| /linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imxrt1050.dtsi | 78 interrupts = <0>, <1>, <2>, <3>, <4>, <5>, <6>, <7>, <8>, 85 usdhc1: mmc@402c0000 { 95 no-1-8-v; 122 gpio3: gpio@401c0000 { 142 gpio5: gpio@400c0000 {
|
| /linux/arch/arm64/boot/dts/renesas/ |
| H A D | r8a77970-v3msk.dts | 79 regulator-name = "VCC_D1.8V"; 158 adi,input-depth = <8>; 201 bus-width = <8>; 259 cert_header_sa3@c0000 { 271 bl31@1c0000 { 286 kernel@7c0000 {
|
| H A D | r8a77980-v3hsk.dts | 150 adi,input-depth = <8>; 240 cert_header_sa3@c0000 { 252 bl31@1c0000 { 267 kernel@7c0000 {
|
| H A D | condor-common.dtsi | 29 regulator-name = "D1.8V"; 206 adi,input-depth = <8>; 233 pagesize = <8>; 416 bus-width = <8>; 504 cert_header_sa3@c0000 { 516 bl31@1c0000 { 531 kernel@7c0000 {
|
| H A D | r8a77970-eagle.dts | 182 adi,input-depth = <8>; 367 cert_header_sa3@c0000 { 379 bl31@1c0000 { 394 kernel@7c0000 {
|
| H A D | ulcb.dtsi | 280 pagesize = <8>; 420 bl31@1c0000 { 435 kernel@7c0000 { 477 /* used for on-board 8bit eMMC */ 484 bus-width = <8>;
|
| /linux/arch/arm64/boot/dts/arm/ |
| H A D | juno-scmi.dtsi | 3 power-domains = <&scmi_devpd 8>; 7 power-domains = <&scmi_devpd 8>; 11 power-domains = <&scmi_devpd 8>; 15 power-domains = <&scmi_devpd 8>; 19 power-domains = <&scmi_devpd 8>; 23 power-domains = <&scmi_devpd 8>; 26 funnel@220c0000 { 27 power-domains = <&scmi_devpd 8>; 30 funnel@230c0000 { 31 power-domains = <&scmi_devpd 8>; [all …]
|
| /linux/arch/arm/boot/dts/microchip/ |
| H A D | at91-qil_a9260.dts | 134 nand-bus-width = <8>; 169 kernel@c0000 { 174 rootfs@4c0000 {
|
| H A D | ge863-pro3.dtsi | 49 nand-bus-width = <8>; 64 root@7c0000 {
|
| H A D | at91-som60.dtsi | 107 bus-width = <8>; 174 nand-bus-width = <8>; 176 nand-ecc-strength = <8>; 201 ubootenv@c0000 {
|
| H A D | at91-cosino.dtsi | 65 nand-bus-width = <8>; 87 ubootenv@c0000 {
|
| H A D | at91-wb50n.dtsi | 96 rng-gpios = <&pioD 8 GPIO_ACTIVE_LOW>; 124 nand-bus-width = <8>; 126 nand-ecc-strength = <8>; 151 ubootenv@c0000 {
|
| H A D | sama5d3xcm.dtsi | 67 atmel,smc-nwe-setup-ns = <8>; 105 bootloaderenv@c0000 {
|
| /linux/arch/arm64/boot/dts/exynos/ |
| H A D | exynos7870.dtsi | 196 interrupts = <GIC_PPI 9 (GIC_CPU_MASK_SIMPLE(8) | 296 usbdrd_phy: phy@135c0000 { 540 hsi2c3: i2c@138c0000 { 636 pinctrl_nfc: pinctrl@139c0000 { 678 pinctrl_dispaud: pinctrl@148c0000 { 699 interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(8) | IRQ_TYPE_LEVEL_LOW)>, 700 <GIC_PPI 14 (GIC_CPU_MASK_SIMPLE(8) | IRQ_TYPE_LEVEL_LOW)>, 701 <GIC_PPI 11 (GIC_CPU_MASK_SIMPLE(8) | IRQ_TYPE_LEVEL_LOW)>, 702 <GIC_PPI 10 (GIC_CPU_MASK_SIMPLE(8) | IRQ_TYPE_LEVEL_LOW)>;
|
| /linux/Documentation/devicetree/bindings/serial/ |
| H A D | xlnx,opb-uartlite.yaml | 41 enum: [5, 6, 7, 8] 79 serial@800c0000 { 85 xlnx,data-bits = <8>;
|
| /linux/arch/arm64/boot/dts/st/ |
| H A D | stm32mp25xxai-pinctrl.dtsi | 58 gpioi: gpio@442c0000 { 72 ngpios = <8>; 73 gpio-ranges = <&pinctrl 0 160 8>;
|
| /linux/arch/arm64/boot/dts/nvidia/ |
| H A D | tegra186-p3310.dtsi | 17 i2c5 = "/i2c@31c0000"; 131 i2c@31c0000 { 156 bus-width = <8>; 181 address-width = <8>; 182 pagesize = <8>; 295 in-ldo7-8-supply = <&avdd_dsi_csi>;
|
| /linux/Documentation/devicetree/bindings/spi/ |
| H A D | spi-nxp-fspi.yaml | 77 spi@20c0000 { 93 spi-rx-bus-width = <8>; 94 spi-tx-bus-width = <8>;
|
| /linux/Documentation/devicetree/bindings/net/ |
| H A D | hisilicon-hip04-net.txt | 50 ppe: ppe@28c0000 { 77 port-handle = <&ppe 8 2 8>;
|
| /linux/arch/arm/boot/dts/qcom/ |
| H A D | qcom-ipq4018-jalapeno.dts | 9 model = "8devices Jalapeno"; 10 compatible = "8dev,jalapeno", "qcom,ipq4018"; 101 partition@c0000 { 182 qcom,calibration-variant = "8devices-Jalapeno"; 188 qcom,calibration-variant = "8devices-Jalapeno";
|
| /linux/Documentation/devicetree/bindings/soc/qcom/ |
| H A D | qcom,sa8255p-geni-se-qup.yaml | 15 like UART, SPI, I2C, I3C, etc. A single QUP module can provide up to 8 Serial 91 geniqup@9c0000 {
|
| H A D | qcom,geni-se.yaml | 15 like UART, SPI, I2C, I3C, etc. A single QUP module can provide upto 8 Serial 133 geniqup@8c0000 {
|
| /linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | qcom,sc8280xp-lpass-lpi-pinctrl.yaml | 59 pattern: "^gpio([0-9]|1[0-8])$" 87 pinctrl@33c0000 {
|
| /linux/Documentation/networking/ |
| H A D | arcnet-hardware.rst | 279 - the IRQ: on 8-bit cards, it might be 2 (9), 3, 4, 5, or 7. 300 IRQ 8 Realtime Clock Interrupt (Not on bus) 336 C0000 \ One of these is your VGA BIOS - usually C0000. 348 software). Since it's only 8 bits, you can only have 254 ARCnet cards 415 SMC PC100 8 416 SMC PC110 8 417 SMC PC120 8 418 SMC PC130 8 419 SMC PC270E 8 424 SMC PC710 8 [all …]
|
| /linux/arch/arm/boot/dts/marvell/ |
| H A D | kirkwood-b3.dts | 73 partition@c0000 { 156 gpios = <&gpio1 8 GPIO_ACTIVE_HIGH>; 163 ethphy0: ethernet-phy@8 { 165 reg = <8>;
|