| /linux/drivers/media/rc/img-ir/ |
| H A D | Kconfig | 8 Say Y or M here if you want to use the ImgTec infrared decoder
36 NEC protocols in the ImgTec infrared decoder block.
43 infrared decoder block.
50 infrared decoder block.
57 infrared decoder block.
64 Aiwa, Chinon remotes) in the ImgTec infrared decoder block.
71 infrared decoder block.
78 infrared decoder block.
|
| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-light-si1133 | 5 Unit-less infrared intensity. The intensity is measured from 1
7 infrared.
13 Unit-less infrared intensity. The intensity is measured from 4
15 infrared.
|
| H A D | sysfs-bus-iio-light-isl29018 | 7 infrared suppression:
|
| /linux/Documentation/driver-api/media/ |
| H A D | rc-core.rst | 23 infrared-based remote controllers, there's no key release event. Instead,
26 However, most of the remote controllers use infrared (IR) to transmit signals.
27 As there are several protocols used to modulate infrared signals, one
29 system to support the infrared protocol used by the emitter.
31 The infrared transmission is done by blinking a infrared emitter using a
|
| /linux/Documentation/userspace-api/media/v4l/ |
| H A D | pixfmt-inzi.rst | 10 Infrared 10-bit linked with Depth 16-bit images
17 Infrared image followed by Depth data. The pixel definition is 32-bpp,
18 with the Depth and Infrared Data split into separate continuous planes of
23 The first plane - Infrared data - is stored according to
57 * - :cspan:`5` Infrared Data
|
| /linux/drivers/media/rc/ |
| H A D | mceusb.c | 3 * Driver for USB Windows Media Center Ed. eHome Infrared Transceivers
35 #define DRIVER_DESC "Windows Media Center Ed. eHome Infrared Transceiver " \
285 /* Philips Infrared Transceiver - Sahara branded */
287 /* Philips Infrared Transceiver - HP branded */
292 /* Philips Infrared Transceiver - Omaura */
294 /* Philips Infrared Transceiver - Spinel plus */
296 /* Philips eHome Infrared Transceiver */
311 /* SMK eHome Infrared Transceiver (Sony VAIO) */
317 /* SMK eHome Infrared Transceiver */
322 /* SMK RXX6000 Infrared Receiver */
[all …]
|
| H A D | winbond-cir.c | 62 #define WBCIR_REG_ECEIR_CCTL 0x01 /* Infrared Counter Control */
63 #define WBCIR_REG_ECEIR_CNT_LO 0x02 /* Infrared Counter LSB */
64 #define WBCIR_REG_ECEIR_CNT_HI 0x03 /* Infrared Counter MSB */
65 #define WBCIR_REG_ECEIR_IREM 0x04 /* Infrared Emitter Status */
91 #define WBCIR_REG_SP3_IRCR1 0x02 /* Infrared Control 1 */
93 #define WBCIR_REG_SP3_IRCR2 0x04 /* Infrared Control 2 */
95 #define WBCIR_REG_SP3_IRCR3 0x00 /* Infrared Control 3 */
101 #define WBCIR_REG_SP3_IRCFG1 0x04 /* Infrared Config 1 */
102 #define WBCIR_REG_SP3_IRCFG4 0x07 /* Infrared Config 4 */
|
| H A D | ir_toy.c | 4 * Infrared Toy and IR Droid RC core driver
483 rc->device_name = "Infrared Toy"; in irtoy_probe()
560 MODULE_DESCRIPTION("Infrared Toy and IR Droid driver");
|
| /linux/Documentation/devicetree/bindings/media/ |
| H A D | st-rc.txt | 10 - rx-mode: can be "infrared" or "uhf". This property specifies the L1
13 - tx-mode: should be "infrared". This property specifies the L1
28 rx-mode = "infrared";
|
| H A D | img-ir-rev1.txt | 1 * ImgTec Infrared (IR) decoder version 1
3 This binding is for Imagination Technologies' Infrared decoder block,
|
| H A D | mediatek,mt7622-cir.yaml | 7 title: MediaTek Consumer Infrared Receiver on-SoC Controller
|
| H A D | allwinner,sun4i-a10-ir.yaml | 7 title: Allwinner A10 Infrared Controller
|
| /linux/Documentation/devicetree/bindings/iio/temperature/ |
| H A D | melexis,mlx90614.yaml | 14 http://melexis.com/Infrared-Thermometer-Sensors/Infrared-Thermometer-Sensors/MLX90614-615.aspx
|
| /linux/Documentation/devicetree/bindings/iio/light/ |
| H A D | isl29018.yaml | 8 Intersil 29018/29023/29035 Ambient Light, Infrared Light, and Proximity Sensor
14 Ambient and infrared light sensing with proximity detection over an i2c
|
| /linux/include/dt-bindings/pinctrl/ |
| H A D | k210-fpioa.h | 166 #define K210_PCF_UART1_SIR_IN 152 /* UART1 Serial Infrared Input */
171 #define K210_PCF_UART1_SIR_OUT 157 /* UART1 Serial Infrared Output */
180 #define K210_PCF_UART2_SIR_IN 166 /* UART2 Serial Infrared Input */
185 #define K210_PCF_UART2_SIR_OUT 171 /* UART2 Serial Infrared Output */
194 #define K210_PCF_UART3_SIR_IN 180 /* UART3 Serial Infrared Input */
199 #define K210_PCF_UART3_SIR_OUT 185 /* UART3 Serial Infrared Output */
|
| /linux/Documentation/devicetree/bindings/iio/proximity/ |
| H A D | vishay,vcnl3020.yaml | 7 title: Integrated Proximity Sensor With Infrared Emitter
14 that the infrared emitter is included in the package. It has 16-bit
|
| /linux/drivers/staging/media/av7110/ |
| H A D | av7110.h | 84 /* infrared remote control */
85 struct infrared { struct
249 struct infrared ir;
|
| /linux/drivers/power/reset/ |
| H A D | gemini-poweroff.c | 51 * We do not yet have a driver for the infrared in gemini_powerbutton_interrupt()
55 dev_info(gpw->dev, "infrared poweroff - ignored\n"); in gemini_powerbutton_interrupt()
|
| /linux/drivers/media/pci/cx23885/ |
| H A D | cx23888-ir.h | 5 * CX23888 Integrated Consumer Infrared Controller
|
| H A D | cx23885-input.h | 5 * Infrared remote control input device
|
| H A D | cx23885-ir.h | 5 * Infrared device support routines - non-input, non-vl42_subdev routines
|
| H A D | cx23885-ir.c | 5 * Infrared device support routines - non-input, non-vl42_subdev routines
|
| /linux/Documentation/userspace-api/media/rc/ |
| H A D | rc-intro.rst | 9 Currently, most analog and digital devices have a Infrared input for
|
| /linux/Documentation/devicetree/bindings/input/touchscreen/ |
| H A D | neonode,zforce.yaml | 7 title: Neonode infrared touchscreen controller
|
| /linux/drivers/media/usb/em28xx/ |
| H A D | em28xx-input.c | 210 /* Infrared toggle (Reg 0x45[7]) */ in default_polling_getkey()
213 /* Infrared read count (Reg 0x45[6:0] */ in default_polling_getkey()
253 /* Infrared toggle (Reg 0x51[7]) */ in em2874_polling_getkey()
256 /* Infrared read count (Reg 0x51[6:0] */ in em2874_polling_getkey()
|