| /linux/Documentation/mhi/ |
| H A D | topology.rst | 26 * Initiates power on and shutdown sequence
27 * Initiates suspend and resume power management operations of the device.
58 * Initiates data transfer by calling mhi_queue_transfer.
|
| /linux/Documentation/w1/slaves/ |
| H A D | w1_ds2438.rst | 66 Opening and reading this file initiates the CONVERT_T (temperature conversion)
75 Opening and reading this file initiates the CONVERT_V (voltage conversion)
|
| H A D | w1_ds2423.rst | 20 read sequence of w1_slave file initiates the read of counters and ram
|
| /linux/drivers/char/xilinx_hwicap/ |
| H A D | buffer_icap.c | 156 * this register initiates the transfer. A value of 1 initiates a
157 * readback while writing a value of 0 initiates a configuration.
|
| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-class-mic | 68 "reset" Initiates device reset.
69 "shutdown" Initiates card OS shutdown.
|
| H A D | sysfs-bus-fsi | 6 Initiates a FSI master scan for all connected slave devices
|
| H A D | sysfs-bus-iio-adc-ad7192 | 26 Initiates the system calibration procedure. This is done on a
|
| H A D | debugfs-driver-habanalabs | 107 than 128MB. Writing to this value initiates the DMA transfer.
251 must be 1. Triggering the monitor dump operation initiates dump of
|
| /linux/Documentation/devicetree/bindings/fpga/ |
| H A D | lattice,sysconfig.yaml | 31 Initiates configuration sequence.
|
| /linux/Documentation/filesystems/iomap/ |
| H A D | operations.rst | 174 The ``iomap_readahead`` function initiates readahead to the pagecache.
483 A direct I/O read initiates a read I/O from the storage device to the
498 A direct I/O write initiates a write I/O to the storage device from the
601 A fsdax write initiates a memcpy to the storage device from the caller's
|
| /linux/drivers/firmware/arm_scmi/ |
| H A D | scmi_power_control.c | 153 * Initiates the required SystemPower transition without involving userspace:
205 * Initiates the required SystemPower transition, requesting userspace
|
| /linux/include/soc/tegra/ |
| H A D | ivc.h | 85 * tegra_ivc_reset - initiates a reset of the shared memory state
|
| /linux/include/linux/ |
| H A D | wm97xx.h | 77 #define WM9712_MASK_SYNC 0x00c0 /* rising/falling edge on mask initiates sample */
95 #define WM9705_MASK_SYNC 0x0030 /* rising/falling edge on mask initiates sample */
|
| /linux/Documentation/devicetree/bindings/dma/stm32/ |
| H A D | st,stm32-dma.yaml | 41 0x1: Direct mode: each DMA request immediately initiates a transfer
|
| /linux/Documentation/hwmon/ |
| H A D | ntc_thermistor.rst | 108 (reading this file initiates the reading procedure.)
|
| /linux/tools/perf/pmu-events/arch/x86/goldmont/ |
| H A D | frontend.json | 70 …truction encounters a fault, trap, or microcode assist of any sort that initiates a flow of uops. …
|
| /linux/tools/perf/pmu-events/arch/x86/goldmontplus/ |
| H A D | frontend.json | 70 …truction encounters a fault, trap, or microcode assist of any sort that initiates a flow of uops. …
|
| /linux/include/rdma/ |
| H A D | ib_sa.h | 429 * ib_sa_join_multicast - Initiates a join request to the specified multicast
442 * This call initiates a multicast join request with the SA for the specified
|
| /linux/Documentation/driver-api/ |
| H A D | slimbus.rst | 109 Clock-pause is exited by waking up framer device (if controller driver initiates
|
| /linux/Documentation/driver-api/soundwire/ |
| H A D | stream.rst | 359 (4) Once all the values are programmed, Bus initiates switch to alternate
393 (3) Once all the values are programmed, Bus initiates switch to alternate
421 (3) Once all the values are programmed, Bus initiates switch to alternate
|
| /linux/arch/powerpc/platforms/powernv/ |
| H A D | ocxl.c | 495 * ATSD LAUNCH register: write access initiates a shoot down to in pnv_ocxl_map_lpar()
552 /* Write access initiates a shoot down to initiate the in pnv_ocxl_tlb_invalidate()
|
| /linux/arch/mips/kernel/ |
| H A D | sync-r4k.c | 106 * The freshly booted CPU initiates this via an async SMP function call.
|
| /linux/Documentation/networking/ |
| H A D | mptcp.rst | 59 address announcements. Typically, it is the client side that initiates subflows,
|
| /linux/drivers/scsi/bnx2fc/ |
| H A D | bnx2fc_hwi.c | 54 * bnx2fc_send_fw_fcoe_init_msg - initiates initial handshake with FCoE f/w
58 * Send down FCoE firmware init KWQEs which initiates the initial handshake
166 * bnx2fc_send_session_ofld_req - initiates FCoE Session offload process
351 * bnx2fc_send_session_enable_req - initiates FCoE Session enablement
421 * bnx2fc_send_session_disable_req - initiates FCoE Session disable
486 * bnx2fc_send_session_destroy_req - initiates FCoE Session destroy
|
| /linux/drivers/s390/char/ |
| H A D | diag_ftp.c | 98 * 1. This function only initiates a transfer, so the caller must wait
|