Searched full:adaptation (Results 1 – 25 of 79) sorted by relevance
1234
2 Samsung USB 2.0 PHY adaptation layer13 the PHY powering up process had to be altered. This adaptation layer is21 This is the main file of the adaptation layer. This file contains
19 tristate "TI CAL (Camera Adaptation Layer) driver"28 Support for the TI CAL (Camera Adaptation Layer) block
33 * enum hdcp_wired_protocol - HDCP adaptation used on the port34 * @HDCP_PROTOCOL_INVALID: Invalid HDCP adaptation protocol35 * @HDCP_PROTOCOL_HDMI: HDMI adaptation of HDCP used on the port36 * @HDCP_PROTOCOL_DP: DP adaptation of HDCP used on the port83 * @protocol: HDCP adaptation as per ME/GSC FW
7 title: Texas Instruments DRA72x CAMERA ADAPTATION LAYER (CAL)13 The Camera Adaptation Layer (CAL) is a key component for image capture
104 // adaptation flags114 // adaptation extension flags
37 /* set if 56K adaptation */
77 * @phy_layer: Adaptation layer to be removed.
24 Translation from C++ and adaptation for use in ALSA-Driver
26 Translation from C++ and adaptation for use in ALSA-Driver
30 L2CAP (Logical Link Control and Adaptation Protocol)
502 * When a peer sends a Adaptation Layer Indication parameter , SCTP504 * that of the peers requested adaptation layer.771 * 7.1.11 Set Adaptation Layer Indicator (SCTP_ADAPTATION_LAYER)773 * Requests that the local endpoint set the specified Adaptation Layer
2113 /* perform rx adaptation */ in xgbe_phy_rx_adaptation()2198 "Enabling RX adaptation\n"); in xgbe_phy_perform_ratechange()2202 * during adaptation phase in xgbe_phy_perform_ratechange()2239 /* Rx-Adaptation is not supported on older platforms(< 0x30H) */ in enable_rx_adap()2244 /* Re-driver models 4223 && 4227 do not support Rx-Adaptation */ in enable_rx_adap()2250 /* 10G KR mode with AN does not support Rx-Adaptation */ in enable_rx_adap()2900 /* if the link is available and adaptation is done, in xgbe_phy_link_status()2905 /* If either link is not available or adaptation is not done, in xgbe_phy_link_status()2906 * retrigger the adaptation logic. (if the mode is not set, in xgbe_phy_link_status()2916 /* check again for the link and adaptation status */ in xgbe_phy_link_status()
9 * "Adaptation header" to allow i915 display to also build for xe driver.
206 * adaptation to changes in the input data statistics. (Take for209 * fast adaptation but have of course the overhead of transmitting
9 * Adaptation to new UART layer is:
100 /* ATM adaptation layer id */115 enum fore200e_aal aal : 4, /* adaptation layer */283 enum fore200e_aal aal : 8, /* adaptation layer */