller/arm-gic.h> 11 #include <dt-bindings/interrupt-controller/irq.h> 12 #include <dt-bindings/memory/mt8195-memory-port.h> 13 #include <dt-bindings/phy/phy.h> 14 #include <dt-bindings/pinctrl/mt8195-pinfunc.h> 15 #include <dt-bindings/power/mt8195-power.h> [all …]
|