/linux/lib/ |
H A D | iomap_copy.c | 17 * performed afterwards. 40 * performed afterwards. 61 * performed afterwards.
|
/linux/Documentation/ABI/testing/ |
H A D | debugfs-scmi-raw | 26 Any additional delayed response received afterwards can be read 62 Any additional delayed response received afterwards can be read 140 Any additional delayed response received afterwards can be read 195 Any additional delayed response received afterwards can be read
|
H A D | debugfs-ec | 19 what you are doing! Rebooting afterwards also is a good idea.
|
H A D | sysfs-firmware-memmap | 11 map is modified afterwards by the kernel itself, either because
|
/linux/mm/ |
H A D | pgtable-generic.c | 345 * struct page). pte_unmap_unlock(pte, ptl) to unlock and unmap afterwards. 360 * afterwards. 372 * afterwards. 377 * page table may happen after the corresponding spinlock is held afterwards.
|
/linux/include/linux/ |
H A D | wait.h | 1033 * and schedule() and reacquired afterwards. 1046 * afterwards. 1063 * and reacquired afterwards. 1073 * dropped before going to sleep and is reacquired afterwards. 1097 * schedule() and reacquired afterwards. 1110 * afterwards. 1131 * and reacquired afterwards. 1141 * dropped before going to sleep and is reacquired afterwards. 1169 * and reacquired afterwards. 1180 * dropped before going to sleep and is reacquired afterwards.
|
/linux/Documentation/networking/ |
H A D | operstates.rst | 147 IF_OPER_UP transition afterwards. 158 driver. Afterwards, the userspace application can set IFLA_OPERSTATE
|
/linux/rust/pin-init/src/ |
H A D | alloc.rs | 29 /// If `T: !Unpin` it will not be able to move afterwards. 37 /// If `T: !Unpin` it will not be able to move afterwards.
|
/linux/arch/mips/lib/ |
H A D | iomap_copy.c | 14 * performed afterwards.
|
/linux/Documentation/power/ |
H A D | userland-swsusp.rst | 142 mounted afterwards. 186 device. Afterwards it will be treated as a regular userland process,
|
/linux/Documentation/devicetree/bindings/iio/proximity/ |
H A D | parallax-ping.yaml | 32 should initiate the measurement cycle. Afterwards the GPIO is switched
|
/linux/Documentation/devicetree/bindings/bus/ |
H A D | brcm,bus-axi.txt | 10 memory ranges they are using and they get registered afterwards.
|
/linux/Documentation/driver-api/fpga/ |
H A D | intro.rst | 37 programming begins and re-enabled afterwards. An FPGA bridge may be
|
/linux/Documentation/translations/ |
H A D | index.rst | 45 applied to the English documents first. Afterwards and when possible, the
|
/linux/Documentation/hwmon/ |
H A D | spd5118.rst | 54 Alarm attributes are sticky until read and will be cleared afterwards
|
/linux/sound/firewire/dice/ |
H A D | dice-interface.h | 235 * registers of the first stream follow immediately afterwards; the registers 297 * registers of the first stream follow immediately afterwards; the registers
|
/linux/drivers/gpu/drm/i915/gt/uc/abi/ |
H A D | guc_communication_mmio_abi.h | 28 * phase to setup the `CTB based communication`_ that will be used afterwards.
|
/linux/drivers/gpu/drm/xe/abi/ |
H A D | guc_communication_mmio_abi.h | 28 * phase to setup the `CTB based communication`_ that will be used afterwards.
|
/linux/Documentation/arch/s390/ |
H A D | zfcpdump.rst | 11 memory afterwards. Currently 32 MB are saved.
|
/linux/arch/s390/kernel/ |
H A D | reipl.S | 18 # and call passed function afterwards
|
/linux/arch/m68k/amiga/ |
H A D | chipram.c | 70 * those drivers must not free that Chip RAM afterwards.
|
/linux/Documentation/driver-api/media/drivers/ |
H A D | dvb-usb.rst | 18 dibusb-driver would be a complete mess afterwards. So I decided to do it in a 246 load' afterwards.
|
/linux/drivers/video/ |
H A D | aperture.c | 130 * registers, framebuffer memory, ROM, etc afterwards. 311 * should acquire ownership of those memory areas and afterwards call
|
/linux/Documentation/virt/kvm/s390/ |
H A D | s390-pv-boot.rst | 22 hashes, to ensure integrity. Afterwards KVM can run the PVM via the
|
/linux/Documentation/w1/slaves/ |
H A D | w1_ds2438.rst | 67 command of the chip, afterwards the temperature is read from the device
|