Home
last modified time | relevance | path

Searched +full:1 +full:a100000 (Results 1 – 10 of 10) sorted by relevance

/linux/Documentation/devicetree/bindings/net/
H A Dcpsw.txt71 mac: ethernet@4a100000 {
92 phys = <&phy_gmii_sel 1 0>;
94 cpsw_emac1: slave@1 {
95 phy_id = <&davinci_mdio>, <1>;
104 mac: ethernet@4a100000 {
123 phys = <&phy_gmii_sel 1 0>;
125 cpsw_emac1: slave@1 {
126 phy_id = <&davinci_mdio>, <1>;
/linux/Documentation/devicetree/bindings/bus/
H A Dqcom,ebi2.yaml15 lines (up to 9 address lines so can only address 1KiB external memory space),
92 const: 1
110 maxItems: 1
120 actually 1, so a value of 0 will still yield 1 recovery cycle.
127 The extra cycles inserted after every write minimum 1. The
129 asserted. With a hold of 1 (value = 0), the CS stays active
130 for 1 extra cycle, etc.
170 requirements with ADV assertion, when set to 1.
171 enum: [ 0, 1 ]
201 external-bus@1a100000 {
[all …]
/linux/arch/arm/boot/dts/qcom/
H A Dqcom-msm8660.dtsi10 #address-cells = <1>;
11 #size-cells = <1>;
17 #address-cells = <1>;
28 cpu@1 {
32 reg = <1>;
77 #address-cells = <1>;
78 #size-cells = <1>;
93 <GIC_PPI 1 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_EDGE_RISING)>,
115 #clock-cells = <1>;
116 #reset-cells = <1>;
[all …]
/linux/arch/arm64/boot/dts/qcom/
H A Dipq5332.dtsi31 #address-cells = <1>;
44 CPU1: cpu@1 {
127 bootloader@4a100000 {
153 #address-cells = <1>;
154 #size-cells = <1>;
173 #address-cells = <1>;
174 #size-cells = <1>;
176 cpu_speed_bin: cpu-speed-bin@1d {
210 #clock-cells = <1>;
211 #reset-cells = <1>;
[all …]
H A Dsm8250-sony-xperia-edo.dtsi18 qcom,msm-id = <356 0x20001>; /* SM8250 v2.1 */
74 gpios = <&pm8150b_gpios 1 GPIO_ACTIVE_LOW>;
83 gpios = <&pm8150_gpios 1 GPIO_ACTIVE_LOW>;
109 adsp_mem: memory@8a100000 {
270 regulators-1 {
489 #sound-dai-cells = <1>;
504 #sound-dai-cells = <1>;
622 pinctrl-1 = <&sdc2_sleep_state &sdc2_card_det_n>;
H A Dipq9574.dtsi34 #address-cells = <1>;
50 CPU1: cpu@1 {
195 bootloader@4a100000 {
220 #address-cells = <1>;
221 #size-cells = <1>;
239 #address-cells = <1>;
249 #address-cells = <1>;
250 #size-cells = <1>;
262 #dma-cells = <1>;
263 qcom,ee = <1>;
[all …]
H A Dipq6018.dtsi34 #address-cells = <1>;
50 CPU1: cpu@1 {
197 bootloader@4a100000 {
310 #address-cells = <1>;
322 #address-cells = <1>;
323 #size-cells = <1>;
327 bits = <7 1>;
345 #thermal-sensor-cells = <1>;
354 #dma-cells = <1>;
355 qcom,ee = <1>;
[all …]
H A Dsc8280xp.dtsi148 clocks = <&cpufreq_hw 1>;
155 qcom,freq-domain = <&cpufreq_hw 1>;
171 clocks = <&cpufreq_hw 1>;
178 qcom,freq-domain = <&cpufreq_hw 1>;
194 clocks = <&cpufreq_hw 1>;
201 qcom,freq-domain = <&cpufreq_hw 1>;
217 clocks = <&cpufreq_hw 1>;
224 qcom,freq-domain = <&cpufreq_hw 1>;
285 BIG_CPU_SLEEP_0: cpu-sleep-1-0 {
698 pil_nsp0_mem: cdsp0-region@8a100000 {
[all …]
H A Dsm8250.dtsi206 clocks = <&cpufreq_hw 1>;
213 qcom,freq-domain = <&cpufreq_hw 1>;
231 clocks = <&cpufreq_hw 1>;
238 qcom,freq-domain = <&cpufreq_hw 1>;
256 clocks = <&cpufreq_hw 1>;
263 qcom,freq-domain = <&cpufreq_hw 1>;
351 BIG_CPU_SLEEP_0: cpu-sleep-1-0 {
673 #reset-cells = <1>;
846 adsp_mem: memory@8a100000 {
882 #qcom,smem-state-cells = <1>;
[all …]
/linux/arch/arm/boot/dts/ti/omap/
H A Ddm816x.dtsi11 #address-cells = <1>;
12 #size-cells = <1>;
26 #address-cells = <1>;
63 #address-cells = <1>;
64 #size-cells = <1>;
70 #address-cells = <1>;
71 #size-cells = <1>;
75 #address-cells = <1>;
86 #address-cells = <1>;
87 #size-cells = <1>;
[all …]